P30 工业与民用建筑工程综合 标准查询与下载

KS F ISO 6242-1:2001 建筑结构.用户要求事项.第1部分:热量性能

이 규격은 건물 사용자의 온열 요구를 파악, 표현, 정량화하기 위한 방법을 규정한다. 이

Building construction-Expression of users′ requirements-Part 1:Thermal requirements

KS F ISO 9883:2001 建筑物性能标准.有预浇负载情况下预制钢盘钢筋混凝土地板的性能试验

이 규격(1)은 집중 하중을 받는 바닥과 바닥 부재의 거동을 측정하기 위한 시험 방법을 규

Performance standards in building-Performance test for precast concrete floors-Behaviour under concentrated load

KS F ISO 6242-2:2001 建筑结构.用户要求事项.第2部分:空气净化性能

이 규격은 건물 사용자의 공기 청정 요구를 파악, 표현, 정량화하기 위한 방법을 규정한다.

Building construction-Expression of users′ requirements-Part 2:Air purity requirements

KS F ISO 7162:2001 建筑物性能标准.性能评定标准的内容和格式

이 규격은 건축물 전체나 건축물의 일부분(구성재, 조립품, 서브 시스템), 건축물 내부ㆍ외

Performance standards in building－Contents and format of standards for evaluation of performance

KS F ISO 9699:2001 建筑性能标准.简要检查表.建筑设计用简要内容

이 규격은 건축물 설계 요약서의 내용을 규정한다.

Performance standards in building－Checklist for briefing－Contents of brief for building design

KS F ISO 6240:2001 建筑物性能标准.内容和说明

이 규격은 건축물의 구성재와 조립품의 성능 표준에 포함되는 기본적 내용과 표기 순서에 대해

Performance standards in building-Contents and presentation

KS F ISO 6241:2001 建筑物性能标准.标准的制定原则和所考虑的因素

이 규격은 건축물의 성능 표준 작성을 위한 일반 원칙을 규정한다. 그리고 성능 표준에 고려

Performance standards in building-Principles for their preparation and factors to be considered

DIN EN 50171:2001 中央动力供应系统

Central power supply systems; German version EN 50171:2001 + Corrigendum 2001-08

ISO 12494:2001 结构的大气结冰

1 General This International Standard describes the general principles of determining ice load on structures of the types listed in 1.2. In cases where a certain structure is not directly covered by this or another standard or recommendation, designers may use the intentions of this International Standard. However, the user should always consider carefully the applicability of the standard (recommendation) to the structure in question. The practical use of all data in this International Standard is based upon certain knowledge of the site of the structure. It is necessary to have information about the degree of "normal" icing amounts (= ice classes) for the site in question. For many areas, however, no information is available. Even in such cases this International Standard can be useful, because local meteorologists or other experienced persons should be able to, on the safe side, estimate a proper ice class. Using such an estimate in the structural design will result in a much safer structure, than designing without any considerations for problems due to ice. CAUTION It is extremely important to design for some ice instead of no ice, and then the question of whether the amount of ice was correct is of less importance. In particular, the action of wind can be increased considerably due to both increased exposed area and increased drag coefficient. 2 Application This International Standard is intended for use in determining ice mass and wind load on the iced structure for the following types of structure: — masts; — towers; — antennas and antenna structures; — cables, stays, guy ropes, etc.; — rope ways (cable railways); — structures for ski-lifts; — buildings or parts of them exposed to potential icing; — towers for special types of construction such as transmission lines, wind turbines, etc. Atmospheric icing on electrical overhead lines is covered by IEC (International Electrotechnical Commission) standards. This International Standard is intended to be used in conjunction with ISO 2394. NOTE Some typical types of structure are mentioned, but other types might be considered also. Designers should think in terms of which type of structure is sensitive to unforeseen ice, and act thereafter. Also, in many cases only parts of structures should be designed for ice loads, because they are more vulnerable to unforeseen ice than is the whole structure. Even if electrical overhead lines are covered by IEC standards, designers may use this International Standard for the mast structures to overhead lines (which are not covered by IEC standards) if they so wish.

Atmospheric icing of structures

ASHRAE 90421-2001 为商业和机构建筑物设计的湿度控制设计指南

Humidity Control Design Guide for Commercial and Institutional Buildings

Humidity Control Design Guide for Commercial and Institutional Buildings

ANSI A10.34-2001 建筑地点及其附近的公共区域的保护

This standard provides the recommended elements and activities on construction projects to provide protection for the Public.

Protection of the Public on and Adjacent to Construction Sites

DIN 18012:2000 建筑物中的家用连接设施.空间要求和设计原则

The document is applicable for the determination of space requirements of house service connection facilities in buildings. It stipulates structural requirements for the construction of these facilities.

House service connection facilities in buildings - Space requirements, principles for planning

DIN V ENV 1991-2-7:2000 欧洲法规1.支承结构设计和对结构作用原理.第2-7部分:冲击和爆炸的突然作用对结构的影响

Eurocode 1: Basis of design and actions on structures - Part 2-7: Actions on structures; accidental actions due to impact and explosions; German version ENV 1991-2-7:1998

KT 22-2000 栅栏

Fences

DIN 52460:2000 密封和窗用玻璃.术语

The document specifies terms of sealing and glazing in building constructions.

Sealing and glazing - Terms

YD 5082-1999 建筑与建筑群综合布线系统工程设计施工图集

Drawings set for engineering design and working of generic cabling system for building and campus

ANSI C57.12.40-2000 地下铁道和拱顶型(液浸式).要求

Covers certain electrical, dimensional, and mechanical characteristics and takes into consideration certain safety features of three-phase, 60-Hz, liquid-immersed, secondary network transformers with a three-position grounding switch, subway and vault ty

Subway and Vault Types (Liquid Immersed) - Requirements

DB37/ 268-1999 霓虹灯安装规范

本标准规定了霓虹灯管、霓虹灯变压器、霓虹灯控制器、导线、避雷装置、霓虹灯招牌以及导线贯穿板壁等安装要求，适用于各类室内、外霓虹灯安装工程。

Neon Light Installation Specifications

BS 6651:1999 建筑物避雷装置的实施规范

This British Standard provides guidance on the design of systems for the protection of structures against lightning and on the selection of materials. Recommendations are made for special cases such as explosives stores and temporary structures, e.g. cranes and spectator stands constructed of metal scaffolding. Guidance is also given on the protection of electronically stored data. The principle informing all the provisions of this British Standard is that of the "Faraday cage" form of lightning protection, and installations employing alternative technologies fall outside the scope of this British Standard. Protection of offshore oil and gas installations does not fall within the scope of this British Standard. NOTE Where current-carrying conductors are directly associated with structures lying within the scope of this code of practice, certain recommendations relating to them are included; however, the protection of radar stations, overhead telephone wires, electric traction and supply lines should, on account of their special nature, be determined by the appropriate authorities.

Code of practice for protection of structures against lightning

CJ 27-1999 房屋接管验收标准

Acceptance standard of buildings taken over