L11 电容器 标准查询与下载

IEC 60384-19:2006 电子设备用固定电容器.第19部分:分规范:金属化聚乙烯对苯二甲酸酯膜介质表面安装直流固定电容器

The capacitors have metallized connecting pads or soldering strips and are intended to be mounted directly onto substrates for hybrid circuits or onto printed boards. They may have "self-healing properties" depending on conditions of use and are primaril

Fixed capacitors for use in electronic equipment - Part 19: Sectional specification - Fixed metallized polyethylene-terephthalate film dielectric surface mount d.c. capacitors

DIN EN 60384-9:2006 电子设备用固定电容器.第9部分:分规范.2类陶瓷介质固定电容器

This part of IEC 60384 is applicable to fixed capacitors of ceramic dielectric with a defined temperature coefficient (dielectric Class 2), intended for use in electronic equipment including leadless capacitors but excluding fixed surface mount multilayer capacitors of ceramic dielectric. Capacitors for electromagnetic interference suppression are not included, but are covered by IEC 60384 14.

Fixed capacitors for use in electronic equipment - Part 9: Sectional specification - Fixed capacitors of ceramic dielectric, Class 2 (IEC 60384-9:2005); German version EN 60384-9:2005

ANSI/EIA 956:2006 带聚合物阴极的铝电解集成电容器

Polar, Nonhermetically sealed chip capacitor with conductive polymer and electrical circ

Aluminum Electrolytic Chip Capacitor with Polymer Cathode

ANSI/EIA 469-D:2006 片状瓷电容器破坏性物理分析的试验方法

Provides terminology, methods, and criteria for characterizing the internal structural features of monolithic, ceramic dielectric capacitors.

Test Method for Destructive Physical Analysis (DPA) of Ceramic Monololithic Capacitors

KS C IEC 60384-5:2005 电子设备用固定电容器.第5部分:分规范:额定电压不超过3000V直流云母固定电容器.试验方法的选择和通用要求

이 규격은 얇은 금속박이나 마이카 위에 얇은 금속을 적층한 전극에 유전체로서 마이카를 사용

Fixed capacitors for use in electronic equipment-Part 5:Sectional specification:Fixed mica dielectric d.c. capacitor with a rated voltage not exceeding 3 000 V-Selection of methods of test and general requirements

KS C IEC 60384-3:2005 电子设备用固定电容器.第3部分:分规范:片式钽固定电容器

이 규격은 탄탈륨 고체 전해 칩 커패시터에 적용 가능하다. 이 커패시터들은 혼성 회로 기판

Fixed capacitors for use in electronic equipment－Part 3：Sectional specification：Fixed tantalum chip capacitors

KS C IEC 60384-4:2005 电子设备用固定电容器.第4部分:分规范:固体(MnO2)和非固体电解质的铝电解电容器

이 규격은 우선 전자 기기에 사용되는 직류용 고체 또는 비고체 전해질을 사용하는 알루미늄

Fixed capacitors for use in electronic equipment－Part 4：Sectional specification：Aluminium electrolytic capacitors with solid and non－solid electrolyte

KS C IEC 60384-1:2005 电子设备用固定电容器.第1部分:总规范

이 규격은 전자 기기용 고정 커패시터에 대하여 규정하며, 품질 평가 또는 다른 목적을 위하

Fixed capacitors for use in electronic equipment-Part 1:Generic specification

KS C IEC 60255-16:2005 电气继电器.第16部分:阻抗测量继电器

이 규격은 임피던스 측정의 릴레이에 대한 일반적인 요건을 구체화한다. 이 릴레이 들은 하

Electrical relays－Part 16：Impedance measuring relays

KS C IEC 60255-13:2005 电气继电器.第13部分:偏置(比率)差动继电器

이 규격은 전기적으로 바이어스된 차동 릴레이의 활동 요건을 구체화한다. 이 범주의 릴레이들

Electrical relays-Part 13:Biased (percentage) differential relays

KS C IEC 60255-12:2005 电气继电器.第12部分:定向能源供应与两个继电器和功率继电器

이 규격은 2개의 에너지 공급량을 갖는 방향성 릴레이 및 전력 릴레이의 성능 요구 사항 및

Electrical relays－Part 12：Directional relays and power relays with two input energizing quantities

KS C IEC 60255-11:2005 电气继电器.第11部分:测量间歇性能源供应和AC组件的DC辅助继电器

이 규격은 측정용 릴레이의 직류 보조 에너지 공급량의 단속 및 교류 성분(맥류)과 관련하여

Electrical relays－Part 11：Interruptions to and alternating component(ripple) in d.c. auxiliary energizing quantity of measuring relays

NF C93-112-14-1:2005 电子设备用固定电容器.第14-1部分:空白详细规范.电磁干扰抑制和电源网络连接用固定电容器.评定等级D

Fixed capacitors for use in electronic equipment - Part 14-1 : blank detail specification - Fixed capacitors for electromagnetic interference suppression and connection to the supply mains - Assessment level D.

