L13 电阻器 标准查询与下载

DLA DSCC-DWG-88040 REV D-2000 变量表面安装非线绕修整电阻器

This drawing describes the requirements for a variable, surface mount, non-wirewound (adjustment type, lead screw actuated) resistor.

RESISTOR, VARIABLE, SURFACE MOUNT, NON-WIREWOUND, TRIMMER

JIS C 5260-2-1:2000 电子设备用电位计.第2部分:空白详细规范:导螺杆作动的和旋转预调电位计.评定等级E

この規格は，JIS C 5260-2を品種別通則とするプランク個別規格で，にと駆動形及び回転形半固定可変抵抗器評価水準E(以下.可変抵抗器という。)について規定する。

Potentiometers for use in electronic equipment -- Part 2: Blank detail specification: Lead-screw actuated and rotary preset potentiometers Assessment level E

JIS C 5260-2:2000 电子设备用电位计.第2部分:分规范:导螺杆作动的和旋转预调电位计

この規格は，JIS C 5260-1を品目別通則とすろ品種別通則で,電子機器に使用する巻線及び非巻線のねじ駆動形及び回転形半周定可変抵抗器(以下.可変祇抗器という。)について規定する。これらの可変抵抗器は，調整を必要とする頻度が少なく微調整を目的とする回路に用いることを意図したものである。

Potentiometers for use in electronic equipment -- Part 2: Sectional specification: Lead-screw actuated and rotary preset potentiometers

JIS C 5260-5-2:2000 电子设备用电位计.第5部分:空白详细规范:单匝低功率旋转电位计.评定等级F

この規格は，JIS C 5260-5を品種別通則とするプランク個別規格で，単回転低電力形巻線及び非巻線可変抵抗器評価水準F(以下.可変抵抗器という。)について規定する。

Potentiometers for use in electronic equipment -- Part 5: Blank detail specification: Single-turn rotary low-power potentiometers Assessment level F

JIS C 5260-5-1:2000 电子设备用电位计.第5部分:空白详细规范:单匝低功率旋转电位计.评定等级E

この規格は，JIS C 5260-5を品種別通則とするプランク個別規格で，単回転低電力形巻線及び非巻線可変抵抗器評価水準E(以下,可変抵抗器という。)について規定する。

Potentiometers for use in electronic equipment -- Part 5: Blank detail specification: Single-turn rotary low-power potentiometers Assessment level E

JIS C 5260-5:2000 电子设备用电位计.第5部分:分规范:单匝低功率线绕旋转和非线绕电位计

この規格は， JIS C 5260-1を品目別通則とする電子機器用可変抵抗器の品種別通則で，定格電力が10W未満の単回転低電力形巻線及び非巻線の可変抵抗器(以下,可変抵抗器という。)について規定する。

Potentiometers for use in electronic equipment -- Part 5: Sectional specification: Single-turn rotary low-power wirewound and non-wirewound potentiometers

JIS C 5260-2-2:2000 电子设备用电位计.第2部分:空白详细规范:导螺杆作动的和旋转预调电位计.评定等级F

この規格は，JIS C 5260-2を品種別通則とするプランク個別規格で,ねと駆動形及び回転形半固定可変抵抗器評価水準F（以下.可変祇抗器という。）について規定する。

Potentiometers for use in electronic equipment -- Part 2: Blank detail specification: Lead-screw actuated and rotary preset potentiometers Assessment level F

DLA A-A-59496-2000 绕有电阻丝或没绕的匀货机微调电容器调整片 可变电阻 常规

This CID covers the general requirements for variable, nonwire wound, wire wound, single turn, multi-turn and lead-screw actuated, with a contact bearing uniformly over the entire surface of the entire resistive element, when positioned by an actuator. These resistors are capable of full load operation at maximum temperatures, and are suitable for continuous operation when properly derated. Requirements for specific resistors are covered in the individual CID sheets.

RESISTOR, VARIABLE, TRIMMER NONWIRE WOUND, AND WIREWOUND, GENERAL SPECIFICATION FOR

DLA A-A-59497-2000 非精确或精确的绕线或没绕线可变电阻 常规

This CID covers the general requirements for wire wound, nonwire wound, precision, nonprecision variable resistors. The individual requirements for specific resistors are covered in the individual CID sheets. For technical assistance when utilizing parts for parameters not specifically detailed, contact the manufacturers listed on applicable CID sheets. The resistors covered by this CID are intended for commercial/industriaI applications.

