S11 线路构件 标准查询与下载

TB/T 3065.1-2002 弹条Ⅱ型扣件.第1部分:组装与配置

本标准规定了弹条I型扣件(以下简称扣件)的组装和配置。 本标准适用于标准轨距铁路直线及曲线半径不小于300m线路上联接60kg/m钢轨与混凝土枕，最大调高量为10mm的弹条Ⅱ型扣件。

Spring clip-Ⅱ fastenings Part 1:Assembling and configure

TB/T 3065.2-2002 弹条Ⅱ型扣件.第2部分:弹条

本标准规定了弹条I型扣件弹条的技术要求、试验方法、检验规则、包装与标志。 本标准适用于弹条I型扣件弹条。

Spring clip-Ⅱ fastenings Part 2:Spring clip

TB/T 2190-2002 预应力混凝土枕.Ⅰ型、Ⅱ型及Ⅲ型

本标准规定了先张法预应力混凝土枕的技术要求、试验方法、检验规则、标志和证明书、存放和运输。 本标准适用于标准轨距铁路用Iot.I型及In型预应力混凝土枕(以下简称Ⅰ型枕,Ⅱ型枕、Ⅲ型枕或轨枕)。 其他种类轨枕也可参照使用本标准。

Prestressed concrete sleeper Type Ⅰ、Ⅱ and Ⅲ

DIN EN 13146-6:2002 轨道交通.轨道.紧固系统的试验方法.第6部分:恶劣环境条件的影响; 德文版本 EN 13146-6:2002

Railway applications - Track; Test methods for fastening systems - Part 6: Effect of severe environmental conditions; German version EN 13146-6:2002

BS EN 13146-8:2002 轨道交通.轨道.紧固系统的试验方法.使用中的试验

This Part of this European Standard specifies a procedure for the comparative testing of fastening systems in track. The test procedure is applicable to fastening systems which in all other respects comply with prEN 13481 Parts 2 to 7. This test applies to complete fastening assemblies. It is only to be used for comparative testing of such fastening systems installed at the same time on the type of support for which they are intended.

Railway applications - Track - Test methods for fastening systems - In service testing

BS EN 13481-1:2002 轨道交通.轨道.紧固件系统的性能要求.定义

This European Standard defines the terms and definitions used in prEN 13146 and in EN 13481.

Railway applications - Track - Performance requirements for fastening systems - Definitions

BS EN 13481-5:2002 轨道交通.轨道.紧固件系统的性能要求.厚板轨道的紧固系统

This European Standard is applicable to fastening systems for use in attaching rails to the uppermost surface of concrete or asphalt slabs in non-ballasted track construction as follows: ??main lines having radius of curvature greater than 150 m and subject to maximum design axle load of 260 kN; ??light rail systems having a radius of curvature greater than 40 m and subject to a maximum design axle load of 130 kN. This includes fastening systems for floating slabs but does not include fastening systems for embedded rails. The requirements apply to the following: a) direct fastening systems; b) indirect fastening systems; c) fastening systems for the rail sections in EN 13674-1 and EN 13674-4 ; d) fastening systems which incorporate concrete elements which each have not more than one supporting element per rail. In the case of (d) the concrete element is considered to be part of the fastening system. If the system includes concrete elements which each have more than one supporting location per rail, those concrete elements are considered to be part of the slab and not part of the fastening system. This standard is not applicable to special fastening systems used at bolted joints. This standard is for type approval of a complete fastening assembly only.

Railway applications - Track - Performance requirements for fastening systems - Fastening systems for slab track

BS EN 13481-2:2002 轨道交通.轨道.紧固件系统的性能要求.混凝土轨枕的紧固系统

This European Standard is applicable to fastening systems for use on concrete sleepers in ballasted track as follows: ? main lines having a radius of curvature greater than 150 m and subject to a maximum design axle load of 260 kN; ? light rail systems having a radius of curvature greater than 80 m and subject to a maximum design axle load of 130 kN. The requirements apply to: ? direct fastening systems and systems which incorporate a baseplate; ? fastening systems for the rail sections in !EN 13674-1 and EN 13674-4." This standard is not applicable to fastening systems for other rail sections, rigid fastening systems or special fastening systems used at bolted joints. This standard is for type approval of a complete fastening assembly only.

Railway applications - Track - Performance requirements for fastening systems - Fastening systems for concrete sleepers

BS EN 13481-3:2002 轨道交通.轨道.紧固件系统的性能要求.木质轨枕的紧固件系统

This European Standard is applicable to fastening systems for use on wood sleepers in ballasted track as follows: ? main lines having a radius of curvature greater than 150 m and subject to a maximum design axle load of 260kN; ? light rail systems having a radius of curvature greater than 80 m and subject to a maximum design axle load of 130 kN. The requirements apply to: ? direct fastening systems and systems which incorporate a baseplate; ? fastening systems for the rail sections in prEN 13674-1 and prEN 13674-4. This standard is not applicable to fastening systems for other rail sections, rigid fastening systems or special fastening systems used at bolted joints. This standard is for type approval of a complete fastening assembly only.

