Q15 墙体材料 标准查询与下载

ASTM C1127-95 有整体磨损表面的高固体含量及冷液处理的弹性防水薄膜材料的应用标准指南

1.1 This guide describes the design and installation of cold liquid-applied elastomeric waterproofing membrane systems that have an integral wearing surface. The cold liquid-applied elastomeric waterproofing membrane (membrane) to which this guide refers is specified in Specification C957.1.2 Concrete Slab-on-Grade--Waterproofing the upper surface of a concrete slab on grade presents special problems due to the possibility of negative hydrostatic pressure causing loss of bond to the substrate. Consideration of these problems is beyond the scope of this guide. Consult the membrane manufacturer for recommendations when this situation exists.1.3 The committee having jurisdiction for this guide is not aware of any similar ISO standard.1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements see Note in 15.4.

Standard Guide for Use of High Solids Content, Cold Liquid-Applied Elastomeric Waterproofing Membrane with an Integral Wearing Surface

CGSB 34.18-94-CAN/CGSB-1994 低密度石棉板 代替34-GP-18M

Low Density Asbestos Sheets

Plaques D'Amiante De Faible Masse Volumique

JC/T 525-1993 煤渣砖

cinder block

JIS A 5409:1993 预制钢筋混凝土围墙构件

この規格は，鉄筋コンクリート組立塀の構成材（以下,コンクリート組立塀という。)について規定する。

Precast reinforced components for concrete fences

NF P51-202:1993 建筑工程.只用木材做燃料的配备或不配备回热器的外露壁炉.技术规范

DTU 24.2.1 - Building works - Open fireplaces fitted or not with heat regenerator using only wood for fuel - Technical specifications.

NF P68-201:1993 DTU 25-232.建筑工程.吊顶.石膏底板.石膏墙板.技术规范

DTU 25-232. Building works. Suspended ceilings. Gypsum baseboards. Gypsum wallboards. Technical specifications.

NF P71-202:1993 DTU 25-221.建筑工程.石膏灰浆悬吊式金属板条天花板.技术规范

DTU 25-221. Building works. Gypsum plastered suspended metal lath ceilings. Technical specifications.

NF P71-201-1:1993 DTU 25-1.建筑工程.内壁石膏灰浆.第1部分:技术规范

DTU 25-1. Building works. Internal gypsum plastering. Part 1 : technical specifications.

BOCA CHAPTER 18 NBC-1993 地基会及挡土墙

The BOCA National Mechanical Code was initially prepared and updated on the premise that adequate code requirements are essential to the safe installation and maintenance of all mechanical equipment and systems in order to protect the public health, sa

Foundations and Retaining Walls

BOCA CHAPTER 18 NBC COMM V2-1993 地基会及挡土墙

Each of the BOCA National Codes is completely updated and published in a new edition every three years. Code change activity is conducted annually within each three-year edition cycle. The first and second year’s approved changes are published in supple

Foundations and Retaining Walls

ASTM C456-93(2003) 碱性砖及模型耐水化作用的试验方法

This test method compares relative resistance to hydration of basic refractory brick and shapes in laboratory tests. This test method allows an estimate to be made of the relative potential for hydration. The test method is used in industry and in some cases it is used for specification purposes. The results must be carefully used as a means of predicting whether or not basic brick or shapes will hydrate under actual conditions of storage or service. 1.1 This test method covers measurement of the relative resistance of basic brick and shapes to hydration. 1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Hydration Resistance of Basic Bricks and Shapes

BS 5234-2:1992 隔墙(包括覆面板).第2部分:隔墙强度和坚固性要求(包括试验方法)规范

For a sample partition with a door when tested by the methods given in the annexes. Grades derived when tested for stiffness, hard and soft body impacts and door slamming. Performance levels and test methods are also given for crowd pressure, lightweight and heavyweight anchorages.

Partitions (including matching linings) - Specification for performance requirements for strength and robustness including methods of test

BS 5234-1:1992 隔墙(包括覆面板).第1部分:设计和安装实施规程

Types of partition are defined and the functions and properties to be considered are given regardless of the material from which they are made. Grades of partition are given related to their strength and robustness. Recommendations for ensuring that the design is realized on site and maintained after completion are given.

Partitions (including matching linings) - Code of practice for design and installation

JIS A 6512:1992 移动式隔墙

Movable partitions

JC/T 466-1992 砌墙砖检验规则

Test rules for wall building bricks

JIS A 5417:1992 刨花水泥板

Cement bonded particle boards

JC/T 422-1991 非烧结普通粘土砖

Non-fired ordinary clay brick'

ISO 9384:1991 纤维水泥背瓦

This International Standard specifies the character-istics and establishes methods of control and test as well as acceptance conditions for fibre-cement siding shingles, which are not covered by ISO 880. It applies to shingles of dimensions not exceeding 600 mm × 600 mm. note: 1) National standards may include shingles with dimensions exceeding 600 mm. In this case, all tests with the exception of the heat-rain test should be carried out on elements cut from such shingles. The heat-rain test should always be con-ducted on full-size shingles and the dimensions of the test rig should be adapted accordingly.

Fibre-cement siding shingles

JC/T 429-1991 砖瓦工业隧道窑——干燥室体系热效率、单位热耗、单位煤耗计算方法

Brick and Tile Industrial Tunnel Kiln—Calculation Method of Thermal Efficiency, Unit Heat Consumption and Unit Coal Consumption of Drying Chamber System

JC/T 428-1991 砖瓦工业隧道窑热平衡、热效率测定与计算方法

Measurement and Calculation Method of Heat Balance and Thermal Efficiency of Brick and Tile Industrial Tunnel Kiln