L11 电容器 标准查询与下载

JIS C 5101-22:2006 电子设备用固定电容器.第22部分:分规范:2级陶瓷介质的表面安装固定多层电容器

この規格は，JIS C 5101-1を品目別通則とする品種別通則で，電子機器用の外装なし固定積層磁器コンデンサ種類2の表面実装用コンデンサ(以下,コンデンサという。)について規定する。

Fixed capacitors for use in electronic equipment -- Part 22: Sectional specification: Fixed surface mount multilayer capacitors of ceramic dielectric, Class 2

JEITA RC2002-2006 电气设备和电子设备用表面安装电容器的低ESL测量方法

Low ESL measuring method on surface mount capacitors for use in electrical and electronic equipment

BS EN 60384-14:2005 电子设备用固定电容器.第14部分:分规范.电磁干扰抑制和供电干线连接用固定电容器

This part of IEC 60384 applies to capacitors and resistor-capacitor combinations which will be connected to an a.c. mains or other supply with nominal voltage not exceeding 1 000 V a.c. (r.m.s.) or 1 000 V d.c. and with a nominal frequency not exceeding 100 Hz.

Fixed capacitors for use in electronic equipment - Part 14: Sectional specification - Fixed capacitors for electromagnetic interference suppression and connection to the supply mains

BS EN 60384-17:2005 电子设备用固定式电容器.第17部分:分规范:用金属处理的聚丙烯膜交流电介质和脉冲固定电容器

This part of IEC 60384 applies to fixed capacitors with metallized electrodes and polypropylene dielectric for use in electronic equipment. NOTE Capacitors which have mixed foil and metallized electrodes are also within the scope of this standard. These capacitors may have "self-healing" properties depending on conditions of use. Capacitors covered by this specification are mainly intended for use with alternating voltage and/or for pulse applications. The maximum reactive power applicable is 10 000 var and the maximum peak voltage is 3 000 V. Capacitors for reactive power exceeding 500 var and to which a maximum peak voltage of 2 500 V at 50 Hz can be applied are not covered by this standard, except when they are the highest part of a range of reactive power mainly situated below 500 var at 50 Hz. This standard is not intended to cover capacitance values higher than 20 μF. Two performance grades of capacitors are covered, Grade 1 for long-life application and Grade 2 for general application. Capacitors for electromagnetic interference suppression are not included, but are covered by IEC 60384-14. Capacitors for electrical shock hazard protection (covered by IEC 60065) and fluorescent lamp and motor capacitors (covered by IEC technical committee 33, and IEC technical committee 34) are also excluded.

Fixed capacitors for use in electronic equipment - Part 17: Sectional specification: Fixed metallized polypropylene film dielectric a.c. and pulse capacitors

BS EN 60384-16-1:2005 电子设备用固定电容器.第16-1部分:空白详细规范:金属化聚丙烯薄膜电介质直流固定电容器.评定等级E和EZ

Fixed capacitors for use in electronic equipment - Part 16-1: Blank detail specification: Fixed metallized polypropylene film dielectric d.c. capacitors - Assessment levels E and EZ

BS EN 60384-2:2005 电子设备用固定电容器.第2部分:分规范:金属化聚对苯二甲酸乙二醇酯薄膜电介质直流固定电容器

This part of IEC 60384 applies to fixed capacitors for direct current, with metallized electrodes and polyethylene-terephthalate dielectric for use in electronic equipment. These capacitors may have "self-healing properties" depending on conditions of use. They are primarily intended for applications where the a.c. component is small with respect to the rated voltage. Two performance grades of capacitors are covered, Grade 1 for long-life application and Grade 2 for general application. Capacitors for electromagnetic interference suppression and surface mount fixed metallized polyethylene-terephthalate film dielectric d.c. capacitors are not included, but are covered by IEC 60384-14 and IEC 60384-19 respectively.

Fixed capacitors for use in electronic equipment - Part 2: Sectional specification: Fixed metallized polyethylene-terephthalate film dielectric d.c. capacitors

BS EN 60384-16:2005 电子设备用固定电容器.第16部分:分规范:金属化聚丙烯薄膜电介质直流固定电容器

This part of IEC 60384 applies to fixed capacitors with metallized electrodes and polypropylene dielectric for use in electronic equipment. These capacitors may have "self-healing properties" depending on conditions of use. They are mainly intended for use with direct voltage. Capacitors for alternating voltage and pulse applications are not included, but are covered by IEC 60384-17. The maximum power to be applied is 500 var at 50 Hz and the maximum peak voltage is 2 500 V. Two performance grades of capacitors are covered, Grade 1 for long-life application and Grade 2 for general application. Capacitors for electromagnetic interference suppression are not included, but are covered by IEC 60384-14. Capacitors for electrical shock hazard protection (covered by IEC 60065) and fluorescent lamp and motor capacitors (covered by IEC technical committee 33, and IEC technical committee 34).

Fixed capacitors for use in electronic equipment - Part 16: Sectional specification: Fixed metallized polypropylene film dielectric d.c. capacitors

BS EN 60384-17-1:2005 电子设备用固定式电容器.第17-1部分:空白详细规范.用金属处理的聚丙烯膜交流电介质和脉冲固定电容器.评估等级E和EZ

Fixed capacitors for use in electronic equipment - Part 17-1: Blank detail specification: Fixed metallized polypropylene film dielectric a.c. and pulse capacitors - Assessment levels E and EZ

NF C93-112-23:2006 电子设备用固定电容器.第23部分:分规范.表面安装的金属化聚乙烯苯二甲酸盐膜介质直流固定电容器

Fixed capacitors for use in electronic equipment - Part 23 : sectional specification - Fixed surface mount metallized polyethylene naphthalate film dielectric DC capacitors.

