共找到 261 条与 建筑给水、排水工程 相关的标准,共 18 页
Design, construction and testing of temperature relief valves of the automatic reseating type, specifically intended for use with and protection of storage water heaters of the unvented type. Does not give recommendations on application or installation of the valves.
Safety and control devices for use in hot water systems - Specifications for temperature relief valves for pressures from 1 bar to 10 bar
Requirements for two grades of plastic floats specified in BS 1212.
Specification for floats (plastics) for float operated valves for cold water services
Recommendations on basic workmanship. Common Arrangement of Work Section (CAWS) classification S12.
Workmanship on building sites - Code of practice for hot and cold water services (domestic scale)
The following is a listing of the standards referenced in this code, the effective date of the standard, the promulgating agency of the standard and the section(s) of this code that refer to the standard.
Sizing the Building Water Supply Distribution System
The format and provisions of The BOCA National Propero Maintenance Code are designed to provide units of government with an effective regulatory means of providing minimum health and safety requirements for existing buildings and structures.
Individual Water Supply Eighth Edition
The provisions requiring that the excavation left when an unfit structure has been removed be filled in is an obvious, but often neglected means of protecting the public health and safety.
Individual Water Supply
Each of the BOCA National Codes is completely updated and published in a new edition every three years. Code change activity is conducted annually within each three-year edition cycle. The first and second year’s approved changes are published in supple
Sizing the Building Water Supply Distribution System Eighth Edition
This standard applies to flue connected accumulating water heaters with vaporizing burners for EL fuel-oil corresponding to DIN 51603 part 1.
Oil fired bath water heaters with vaporizing burners
1.1 This guide covers procedures for well-defined recordkeeping of reverse osmosis (RO) systems.1.2 This guide includes a start-up report, recordkeeping of RO operating data, recordkeeping of pretreatment operating data, and a maintenance log.1.3 This guide is applicable to waters including brackish waters and seawaters but is not necessarily applicable to wastewaters.1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Guide for Recordkeeping for Reverse Osmosis Systems
The types of low temperature hot water heating equipment which are in common use and the selection of such equipment when designing open vented or sealed systems.
Code of practice for low temperature hot water heating systems of output greater than 45 kW - Selection of equipment
Requirements which need to be taken into account in the design of open-vented or sealed systems.
Code of practice for low temperature hot water heating systems of output greater than 45 kW - Fundamental and design considerations
Above-ground drainage --Recommended practice and techniques for the installation of unplasticized polyvinyl chloride (PVC-U) sanitary pipework for above-ground systems inside buildings
Roof Drains Revision of ANSI A112.21.2-1971
This specification covers the general construction requirements for sewerage systems including connecting sewers, manholes, and the like, but excluding sewer rising mains, pump stations, treatment works, and ancillary works. HOTE : The standards referred to in the specification are listed in Appendix A.
Standardized specification for civil engineering construction Section LD: Sewers
Design, planning, installation, inspection and testing of hot water supply systems in commercial, industrial or multiple dwelling buildings, including district or group schemes. To be read in conjunction with BS 6700:1997
Code of practice for centralized hot water supply. Buildings other than individual dwellings
Materials, design, construction and dimensions of basins, Type 'A' rectangular shaped sinking on plan, and 'B' round bowl.
Specification for metal hand rinse basins
Method of test for drainage of equipment units for dwellings
Technical specification for unplasticized polyvinyl chloride double-wall noise-reducing pipeline engineering of water sewerage in buildings(explanation)
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号