Railway applications - Track - Performance requirements for fastening systems - Fastening systems for wood sleepers

BS EN 13481-4:2002 轨道交通.轨道.紧固件系统的性能要求.钢轨枕的紧固件系统

This European Standard is applicable to fastening systems for use on steel sleepers in ballasted track as follows: — main lines having a radius of curvature greater than 150 m and subject to a maximum design axle load of 260 kN; — light rail systems having a radius of curvature greater than 80 m and subject to a maximum design axle load of 130 kN. The requirements apply to: — direct fastening systems and systems which incorporate a baseplate; — fastening systems for the rail sections in prEN 13674-1 and prEN 13674-4. This standard is not applicable to fastening systems for other rail sections, rigid fastening systems or special fastening systems used at bolted joints. This standard is for type approval of a complete fastening assembly only.

Railway applications - Track - Performance requirements for fastening systems - Fastening systems for steel sleepers

BS EN 13146-6:2002 轨道交通.轨道.紧固件系统的试验方法.严酷环境条件的影响

This European Standard specifies a laboratory test procedure for finding the effect of exposure to severe environmental conditions on the fastening system. This test procedure applies to a complete fastening assembly.

Railway applications - Track - Test methods for fastening systems - Effect of severe environmental conditions

TB/T 2093-2002 吸水式锚固包技术条件

本标准规定了吸水式锚固包的品种及规格、技术性能、试验方法和检验规则等。 本标准适用于铁路隧道等地下工程锚杆施工和结构物补强加固、建筑安装、设备固定以及文物保护，用的吸水式锚固包。

Technical conditions of water-absorbing anchor pack

TB/T 3054-2002 铁路混凝土工程预防碱-骨料反应技术条件

本标准规定了铁路混凝土工程预防碱一骨料反应的原材料检验程序、工程分类和预防措施。 本标准适用于铁路工程的混凝土结构和混凝土制品。

Technical conditions for prevention of alkali-aggregate reaction in railway concrete engineering

TB/T 1879-2002 预应力混凝土枕静载抗裂试验方法

本标准规定了标准轨距铁路预应力混凝土枕(含岔枕、宽枕、桥枕)静载抗裂试验方法。 本标准适用于标准轨距铁路预应力混凝土枕(含岔枕、宽枕、桥枕)科学研究、新产品开发及产品质量检验的静载抗裂试验。

Static load cracking test method for prestressed concrete pillows

TB/T 2922.5-2002 铁路混凝土用骨料碱活性试验方法 快速砂浆棒法

本标准规定了采用快速砂浆棒法检验铁路混凝土用骨料碱活性的取样方法、仪器设备、试验程序以及结果处理方法等。 本标准适用于评定硅质骨料的碱一硅酸反应活性，亦可用于评定碳酸盐骨料中硅质组分的碱-硅酸反应活性。

Test method for alkali activity of aggregates used in railway concrete - rapid mortar rod method

TB/T 1878-2002 预应力混凝土枕疲劳试验方法

本标准规定了标准轨距铁路预应力混凝土枕(含岔枕、宽枕、桥枕)的疲劳试验方法。 本标准适用于标准轨距铁路预应力混凝土枕(含岔枕、宽枕、桥枕)科学研究、新产品开发及产品质量检验的疲劳试验。

Fatigue test method for prestressed concrete sleepers

TB/T 2329-2002 弹条Ⅰ型、Ⅱ型扣件弹条疲劳试验方法

本标准规定了弹条的疲劳试验方法。 本标准适用于干线铁路弹条工型扣件A,B型弹条及弹条I型扣件弹条的疲劳试验。

Fatigue test method for clips of type I and type II fasteners

TB/T 1631-2002 钢轨电弧焊补技术条件

本标准规定了钢轨焊补用手工焊条、自保护药芯焊丝(以下简称焊条和焊丝)、焊补设备等的要求、试验方法、检验规则等内容。 本标准适用于钢轨出现的表面擦伤、低塌(包括焊缝低塌)、磨耗以及轨端(包括淬火和未淬火)剥落掉块时的电弧焊补。

Rail arc welding technical conditions

TB/T 3049-2002 螺纹道钉

screw spike

TB/T 3012-2001 铁道货车铸钢摇枕、侧架采购与验收技术条件

本标准规定了铁道货车用铸钢侧架和摇枕的技术要求和检查要求。 本标准适用于铁道货车用铸钢侧架和摇枕的采购与验收。

Specifications for procurement and acceptance of cast steel bolsters and side frames for railway freight cars