T38 照明与信号设备 标准查询与下载

KS C IEC 60810:2005 道路车辆用灯.性能要求

이 규격은 도로 차량용 전조등, 안개등과 기타 신호용 조명 장치 등에 사용하는 교체 가능한

Lamps for road vehicles-Performance requirements

SAE J96-2005 工业设备用闪烁警示灯

This SAE Standard provides performance and general design requirements and related test procedures for headlamps for use on industrial wheeled equipment that may be operated on public roads.

Flashing Warning Lamp for Industrial Equipment

SAE J2009-2005 前照放电系统和子系统

This SAE Recommended Practice applies to motor vehicle forward illumination systems and subsystems generated by discharge sources. It provides test methods, requirements, and guidelines applicable to the special characteristics of gaseous discharge lighting devices which supplement those required for forward illumination systems using incandescent light sources. The document is applicable to both discharge forward lighting systems, subsystems and components. This document is intended to be a guide to standard practice and is subject to change to reflect additional experience and technical advances.

Discharge Forward Lighting System and Subsystems

SAE J593-2005 倒车灯

This SAE Standard provides installation requirements, test procedures, design guidelines and performance requirements for backup/reversing lamp.

Backup Lamp (Reversing Lamp)

SAE J2650-2005 道路照明装置系统发光二极管的性能要求

This SAE Recommended Practice provides performance requirements, test procedures, and design and installation guidelines for road illumination devices that incorporate light emitting diode (LED) modules. These requirements are in addition to those specified for devices deisnged with light sources other than LED sources.

Performance Requirements for Light Emitting Diode (LED) Road Illumination Device Systems

SAE J583-2005 前雾灯

This SAE Standard provides test procedures, performance requirements, design guidelines and installation guidelines for front fog lamps.

Front Fog Lamps

SAE J592-2005 全宽小于2032mm的道路车辆用边侧标志灯

This SAE Standard provides test procedures, requirements, and guidelines for sidemarker lamps for vehicles less than 2032 mm in overall width.

Sidemarker Lamps for Use on Road Vehicles Less Than 2032 mm in Overall Width

DLA MS90308 REV C-2005 反复照亮型微型指示灯

DIMENSIONS IN INCHES, UNLESS OTHERWISE SPECIFIED, TOLERANCES: DECIMALS: 2 PLACE ±.01, 3 PLACE ±.005.

LIGHT, INDICATOR, SUBMINIATURE, RELAMPABLE

SANS 20087:2005 机动车白天行车灯认证的统一规定

Applies to lamps intended to increase conspicuity of a vehicle in daylight.

Uniform provisions concerning the approval of daytime running lamps for power-driven vehicles

SAE J1319-2005 尾部雾灯(后端雾灯)系统

This SAE Recommended Practice provides test procedures, requirements, and guidelines for fog tail lamp systems.

Fog Tail Lamp (Rear Fog Light) Systems

ISO 2575:2004/Amd 1:2005 道路车辆.操纵件、指示器和信号装置的符号.修改件1

This is Amendment 1 to ISO 2575-2004 (Road vehicles — Symbols for controls, indicators and tell-tales)

Road vehicles - Symbols for controls, indicators and tell-tales; Amendment 1

SANS 20053:2005 关于就灯光及信号装置的安装方面批准L3类车辆的统一规定

Applies to the approval of lighting installations of two-wheeled power-driven vehicles without side-car, having a maximum design speed exceeding 50 km/h and/or a cylinder capacity exceeding 50 cubic centimetres.

Uniform provisions concerning the approval of category L3 vehicles with regard to the installation of lighting and light-signalling devices

UL 234-2005 娱乐车用低压照明装置

1.1 These requirements apply to incandescent and fluorescent low-voltage luminaires, rated 24 volts or less, of the surface mounted or recessed type intended for permanent installation in recreational vehicles in accordance with Article 551 of the National Electrical Code, NFPA 70. 1.2 These requirements do not apply to running or clearance lights intended to be mounted on the exterior of a recreational vehicle. This new edition of ANSI/UL 234 is issued to update the title of the standard and to replace the terminology from "fixure" to "luminaires." This new edition also includes a clarification of the flammability rating.

UL Standard for Safety Low Voltage Lighting Fixtures for Use in Recreational Vehicles Fifth Edition; Reprint with revisions through and including October 31, 2007

ANSI/UL 234-2005 供游乐车辆使用的低压照明装置的安全性标准

This bulletin contains substantive changes to UL 234 based on comments received to the ballot of the proposed Fifth Edition, bulletin dated March 19, 2004.

Standard for Safety for Low Voltage Lighting Fixtures for Use in Recreational Vehicles

BS ISO 4148:2004 道路车辆.专用警示信号灯.尺寸

This International Standard specifies the dimensions of special warning lamps for road vehicles, in order to ensure interchangeability and accurate positioning, bearing in mind the rapid change of light intensity from such devices in a vertical cross-section of the projected beam. It also specifies (see Annex A) methods for testing the magnetic-base mountings used to install special warning lamps directly on the steel sheet of the roof or body of a vehicle (special warning lamps of Category D). NOTE In certain countries and international bodies, the term “light” is sometimes used instead of “lamp”.

Road vehicles - Special warning lamps - Dimensions

NF R13-629/A3:2004 道路车辆用灯.尺寸、电和照明要求

Lamps for road vehicles - Dimensional, electrical and luminous requirements.

ISO 4148:2004 道路车辆.专用警示信号灯.尺寸

This International Standard specifies the dimensions of special warning lamps for road vehicles, in order to ensure interchangeability and accurate positioning, bearing in mind the rapid change of light intensity from such devices in a vertical cross-section of the projected beam. It also specifies (see Annex A) methods for testing the magnetic-base mountings used to install special warning lamps directly on the steel sheet of the roof or body of a vehicle (special warning lamps of Category D). NOTE In certain countries and international bodies, the term “light” is sometimes used instead of “lamp”.

Road vehicles - Special warning lamps - Dimensions

ISO 7227:1987/Amd 1:2004 道路车辆.照明和光信号装置.词汇.修改件1

This is Amendment 1 to ISO 7227-1987 (Road vehicles — Lighting and lightsignalling devices — VocabularyAMENDMENT 1 )

Road vehicles - Lighting and light signalling devices - Vocabulary; Amendment 1

SANS 20008:2004 关于批准发射非对称近光或远光或两者兼有装有卤素灯（H1，H2，H3，HB3，HB4和/或H7）的机动车前照灯的统一规定

Applies to the motor vehicle headlamps which may incorporate lenses of glass or plastic material.

Uniform provisions concerning the approval of motor vehicle headlamps emitting an asymmetrical passing beam or a driving beam or both and equipped with halogen filament lamps (H1, H2, H3, HB3, HB4, H7, H8, H9, HIR1, HIR2 and/or H11)

SAE J2498-2004 应急车辆用警告灯系统的最低性能

This SAE Recommended Practice provides test procedures, requirements, and guidelines for the system of optical warning devices used on emergency vehicles.

Minimum Performance of the Warning Light System Used on Emergency Vehicles