RESISTORS, VARIABLE, NONWIRE WOUND, WIRE WOUND, PRECISION, NONPRECISION, GENERAL REQUIREMENTS FOR

ARMY MS24537 REV C VALID NOTICE 3-2000 24伏特直流电电阻温度变送器

MS24537C remains inactive for new design, however, the document is valid for acthewhen needed.

TRANSMITTER, TEMPERATURE ELECTRICAL RESISTANCE - 24 VOLT DC

ARMY MS24542 REV H VALID NOTICE 2-2000 24伏特直流电.范围在160度至零下320度的电阻温度变送器

MS24542H remains inactive for new design, however, the document is valid for acthewhen needed.

INDICATOR, TEMPERATURE, ELECTRICAL RESISTANCE; 24 VOLT DC, RANGE 160 DEG.-320 DEG. F

ARMY MS24543 REV H VALID NOTICE 2-2000 24伏特直流电.范围在120度至零下240度的电阻温度变送器

MS24543H remains inactive for new design, however, the document is valid for acthewhen needed.

INDICATOR, TEMPERATURE, ELECTRICAL RESISTANCE; 24 VOLT DC, RANGE 120 DEG. -240 DEG. F

SJ 51432/1-1999 RMK3216型有可靠性指标的片式膜固定电阻器详细规范

Resistors,fixed,film,chip,established reliability,style RMK3216,detail specification for

IEC 60397:1994/COR1:1999 有金属加热电阻体的间歇式炉的试验方法

This standard is Test methods for batch furnaces with metallic heating resistors; Corrigendum 1.

Test methods for batch furnaces with metallic heating resistors; Corrigendum 1

IEC 60115-1:1999 电子设备用固定电阻器.第1部分:总规范

This part of IEC 60115 is applicable to fixed resistors for use in electronic equipment. It establishes standard terms, inspection procedures and methods of test for use in sectional and detail specifications of electronic components for quality assessment or any other purpose.

Fixed resistors for use in electronic equipment - Part 1: Generic specification

DIN EN 140402:1999 空白详细规范.低功率绕线的表面安装固定式电阻(SMD)

The document is a supplementary document of the Sectional Specifications and contains requirements for style and layout and minimum content of detail specifications.

Blank detail specification: Fixed low power wire wound surface mounting (SMD) resistors; German version EN 140402:1998

DIN EN 60477:1999 实验室直流电阻器

The document applies to resistors intended for use as laboratory d.c. resistors comprising single or multiple resistors for accuracy Classes 0,0005 to 0,2 and single or multi-decade resistors of accuracy Classes 0,0005 to 5.#,,#

Laboratory d.c. resistors (IEC 60477:1974 + A1:1997); German version EN 60477:1997 + A1:1997

DIN EN 60477-2:1999 实验室电阻器.第2部分:实验室交流电阻

The document applies to resistors intended as laboratory a.c. resistors for use over a range of frequencies from d.c. up to stated frequency which is not in excess of 100 kHz.

Laboratory resistors - Part 2: Laboratory a.c. resistors (IEC 60477-2:1979 + A1:1997); German version EN 60477-2:1997 + A1:1997

JIS C 5201-6-2:1999 电子设备用固定电阻器.第6部分:空白详细规范.带有可独立测量电阻（不同电阻值或不同额定耗散）的固定电阻网络. E 评定等级

この規格は，JIS C 5201-6を品種別通則とするプランク個別規格で，個別測定可能な固定ネットワーク抵抗器—異種抵抗値又は異種定格電力評価水準Eについて規定する。

Fixed resistors for use in electronic equipment Part 6: Blank detail specification: Fixed resistor networks with individually measurable resistors, of either different resistance values or different rated dissipations Assessment level E

JIS C 5201-6-1:1999 电子设备用固定电阻器.第6部分:空白详细规范:由独立可测量电阻、所有电阻值和功耗均相同的电阻器组成的固定电阻网络.评估等级E

この規格は，JIS C 5201-6(電子機器用固定抵抗器—第6部:品種別通則:個別測定可能な固定ネットワーク抵抗器)を品種別通則とするブランク個別規格で,個別測定可能な固定ネットワーク抵抗器-同一抵抗値及び同-一定格電力評価水準Eについて規定する。

Fixed resistors for use in electronic equipment Part 6: Blank detail specification: Fixed resistor networks with individually measurable resistors, all of equal value and equal dissipation Assessment level E