Q17 屋面、铺面防水与防潮材料 标准查询与下载

JGJ/T 316-2013 单层防水卷材屋面工程技术规程

Technical specification for single-layer waterproof membrane roofing engineering

EN 12697-43:2014 沥青混合料.热拌沥青实验方法.第43部分:耐燃料

This European Standard specifies a test method to determine the resistance of a bituminous mixture or pavement to fuels. The procedure involves initial soaking of a test specimen made in the laboratory or cored from a pavement in a fuel, followed by a brushing period with a brush test device. The material loss of the specimen is a measure of the resistance to that fuel for that bituminous mixture.

Bituminous mixtures - Test methods for hot mix asphalt - Part 43: Resistance to fuel

BS EN 13859-2:2014 防水柔性板材. 衬垫物的定义和性能. 墙体衬垫物

Flexible sheets for waterproofing. Definitions and characteristics of underlays. Underlays for walls

BS EN 13859-1:2014 防水柔性板材. 衬垫物的定义和性能. 不连续屋顶用衬垫物

Flexible sheets for waterproofing. Definitions and characteristics of underlays. Underlays for discontinuous roofing

JC/T 2218-2014 防水卷材沥青技术要求

本标准规定了用于防水卷材用沥青的分类、技术要求和试验方法、检验规则以及标志、包装、运输和贮存。本标准适用于以天然石油经蒸馏、氧化或调配等工艺制得的,用于生产改性沥青防水卷材、自粘改性沥青防水卷材的石油沥青。

Technical requirement for asphalt used in waterproofing sheet

JC/T 2217-2014 环氧树脂防水涂料

本标准规定了环氧树脂防水涂料(简称EP防水涂料)的术语和定义、标记、一般要求、技术要求、试验方法、检验规则以及标志、包装、运输和贮存。本标准适用于建设工程非外露使用的环氧树脂防水涂料。

Epoxy resin waterproof coating

EN 12597:2014 沥青和沥青粘合剂.术语

This European Standard defines terms for paving or industrial bitumen of various types and binders derived from bitumen. This European Standard is intended to cover materials only within the scope of CEN/TC 336, i.e. only bitumens and bituminous binders. It should consequently not extend to non-petroleum "hydrocarbon" binders such as coal tar and its derivatives or to natural asphalts. However, some definitions are given for some excluded materials and related terms. The corresponding terms were introduced only when they appeared in a definition of a product or process and when their definition was found necessary for understanding or for avoiding any ambiguity.

Bitumen and bituminous binders - Terminology

EN 12697-7:2014 沥青混合料.热拌沥青实验方法.第7部分:γ射线测定沥青样品的容积密度

This European Standard specifies a method for measuring the bulk density of pavement mixtures using a transmission-type gamma radiation test bench. The applicability of this European Standard is described in the product standards for bituminous mixtures. The safety regulations applicable to the use of gamma rays should be applied. This European Standard applies to cylindrical specimens or blocks, prepared in a laboratory or cut from a pavement, the thickness and the mass absorption coefficient which is a function of the chemical composition are known. The thickness of the specimen body traversed by the radiation shall be between 30 mm and 300 mm. The method cannot be applied to materials containing slags, with variable metal content or chemical composition which may affect the absorption of gamma rays.

Bituminous mixtures - Test methods for hot mix asphalt - Part 7: Determination of bulk density of bituminous specimens by gamma rays

EN 13859-1:2014 防水软片.底衬的定义及特性.第1部分:间断式屋顶的底衬

This European standard specifies the characteristics of flexible sheets for underlays which are to be used under roof covering of discontinuous roofs. It specifies the requirements and test methods and provides for the evaluation of conformity of the products with the requirements of this document.

Flexible sheets for waterproofing - Definitions and characteristics of underlays - Part 1: Underlays for discontinuous roofing

PD CEN/TS 15963:2014 沥青和沥青粘合剂.用三点弯曲试验检在缺口试样做实验测断裂韧性温度

This Technical Specification specifies a method for the determination of the Fracture Toughness temperature, TFT, of bituminous binders by means of a three point bending test on a notched binder sample. WARNING - The use of this Technical Specification can involve hazardous materials, operations and equipment. This Technical Specification does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this Technical Specification to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use. For environmental reasons, it is recommended to limit the use of products, solvents and energy to minimum in order to reduce the emissions to air, water and soil.

