S35 牵引电气设备 标准查询与下载

DIN EN 61377-3:2003 轨道交通.铁路车辆.第3部分:间接变流器供电的交流电动机及其控制系统的组合测试

Railway applications - Rolling stock - Part 3: Combined testing of alternating current motors, fed by an indirect convertor, and their control systems (IEC 61377-3:2002); German version EN 61377-3:2002

BS EN 50329:2003 轨道交通.固定式装置.牵引变压器

This European Standard covers specific characteristics of traction transformers as defined in 1.3.1, used in traction substation or along the track for the supply of power to a.c. and d.c. traction systems or to provide power to auxiliary services. Traction transformers are either -single-phase traction transformers, -single-, three- or poly-phase rectifier-transformers or converter/inverter-transformers for d.c. or a.c. contact line, -single phase auto-transformers for traction power supply, -single- or three-phase auxiliary transformers at traction supply voltage. Transformers feeding a.c. contact lines are covered by EN 60076. Dry-type transformers are covered by HD 464. These standards are valid with the additional requirements given in this document. For transformers feeding contact lines through static converters EN 61378-1 may assist, but modified or additional requirements are given in this document. NOTE Transformers mounted on-board traction vehicles are covered by EN 60310 and are excluded from the scope of this document. Electromagnetic compatibility is ruled by EN 60076-1 which states that a transformer may be considered a passive element in this respect. Some accessories however are subject to EMC requirements and shall comply with EN 50121-5.

Railway applications - Fixed installations - Traction transformers

BS EN 50386:2002 充液变压器用1KV以下和250A至5KA的套管

This standard is applicable to ceramic insulated bushings for rated voltages up to 1 000 V, rated currents from 250 A up to 5 000 A and frequencies from 15 Hz up to 60 Hz for insulating liquid filled transformers. NOTE These bushings are suitable for operation at 1,1 kV in compliance with HD 428.1 S1.

Bushings up to 1 kV and from 250 A to 5 kA, for liquid filled transformers

BS EN 50328:2003 轨道交通.固定式装置.变电站用电子功率变换器

This European Standard specifies the requirements for the performance of all fixed installations electronic power converters, using controllable and/or non-controllable electronic valves, intended for traction power supply. The devices can be controlled by means of current, voltage or light. Non-bistable devices are assumed to be operated in the switched mode. This European Standard applies to fixed installations of following electric traction systems: - railways, - guided mass transport systems such as: tramways, light rail systems, elevated and underground railways, mountain railways, trolleybusses. This European Standard does not apply to - cranes, transportable platforms and similar transportation equipment on rails, - suspended cable cars, - funicular railways. This European Standard applies to diode rectifiers, controlled rectifiers, inverters and frequency converters. The equipment covered in this European Standard is the converter itself.

Railway applications - Fixed installations - Electronic power convertors for substations

BS EN 50387:2003 充液变压器用1KV以下和125A至5KA的母线套管

This standard is applicable to moulded indoor busbar bushings for rated voltages up to 1 000 V, rated currents from 1 250 A up to 5 000 A and frequencies from 15 Hz up to 60 Hz for insulating liquid filled transformers. NOTE These bushings are suitable for operation at 1,1 kV in compliance with HD 428.1 S1.

Busbar bushings up to 1 kV and from 1,25 kA to 5 kA, for liquid filled transformers

BS EN 50327:2003 轨道交通.固定式装置.变流器组额定值和变流器组试验的一致性

This European Standard provides requirements for some type tests which are significant only when made on the entire group. It provides also a basic relationship between compatible ratings of traction transformer and converter(s), in order to provide minimum requirements for the choice of their ratings. Moreover it gives the minimum values to be considered in order to choose switching devices with characteristics suitable for the converter group(s) involved. Annexes provide useful information as a guide for the group designer. Table 1 indicates the components of a converter group and the relevant applicable standards.

