共找到 1462 条与 电容器 相关的标准,共 98 页
Fixed capacitors for use in electronic equipment -- Part 22: Sectional specification -- Fixed surface mount multilayer capacitors of ceramic dielectric, Class 2
Coupling capacitors and capacitor dividers. AC or DC single-phase coupling capacitor connected between line and ground for power line carrier-frequency (PLC) application
Clause 1 of IEC 60358-1:2012 is replaced by the following: This part of IEC 60358 applies to AC or DC single-phase coupling capacitor@ with rated voltage higher than 1 000 V@ connected line to ground with the low voltage terminal either permanently earthed or connected to a tuning device for harmonic-filters applications. NOTE Diagrams of coupling capacitors to which this standard applies are given in Figures AA.1 and AA.2.
Coupling capacitors and capacitor dividers - Part 3: AC or DC coupling capacitors for harmonic-filters applications
Fixed capacitors for use in electronic equipment. Sectional specification: Fixed capacitors for electromagnetic interference suppression and connection to the supply mains
AC motor capacitors - Part 1: General - Performance, testing and rating - Safety requirements - Guidance for installation and operation
AC motor capacitors - Part 2: Motor start capacitors
AC motor capacitors - Part 1: General - Performance, testing and rating - Safety requirements - Guidance for installation and operation
This part of IEC 60384 applies to capacitors and resistor-capacitor combinations which will be connected to an a.c. mains or other supply with nominal voltage not exceeding 1 000 V a.c.(r.m.s.) or 1 000 V d.c. and with a nominal frequency not exceeding 100 Hz.
Fixed capacitors for use in electronic equipment. Part 14: Sectional specification.Fixed capacitors for electromagnetic interference suppression and connection to the supply mains
Railway applications - Rolling stock equipment - Capacitors for power electronics - Part 3: Electric double-layer capacitors (IEC 61881-3:2012); German version EN 61881-3:2012
CA45 type chip solid electrolyte tantalum fixed capacitor
CA551 Conductive Polymer Electrolyte Chip Tantalum Capacitor
Preferred diameters of wire terminations of capacitors and resistors (IEC 60301:2012); German version EN 60301:2012
Coupling capacitors and capacitor dividers - Part 1: General rules (IEC 60358-1:2012); German version EN 60358-1:2012
This document has been declared ""Stabilized"" and will no longer be subjected to periodic reviews for currency. Users are responsible for verifying references and continued suitability or technical requirements. New technology may exist. This recommended practice describes the requirements of a special purpose 10 °F feed through capacitor to be used in series with the power line to an electrical or electronic device during EMI tests.
Capacitor, 10 Microfarad for EMI Measurements
Coupling capacitors and capacitor dividers. General rules
Test procedure for high frequency characterization of low inductance multilayer ceramic chip capacitors
Application Guide for Multilayer Ceramic Capacitors - Electrical
Method for the determination of the space required by capacitors and resistors with unidirectional terminations (IEC 60717:2012); German version EN 60717:2012
Railway applications. Rolling stock equipment. Capacitors for power electronics. Aluminium electrolytic capacitors with non solid electrolyte
Fixed capacitors for use in electronic equipment - Part 22: sectional specification - Fixed surface mount multilayer capacitors of ceramic dielectric, Class 2
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号