Bitumen and bituminous binders - Determination of the fracture toughness temperature by a three point bending test on a notched specimen

EN 13859-2:2014 防水软片.底衬的定义及特性.第2部分:墙壁底衬

This European standard specifies the characteristics of flexible sheets for underlays for walls which are to be used in walls behind outside wall coverings in order to avoid penetration of wind and water from outside. It specifies the requirements and test methods and provides for the evaluation of conformity of the products with the requirements of this document.

Flexible sheets for waterproofing - Definitions and characteristics of underlays - Part 2: Underlays for walls

DIN CEN/TR 16625:2014 防水用软片材.制造商限制价值和申报价值(MLV和MDV)的统计学定义.95%的统计数值.德文版本CEN/TR 16625-2013

Flexible sheets for waterproofing - Statistical definition of manufacturer's limiting value and declared value (MLV and MDV) - 95 % Statistic; German version CEN/TR 16625:2013

DIN EN 16240:2014 屋顶, 墙壁和天花板的内外部用光传输平面固态聚碳酸酯 (PC) 薄板. 要求和试验方法; 德文版本EN 16240-2013

Light transmitting flat solid polycarbonate (PC) sheets for internal and external use in roofs, walls and ceilings - Requirements and test methods; German version EN 16240:2013

BS EN 12697-49:2014 沥青混合物. 热混沥青的试验方法. 抛光后的摩擦力测定

Bituminous mixtures. Test methods for hot mix asphalt. Determination of friction after polishing

PD CEN/TS 14416:2014 土工合成障碍.试验方法来确定耐根

This Technical Specification describes a laboratory procedure for the rapid testing of the resistance of polymeric, bituminous or clay geosynthetic barriers to root penetration. It is suitable for testing of welded seams or other areas of potential weakness. A longer test that may be more suitable for testing the long-term resistance of geosynthetic barriers is described in EN 13948.

Geosynthetic barriers - Test method for determining the resistance to roots

NF P84-138*NF EN 13707:2014 防水用柔性板.屋顶防水用增强油毛毡.定义和特性

La présente Norme européenne spécifie les définitions et les caractéristiques pour les feuilles bitumineuses souples armées, dont l'utilisation prévue est l'étanchéité de toiture. Ceci concerne des feuilles utilisées comme dernière couche, couche intermédiaire ou couche inférieure. Cette norme ne concerne pas les feuillesbitumineuses d'étanchéité armées, utilisées comme sous-couche ou écran de sous-toiture.La présente Norme européenne ne traite pas des feuilles d'étanchéité qui sont destinées à être posées en adhérence totale sous protection de surface en produits bitumineux (par exemple l'asphalte) directement mises en oeuvre à température élevée, spécifié

Flexible sheets for waterproofing - Reinforced bitumen sheets for roof waterproofing - Definitions and characteristics

EN 12697-49:2014 沥青混合料.热拌沥青实验方法.第49部分:抛光后摩擦的测定

This European Standard describes a test method to determine the friction at 60 km/h after polishing during a fixed number of passes on surfaces of bituminous mixtures samples. The samples used are either produced in a laboratory or are cores taken from the site. NOTE This procedure was previously known as Wehner and Schulze method (see [1]).

Bituminous mixtures - Test methods for hot mix asphalt - Part 49: Determination of friction after polishing

GOST 32871-2014 一般用途汽车道路. 沥青胶粘剂. 技术要求

Automobile roads of general use. Pipe road culverts. Technical requirements

KS F 2382-2013 沥青混合物间接拉伸强度测试方法

이 표준은 아스팔트 포장용 혼합물의 원주형 공시체에 대한 간접 인장강도 측정 방법에 대하여 규정한다.

Standard test method for indirect tension of asphalt mixtures

KS F 2383-2013 乳化[石油]沥青漂浮测试方法

이 표준은 아스팔트 흐름 거동이나 굳기를 측정하는 시험방법에 대하여 규정한다.

Standard test method for float test for asphalt