N47 缩微复印机械 标准查询与下载
共找到 244 条与 缩微复印机械 相关的标准，共 17 页
Guidelines for the management of copying machinery consumables
- ICS
- CCS
- N47
- 发布
- 1991-07-16
- 实施
- 1992-07-01
本标准规定了静电复印干式色调剂流动性测定方法，其中包括：术语、符号、原理、使用的仪器、测定的环境条件、取样方法、测定步骤、测定结果和报告。 本标准适用于干式双组份色调剂及干式单组分显影剂流动性的测定，载体流动性测定应使用GB 7369-87标准方法。
Method for measuring dry toner fluidity in xerographic printing
- ICS
- CCS
- N47
- 发布
- 1991-07-10
- 实施
- 1992-07-01
本标准规定了测量静电复印硒鼓光电性能的两种方法（方法A和方法B），内容包括方法原理、测试装置、测试条件、测试步骤和测试报告。 本标准适用于硒及硒合金类型静电复印硒鼓。
Measuring method of photoelectric properties of toner cartridge for electrophotographic printing
- ICS
- CCS
- N47
- 发布
- 1991-07-10
- 实施
- 1992-07-01
本标准规定了缩微阅读复印机的技术要求、试验方法、检验规则及标志、包装、运输、贮存的要求。 本标准适用于放大倍率不超过X50的16mm，35mm条形片、缩微卷片、缩微平片、封套片、开窗卡片等透明缩微品阅读复印机。 本标准不适用于放大复印机此类纯生产性设备，也不适用于产生彩色的或其他特殊类型复印件的阅读复印机。
Micrographic technology reading copier
- ICS
- 37.100.10
- CCS
- N47
- 发布
- 1991-07-10
- 实施
- 1992-07-01
本标准规定了静电复印干式双组份显影剂用色调剂 产品的分类、技术要求、试验方法、检验规则及标志、包装、运输、贮存。 本标准适用于磁刷显影、热定影的静电复印机上使用的干式双组份显影剂用色调剂。其它类型的干式双组份显影剂用色调剂可参照采用。
Toner for dry type two-component developer in electrostatic copying
- ICS
- CCS
- N47
- 发布
- 1991-07-10
- 实施
- 1992-07-01
本标准规定了静电复印机用交流风机的技术要求、试验方法、检验规则并对包装、标志、运输、贮存作了规定。 本标准适用于复印机用横流式及轴流式交流风机，其它类型的风机亦可参照采用。
General technical specification for AC fans for photocopiers
- ICS
- CCS
- N47
- 发布
- 1991-07-10
- 实施
- 1992-07-01
Micrographics. Deks-top microform readers. Characteristics and simplified checking methods.
- ICS
- 37.080
- CCS
- N47
- 发布
- 1991-07-01
- 实施
- 1991-07-28
This recommended practice describes operational and quality control guidelines for alphanumeric computeroutput microfilm recorders and microforms using black-and -white film as well as duplicates made from such filmes.
Test Procedure for Duplicating 35 mm Diazo Microfilm Aperture Cards Addendum - 1996
- ICS
- 37.080
- CCS
- N47
- 发布
- 1990-01-01
- 实施
This recommended practice describes operational and quality control guidelines for alphanumeric computeroutput microfilm recorders and microforms using black-and -white film as well as duplicates made from such filmes.
Recommended Practice for the Requirements and Characteristics of Original Documents That May Be Microfilmed
- ICS
- 37.080
- CCS
- N47
- 发布
- 1990-01-01
- 实施
This recommended practice describes operational and quality control guidelines for alphanumeric computeroutput microfilm recorders and microforms using black-and -white film as well as duplicates made from such filmes.
Recommended Practice for Inspection of Stored Silver-Gelatin Microforms for Evidence of Deterioration
- ICS
- 37.080
- CCS
- N47
- 发布
- 1990-01-01
- 实施
This recommended practice describes operational and quality control guidelines for alphanumeric computeroutput microfilm recorders and microforms using black-and -white film as well as duplicates made from such filmes.