BS EN 60384-8-1:2005 电子设备用固定电容器.空白详细规范.1级陶瓷介质固定电容器.评定等级EZ

Fixed capacitors for use in electronic equipment - Blank detail specification - Fixed capacitors of ceramic dielectric, Class 1. Assessment level EZ

BS EN 60384-9:2005 电子设备用固定电容器.分规范:2级陶瓷介质固定电容器

This part of IEC 60384 is applicable to fixed capacitors of ceramic dielectric with a defined temperature coefficient (dielectric Class 2), intended for use in electronic equipment, including leadless capacitors but excluding fixed surface mount multilayer capacitors of ceramic dielectric.1 Capacitors for electromagnetic interference suppression are not included, but are covered by IEC 60384-14.

Fixed capacitors for use in electronic equipment - Sectional specification: fixed capacitors of ceramic dielectric, Class 2

IEC 60384-2-1:2005 电子设备用固定电容器.第2-1部分:空白详细规范:金属化聚乙烯对苯二甲酸酯薄膜介质直流固定电容器 评定等级E和EZ

Fixed capacitors for use in electronic equipment -Part 2-1:Blank detail specification:Fixed metallized polyethylene-terephthalate film dielectric d.c. capacitors - Assessment levels E and EZ

Fixed capacitors for use in electronic equipment - Part 2-1: Blank detail specification - Fixed metallized polyethylene-terephthalate film dielectric d.c. capacitors - Assessment level E and EZ

IEC 60384-17:2005 电子设备用固定电容器.第17部分:分规范.金属化聚丙烯膜介质直流和脉冲固定电容器

This part of IEC 60384 applies to fixed capacitors with metallized electrodes and poly-propylene dielectric for use in electronic equipment. NOTE Capacitors which have mixed foil and metallized electrodes are also within the scope of this standard. These capacitors may have "self-healing" properties depending on conditions of use. Capacitors covered by this specification are mainly intended for use with alternating voltage and/or for pulse applications. The maximum reactive power applicable is 10 000 var and the maximum peak voltage is 3 000 V. Capacitors for reactive power exceeding 500 var and to which a maximum peak voltage of 2 500 V at 50 Hz can be applied are not covered by this standard, except when they are the highest part of a range of reactive power mainly situated below 500 var at 50 Hz. This standard is not intended to cover capacitance values higher than 20 μF. Two performance grades of capacitors are covered, Grade 1 for long-life application and Grade 2 for general application. Capacitors for electromagnetic interference suppression are not included, but are covered by IEC 60384-14. Capacitors for electrical shock hazard protection (covered by IEC 60065) and fluorescent lamp and motor capacitors (covered by IEC technical committee 33, and IEC technical committee 34) are also excluded.

Fixed capacitors for use in electronic equipment - Part 17: Sectional specification - Fixed metallized polypropylene film dielectric a.c. and pulse capacitors

IEC 60384-2:2005 电子设备用固定电容器.第2部分:分规范.金属化聚乙烯对苯二甲酸酯膜介质直流固定电容器

This part of IEC 60384 applies to fixed capacitors for direct current, with metallized electrodes and polyethylene-terephthalate dielectric for use in electronic equipment. These capacitors may have "self-healing properties" depending on conditions of use. They are primarily intended for applications where the a.c. component is small with respect to the rated voltage. Two performance grades of capacitors are covered, Grade 1 for long-life application and Grade 2 for general application. Capacitors for electromagnetic interference suppression and surface mount fixed metallized polyethylene-terephthalate film dielectric d.c. capacitors are not included, but are covered by IEC 60384-14 and IEC 60384-19 respectively.

Fixed capacitors for use in electronic equipment - Part 2 : Sectional specification - Fixed metallized polyethylene-terephthalate film dielectric d.c. capacitors

IEC 60384-16:2005 电子设备用固定电容器.第16部分:分规范.金属化聚丙烯膜介质直流固定电容器

This part of IEC 60384 applies to fixed capacitors with metallized electrodes and poly-propylene dielectric for use in electronic equipment. These capacitors may have "self-healing properties" depending on conditions of use. They are mainly intended for use with direct voltage. Capacitors for alternating voltage and pulse applications are not included, but are covered by IEC 60384-17. The maximum power to be applied is 500 var at 50 Hz and the maximum peak voltage is 2500 V. Two performance grades of capacitors are covered, Grade 1 for long-life application and Grade 2 for general application. Capacitors for electromagnetic interference suppression are not included, but are covered by IEC 60384-14. Capacitors for electrical shock hazard protection (covered by IEC 60065) and fluorescent lamp and motor capacitors (covered by IEC technical committee 33, and IEC technical committee 34).

Fixed capacitors for use in electronic equipment - Part 16: Sectional specification - Fixed metallized polypropylene film dielectric d.c. capacitors

IEC 60384-17-1:2005 电子设备用固定电容器.第17-1部分:空白详细规范.金属化聚丙烯膜介质直流和脉冲固定电容器.评定等级E和EZ

Fixed capacitors for use in electronic equipment -Part 17-1:Blank detail specification:Fixed metallized polypropylene film dielectric a.c. and pulse capacitors -Assessment levels E and EZ

Fixed capacitors for use in electronic equipment - Part 17-1: Blank detail specification - Fixed metallized polypropylene film dielectric a.c. and pulse capacitors - Assessment level E and EZ