Railway applications - Fixed installations - Harmonisation of the rated values for converter groups and tests on converter groups

BS EN 50123-7-1:2003 轨道交通.固定设备.直流开关设备.直流牵引系统专用测量、控制与保护装置.应用指南

To be read in conjunction with BS EN 50123-1:2003

Railway applications - Fixed installations - d.c. switchgear - Measurement, control and protection devices for specific use in d.c. traction systems - Measurement, control and protection devices for specific use in d.c. traction systems - Application guid

BS EN 50123-1:2003 轨道交通.固定设备.直流开关装置.总则

The EN 50123 series specifies requirements for d.c. switchgear and controlgear and is intended to be used in fixed electrical installations with nominal voltage not exceeding 3 000 V d.c, which supply electrical power to vehicles for public guided transport, i.e. railway vehicles, tramway vehicles, underground vehicles and trolley-buses. Part 1 specifies general requirements. The other parts are covering Part 2 D.C. circuit breakers, Part 3 Indoor d.c. disconnectors, switch-disconnectors and earthing switches, Part 4 Outdoor d.c. disconnectors, switch-disconnectors and earthing switches, Part 5 Surge arresters and low voltage limiters for specific use in d.c. systems, Part 6 D.C. switchgear assemblies, Part 7-1 Measurement, control and protection devices for specific use in d.c. traction systems -Application guide, Part 7-2 Measurement, control and protection devices for specific use in d.c. traction systems -Isolating current transducers and other current measuring devices, Part 7-3 Measurement, control and protection devices for specific use in d.c. traction systems -Isolating voltage transducers and other voltage measuring devices

Railway applications. Fixed installations. D.C. switchgear. General

BS EN 50123-2:2003 轨道交通.固定设备.直流开关装置.直流断路器

To be read in conjunction with BS EN 50123-1:2003

Railway applications - Fixed installations - D.C. switchgear - D. C. circuit breakers

BS EN 50123-7-3:2003 轨道交通.固定设备.直流开关装置.直流牵引系统专用测量、控制和保护设备.绝缘电压传感器和其他电压测量设备

To be read in conjunction with BS EN 50123-1:2003

Railway applications - Fixed installations - d.c. switchgear - Measurement, control and protection devices for specific use in d.c. traction systems - Isolating voltage transducers and other voltage measuring devices

BS EN 50123-7-2:2003 轨道交通.固定设备.直流开关装置.直流牵引系统专用测量、控制和保护设备.绝缘电流传感器和其他电流测量设备

To be read in conjunction with BS EN 50123-1:2003

Railway applications - Fixed installations - d.c. switchgear - Measurement, control and protection devices for specific use in d.c. traction systems - Isolating current transducers and other current measuring devices

BS EN 50123-3:2003+A1:2013 轨道交通.固定装置.直流开关装置.室内直流切断开关、负荷开关和接地开关

Railway applications - Fixed installations - D.C. switchgear - Indoor d.c. disconnectors, switch-disconnectors and earthing switches

BS EN 50123-5:2003 轨道交通.固定设备.直流开关装置.直流系统中特殊应用的电涌放电器和低电压限制器

To be read in conjunction with BS EN 50123-1:2003, BS EN 60099-1:1994, BS EN 60099-4:1993

Railway applications. Fixed installations. D.C. switchgear. Surge arresters and low-voltage limiters for specific use in d.c. systems

BS EN 50123-4:2003 轨道交通.固定设备.直流开关装置.室外直流切断开关、负荷开关和接地开关

To be read in conjunction with BS EN 50123-1:2003

Railway applications - Fixed installations - D.C. switchgear - Outdoor d.c. disconnectors, switch-disconnectors and earthing switches

BS EN 50123-6:2003 轨道交通.固定设备.直流开关装置.直流开关装置组件

To be read in conjunction with BS EN 50123-1:2003

Railway applications - Fixed installations - D.C. switchgear - D. C. switchgear assemblies

BS EN 50123-3:2003 轨道交通.固定设备.直流开关装置.室内直流切断开关、负荷开关和接地开关

To be read in conjunction with BS EN 50123-1:2003

Railway applications - Fixed installations - D.C. switchgear - Indoor d.c. disconnectors, switch-disconnectors and earthing switches

BS EN 60077-4:2003 轨道交通.机车车辆用电气设备.电工元件.交流断路器规则

To be read in conjunction with BS EN 60077-1

Railway applications - Electric equipment for rolling stock - Electrotechnical components - Rules for AC circuit-breakers

DIN EN 50125-2:2003 轨道交通.设备环境条件.第2部分:固定电力设备

Railway applications - Environmental conditions for equipment - Part 2: Fixed electrical installations; German version EN 50125-2:2002

DIN EN 50153:2003 轨道交通.铁路车辆.电器意外的防护规定

Railway applications - Rolling stock - Protective provisions relating to electrical hazards; German version EN 50153:2002

DIN EN 61377-2:2003 轨道交通.机车车辆.联合试验.第2部分:反向直流牵引电动机及其控制设备

Railway applications - Rolling stock; Combined testing - Part 2: Chopper-fed direct current traction motors and their control (IEC 61377-2:2002); German version EN 61377-2:2002