Q73 金属构配件 标准查询与下载

JG/T 234-2008 建筑装饰用搪瓷钢板

本标准规定了建筑装饰用搪瓷钢板的术语和定义、分类和标记、材料、要求、试验方法、检验规则和标志、包装、运输、贮存等。 本标准适用于建筑内、外装饰用搪瓷钢板。

Porcelain enameling steel panels for building

NF P84-206-2:2008 建筑工程.带防水涂层的有槽金属板屋顶.第2部分:专用管理模型条款的合同单

Building works - Grooved sheet metal roofing with waterproof coating - Part 2 : contract bill of special administrative model clauses.

JIS A 6507 AMD 1:2008 建筑构件(钢制地板)(修改件1)

Building components (Steel panel for floor) (Amendment 1)

JIS A 6518 AMD 1:2008 铁丝网栏栅的组件(修改件1)

Components for wire net fences (Amendment 1)

JIS A 4802 AMD 1:2008 窗帘用导轨(金属)(修改件1)

Curtain rails (Metal) (Amendment 1)

JIS A 4801 AMD 1:2008 钢及铝合金活动百页窗(修改件1)

This standard is an Amendment of Steel and aluminium alloy venetian blinds.

Steel and aluminium alloy venetian blinds (Amendment 1)

JIS A 5524 AMD 1:2008 抹灰用金属网片(修改件1)

This translation has been made based on the Amendment to the origi- nal Japanese Industrial Standard revised by the Minister of Economy. Trade and Industry through deliberations at the Japanese Industrial Standards Committee as the result of proposal for revision of Japanese Industrial Standard with the draft being attached, based on the provi- sion of Article 12 Clause i of the Industrial Standardization Law ap- plicable to the case of revision by the provision of Article 14. Consequently, JIS A 5524:1994 is partially replaced with this Amend- ment.

Lath sheets (Amendment 1)

ANSI/TPI 1-2007 连接木框架结构的金属板的国家设计标准

This standard establishes minimum requirements for the design and construction of metal plate connected wood trusses and describes the materials used in a truss, both lumber and steel, and design procedures for truss members and joints. Responsibilities, methods for evaluating the metal connector plates, and manufacturing quality assurance are also contained in this standard. See the 3rd Public Review form available at www.tpinst.org/my TPI1PC.htm for specific sections being reviewed.

National Design Standard for Metal Plate Connected Wood

SANS 190-2:2008 网形铁．第2部分：建筑产品

Covers 8 types of building product made from expanded metal and intended for use as a plaster base or as a reinforcing medium for brickwork.

Expanded metal Part 2: Building products

SANS 190-1:2008 网形铁．第1部分：钢片和钢板

Covers expanded metal sheets or plates for general use.

Expanded metal Part 1: Sheets and plates

ASTM C1007-08a 承重(横向和轴向)钢骨及有关附件安装的标准规范

1.1 This specification covers the installation and erection requirements for load bearing (transverse and axial) steel studs and related accessories 0.0329 in. (0.836 mm) to 0.1120 in. (2.845 mm) thick. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

Standard Specification for Installation of Load Bearing (Transverse and Axial) Steel Studs and Related Accessories

KS F 4569-2007 道路用底灰骨料

이 규격은 도로의 동상방지층 및 보조기층에 사용되는 도로용 바텀애시 골재1)에 대하여 규정

Bottom ash aggregate for road construction

KS F 4530-2007 黄铜金属细木工

이 규격은 콘크리트 바탕 인조석 깔기 마감에 사용하는 황동제 줄눈대(이하 줄눈대라 한다.)

Brass jointer

KS F 4531-2007 排水阀

이 규격은 건축물에 사용하는 생활 하수 및 공장 용수 처리의 오물 찌꺼기 거름 배수전에 대

Drain cock

KS F 4527-2007 黄铜防滑器

이 규격은 콘크리트 계단 디딤면에 사용하는 황동제 논슬립(이하 논슬립이라 한다.)에 대하여

Brass non-slip

KS F 4525-2007 钢门用配件

이 규격은 KS F 3109에 규정하는 강철제 문에 사용하는 철물(이하 철물이라 한다.)

Fittings for steel door

NF A35-017:2007 混凝土加固用钢材.不可焊的带肋钢筋和卷材

Steels for concrete reinforcement - Non weldable ribbed bars and coils.

NF A35-030:2007 钢制品.混凝土电杆、架空线路支架用高粘结性的带肋钢筋

Steel products - High-bond ribbed steel bars for concrete poles, supports for over head lines.

JIS A 6604 ERRATUM 1:2007 勘误表

ERRATUM

KS F 2290-2007 住宅管道模块配合尺寸

이 규격은 주택에 사용되는 배관1) 유닛2)(이하 유닛이라 한다.)의 모듈 호칭 치수3)에

Modular co-ordinating sizes of piping unit for dwellings