NF C93-112-23-1*NF EN 60384-23-1:2006 电子设备用固定电容器.第23-1部分:空白详细规范.表面安装的金属化聚乙烯苯二甲酸盐膜介质直流固定电容器.评定水平EZ

Fixed capacitors for use in electronic equipment - Part 23-1 : blank detail specification - Fixed surface mount metallized polyethylene naphthalate film dielectric DC capacitors - Assessment level EZ.

NF C93-112-14-3:2006 电子设备用固定电容器.第14-3部分:空白详细规范:抑制电磁干扰和电源网络连接用固定电容器.评定等级DZ

Fixed capacitors for use in electronic equipment - Part 14-3 : blank detail specification - Fixed capacitors for electromagnetic interference suppression and connection to the supply mains - Assessment level DZ.

BS EN 60384-8:2005 电子设备用固定电容器.第8部分:分规范:1级陶瓷介电固定电容器

This part of IEC 60384 is applicable to fixed capacitors of ceramic dielectric with a defined temperature coefficient (dielectric Class 1), intended for use in electronic equipment, including leadless capacitors but excluding fixed surface mount multilayer capacitors of ceramic dielectric.2 Capacitors for electromagnetic interference suppression are not included, but are covered by IEC 60384-14.

Fixed capacitors for use in electronic equipment - Part 8: Sectional specification: Fixed capacitors of ceramic dielectric, Class 1

BS EN 60384-9-1:2005 电子设备用固定电容器.第9-1部分:空白详细规范:2类陶瓷电介质的固定电容器.评估等级EZ

Fixed capacitors for use in electronic equipment - Part 9-1: Blank detail specification: Fixed capacitors of ceramic dielectric, Class 2 - Assessment level EZ

NF C93-112-1:2006 电子设备中用的固定电容器.第1部分:总规范

Fixed capacitors for use in electronic equipment - Part 1 : generic specification.

IEC 60384-13-1:2006 电子设备用固定电容器.第13部分:分规范:聚苯乙烯膜介质金属箔直流固定电容器

Fixed capacitors for use in electronic equipment Part 13-1: Blank detail specification Fixed polypropylene film dielectric metal foil d.c. capacitors Assessment level E General data Inspection requirements

Fixed capacitors for use in electronic equipment - Part 13: Sectional specification - Fixed polypropylene film dielectric metal foil d.c. capacitors - Assessment level E

IEC 60384-13:2006 电子设备用固定电容器.第13部分:分规范:金属箔式聚苯乙烯膜介质直流固定电容器

This part of IEC 60384 is applicable to fixed direct current capacitors, using as dielectric a polypropylene film with electrodes of thin metal foils. The capacitors covered by this standard are intended for use in electronic equipment. Capacitors for electromagnetic interference suppression are not included but are covered by IEC 60384-14.

Fixed capacitors for use in electronic equipment - Part 13: Sectional specification - Fixed polypropylene film dielectric metal foil d.c. capacitors

IEC 60384-19-1:2006 电子设备用固定电容器.第19-1部分:空白详细规范.金属化聚乙烯对苯二甲酸酯膜介质表面安装直流固定电容器.评定等级EZ

The blank detail specification is a supplementary document to the sectional specification and contains requirements for style, layout and minimum content (general data and inspection requirements) of the detail specifications. In the preparation of detai

Fixed capacitors for use in electronic equipment - Part 19-1: Blank detail specification - Fixed metallized polyethylene-terephthalate film dielectric surface mount d.c. capacitors; Assessment level EZ

IEC 60384-19:2006 电子设备用固定电容器.第19部分:分规范:金属化聚乙烯对苯二甲酸酯膜介质表面安装直流固定电容器

The capacitors have metallized connecting pads or soldering strips and are intended to be mounted directly onto substrates for hybrid circuits or onto printed boards. They may have "self-healing properties" depending on conditions of use and are primaril

Fixed capacitors for use in electronic equipment - Part 19: Sectional specification - Fixed metallized polyethylene-terephthalate film dielectric surface mount d.c. capacitors

DIN EN 60384-9:2006 电子设备用固定电容器.第9部分:分规范.2类陶瓷介质固定电容器

This part of IEC 60384 is applicable to fixed capacitors of ceramic dielectric with a defined temperature coefficient (dielectric Class 2), intended for use in electronic equipment including leadless capacitors but excluding fixed surface mount multilayer capacitors of ceramic dielectric. Capacitors for electromagnetic interference suppression are not included, but are covered by IEC 60384 14.

Fixed capacitors for use in electronic equipment - Part 9: Sectional specification - Fixed capacitors of ceramic dielectric, Class 2 (IEC 60384-9:2005); German version EN 60384-9:2005

DIN EN 60384-8:2006 电子设备用固定电容器.第8部分:分规范.1类陶瓷介质固定电容器

This part of IEC 60384 is applicable to fixed capacitors of ceramic dielectric with a defined temperature coefficient (dielectric Class 1), intended for use in electronic equipment, including leadless capacitors but excluding fixed surface mount multilayer capacitors of ceramic dielectric.

Fixed capacitors for use in electronic equipment - Part 8: Sectional specification - Fixed capacitors of ceramic dielectric, Class 1 (IEC 60384-8:2005); German version EN 60384-8:2005