35 mm Planetary Cameras (Top-Light) - Procedures for Determining Illumination Uniformity of Microfilming Engineering Drawings Includes Errata and Amendment 1: 1998
- ICS
- 37.080
- CCS
- N47
- 发布
- 1990-01-01
- 实施
This test method is used to determine the copy per minute rating (productivity) of electrostatic copiers under standard conditions. It measures the time required to copy a specific standard load on a copy machine. This productivity value is to be compared to the repeat copy rate for the same machine to see if there is a change in the efficiency of the machine when various accessories or combinations of accessories are added to or used on the machine, or when the work load changes. It can also be used to compare the efficiencies of different but similarly equipped copy machines. It is suitable for productivity evaluation by the user, and in research and development.1.1 This test method covers the determination of productivity using electrostatic copy machines with various combinations of accessories and in different operating modes. 1.2 The results from this test method will enable copy machine users to compare the productivity of similarly equipped copiers to each other or the productivity of a copy machine can be compared with itself in its various configurations. 1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Method for Determination of Productivity Using Electrostatic Copy Machines with Various Configurations
- ICS
- 37.100.10 (Reproduction equipment)
- CCS
- N47
- 发布
- 1990
- 实施
This test method is used to determine the copy per minute rating (productivity) of electrostatic copiers under standard conditions. It measures the time required to copy a specific standard load on a copy machine. This productivity value is to be compared to the repeat copy rate for the same machine to see if there is a change in the efficiency of the machine when various accessories or combinations of accessories are added to or used on the machine, or when the work load changes. It can also be used to compare the efficiencies of different but similarly equipped copy machines. It is suitable for productivity evaluation by the user, and in research and development.1.1 This test method covers the determination of productivity using electrostatic copy machines with various combinations of accessories and in different operating modes. 1.2 The results from this test method will enable copy machine users to compare the productivity of similarly equipped copiers to each other or the productivity of a copy machine can be compared with itself in its various configurations. 1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Method for Determination of Productivity Using Electrostatic Copy Machines with Various Configurations
- ICS
- 37.100.10 (Reproduction equipment)
- CCS
- N47
- 发布
- 1990
- 实施
Duplicators and document copying machines. Symbols.
- ICS
- 01.080.20;37.100.10
- CCS
- N47
- 发布
- 1989-11-01
- 实施
- 1989-11-20
This part of ISO 8127 specifies the characteristics of five chan-nel jackets for 16 mm microfilm.
Micrographics; A6 size microfilm jackets; part 1: five channel jacket for 16 mm microfilm
- ICS
- 37.080
- CCS
- N47
- 发布
- 1989-08
- 实施
- 1989-08-15
This recommended practice describes operational and quality control guidelines for alphanumeric computeroutput microfilm recorders and microforms using black-and -white film as well as duplicates made from such filmes.
Recommended Practice for the Expungement, Deletion, Correction, or Amendment of Records on Microforms
- ICS
- 37.080
- CCS
- N47
- 发布
- 1989-01-01
- 实施
This recommended practice describes operational and quality control guidelines for alphanumeric computeroutput microfilm recorders and microforms using black-and -white film as well as duplicates made from such filmes.
Bar Coding on Microfiche for Production and Dynamic Distribution Control
- ICS
- 37.080
- CCS
- N47
- 发布
- 1988-01-01
- 实施
This recommended practice describes operational and quality control guidelines for alphanumeric computeroutput microfilm recorders and microforms using black-and -white film as well as duplicates made from such filmes.
Microfilm Jackets Errata - 1993
- ICS
- 37.080
- CCS
- N47
- 发布
- 1987-01-01
- 实施
This recommended practice describes operational and quality control guidelines for alphanumeric computeroutput microfilm recorders and microforms using black-and -white film as well as duplicates made from such filmes.
Recommended Practice for Operational Procedures, Quality Control and Inspection of Graphic Computer-Output Microforms
- ICS
- 37.080
- CCS
- N47
- 发布
- 1987-01-01
- 实施
This standard applies to microfiche produced as a result of source document and computer-output microfilming.
Method for Measuring Thickness of Buildup Area on Unitized Microfilm Carriers (Aperture, Camera, Copy, and Image Cards) Addenda - 1996
- ICS
- 37.080
- CCS
- N47
- 发布
- 1987-01-01
- 实施
