T40 汽车综合 标准查询与下载



共找到 233 条与 汽车综合 相关的标准,共 16

Terminology and commercial specification on off-highway dump trucks

ICS
01.040.43;43.080.10
CCS
T40
发布
1991-08-01
实施
1991-08-01

本标准所确定地燃料消耗量是汽车运行燃料消耗量地最高限额

car running fuel consumption

ICS
43.020
CCS
T40
发布
1990-09-15
实施
1990-09-15

The facilities used by domestic automotive manufacturers to provide accelerated corrosion aging of complete vehicles are described in general. The types of vehicles tested, general test methodology, and techniques used to determine test-to-field correlation are discussed. The different procedures used throughout the industry produce different results on various vehicle coatings, components, and systems. The key to successful interpretation of test results is a thorough understanding of the corrosion mechanisms involved and the effects of test limitations on these mechanisms. The purpose of this information report is to provide a general overview of some proving ground procedures and facilities used in the United States to evaluate the corrosion protection performance of vehicles. Because of limitations involved with any accelerated testing procedure, and despite the use of complete vehicles and attempts to make test environments all-inclusive, test results require knowledgeable interpretation. Proving grounds are, in effect, large laboratories. As with different laboratory test procedures, different test techniques will produce different results. Consideration of the various techniques and analysis tools discussed in the following sections may give the reader an understanding of the environments that vehicles must be designed to survive and may aid in the further development of accelerated corrosion tests.

Proving Ground Vehicle Corrosion Testing, Information Report May 1989

ICS
43.040.60;77.060
CCS
T40
发布
1989-05-01
实施
2016-04-07

This standard specifies test methods to determine transient response behaviour of passenger cars. The open-loop-manoeuvres specified in these test methods are not representative of real driving conditions but are useful to obtain measures of vehicle transient behaviour in response to several specific types of steering input under closely controlled test conditions.

Road vehicles; lateral transient response test methods; identical with ISO 7401:1988

ICS
43.020
CCS
T40
发布
1989-04
实施

Road vehicles; lateral transient response tests methods

ICS
4932
CCS
T40
发布
1988-05
实施
1988-05-01

Specifies the dimensions of nozzle spouts on pumps for refuelling road vehicles, and their filling rates. Applies to nozzle spouts for leaded gasoline and diesel fuel for road vehicles. The figure shows a nozzle spout with a spring for safe hooking in the tank filler opening. The dimensions apply also to nozzle spouts with cams or depressions for safe hooking.

Road vehicles; nozzle spouts for leaded gasoline and diesel fuel

ICS
43.060.40
CCS
T40
发布
1988-04
实施
1988-04-01

Specifies test methods and general requirements for the determination of the electrical characteristic data of alternators for road vehicles. Applies to alternators, cooled according to the manufacturer's instructions, mounted on internal combustion engines. Figure 1 shows a diagram for alternator testing.

Road vehicles; alternators with regulators; test methods and general requirements

ICS
43.040.10
CCS
T40
发布
1988-01
实施
1988-01-15

この規格は,自動車の運行試験方法について規定する。

Driving test method of automobiles

ICS
43.020
CCS
T40
发布
1982-03-01
实施

The objective of this recommended practice is to provide a standard wind tunnel testing procedure for heavy duty trucks and buses. The use of this procedure should improve the comparability of aerodynamic data taken in different wind tunnels and should ensure that good data quality is obtained. The scope of this recommended practice is sufficiently broad that it can encompass the full range of current heavy duty vehicles, vehicle modifications, and prototype configurations. The test procedure describes methods for examination of the vehicle's flow field using surface pressures and flow visualization.

SAE Wind Tunnel Test Procedure for Trucks and Buses

ICS
43.080.01;43.180
CCS
T40
发布
1981-07-01
实施
1981-01-01

Clés pour bougies M 14 X 1,25 à siège conique

ICS
43.180;25.140.30
CCS
T40
发布
1977-01-01
实施
1977-01-20

Operation and maintenance management service specification for bus charging stations

ICS
CCS
T40
发布
实施

Pour Construction Automobile

ICS
CCS
T40
发布
实施

本标准规定了飞机液压滤油动力车(以下简称液滤车)的技术要求、试验方法、检验规则和标志、包装、运输、贮存等内容。   本标准适用于大型民航飞机地面用的液压滤油动力车

General technical requirements for hydraulic oil filter powered vehicles

ICS
CCS
T40
发布
实施



Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号