共找到 514 条与 救生设备 相关的标准,共 35 页
This specification covers detail instructions relative to the dimensions, tolerances,repair procedures and other specific manufacturing instructions to be used in the assembly of personnel parachutes. The personnel parachutes covered include the chest, seat, back, troop,training, rescue, integrated, maneuverable, and special purpose.
PARACHUTES, PERSONNEL, DETAIL MANUFACTURING INSTRUCTIONS FOR
This specification covers searchlights for motor lifeboats. The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only. The following precautionary caveat pertains only to the test method portion, Section 7, of this specification: This standard does not purport to address all of the safety concerns associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Specification for Searchlights on Motor Lifeboats
This standard establishes the inspection requirements and a standard classification of manufacturing and final assembly defects for parachutes.
INSPECTION REQUIREMENTS, DEFINITIONS AND CLASSIFICATION OF DEFECTS FOR PARACHUTES
Effective 22 april 1998, MIL-L-24489C, has been declared “Inactive for New Design” with no superseding specification. This is applicable on all acquisitions to which MIL-L-24489C is applied.
LIFEBOAT, INFLATABLE, MARK 6, 25-PERSON CAPACITY
本标准规定了舰船烟幕弹《以下简称烟幕弹)的眉求、質量保証規定和交貨准備。 本标准适用于烟幕弹的研制、生产和验收。 2 引用标准
General specification for shipborne smoke rocket and grenade
The margins of this amendment are marked with asterisks to indicate where changes from the previous amendment were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous amendment.
VALVE, INFLATION, LIFE RAFT, FLU-6/P
Marine buoyant devices
Marine buoyant devices
This International Standard specifies the minimum requirements for coated fabrics, and test procedures for those fabrics, for use in the construction of inflatable chambers of rescue boats complying with the 1974 Safety of Life at Sea Convention (SOLAS), as amended; Chapter I, paragraph 1.2, and Chapter V of the International Life-Saving Appliance Code [IMO Resolution MSC.48 (66)]; and the IMO Assembly resolution A.689(17), as amended. These coated fabrics consist of a base textile with a synthetic elastomeric or plastomeric compound applied to one or both faces. Requirements for fabrics for inflatable boats other than SOLAS rescue boats are contained in ISO 6185:1982, Shipbuilding and marine structures — Inflatable boats — Boats made of reinforced elastomers or plastomers.
Ships and marine technology - Inflatable rescue boats - Coated fabrics for inflatable chambers
This standard specifies functional and safety requirements for depth gauges, depth gauge features of other instruments, and both depth and time measurement features of other instruments. This standard is not applicable to any information displayed to the user besides depth and time. Any information on decompression obligations displayed by equipment covered by this standard is explicitly excluded from its scope. This standard is applicable to instruments measuring water depth by the environmental pressure as used by divers. Requirements for time measurement are only applicable if instruments are automatically counting the dive time.
Diving accessories - Depth gauges and combined depth and time measuring devices - Functional and safety requirements, test methods
This list has been prepared for use by or for the Government in the acquisition of products covered by the subject specification and such listing of a product is not intended to and does not connote endorsement of the product by the Department of Defense.
LIFE RAFTS, INFLATABLE, 4 AND 7 MAN, FOR AIRCRAFT USE
LIFE RAFT, INFLATABLE, ONE MAN VEE BOTTOM LRU-18/U
LIFE RAFT, INFLATABLE, ONE MAN VEE BOTTOM LRU-18/U
This list has been prepared for use by or for the Government in the acquisition of products covered by the subject specification and such listing of a product is not intended to and does not connote endorsement of the product by the Department of Defense. All products listed herein have been qualified under the requirements for the product as specified in the latest effective issue of the applicable specification. This list is subject to change without notice; revision or amendment of this list will be issued as necessary. The listing of a product does not release or otherwise affect the obligation of the manufacturer to comply with the specification requirements.
LIFE RAFTS, INFLATABLE, TWENTY MAN
This European Standard applies to self-contained open-circuit compressed air underwater breathing apparatus and their sub-assemblies. The object of the requirements and tests set out in this European Standard is to ensure a minimum level of safe operation for apparatus down to a maximum depth of 50 m. Laboratory and practical performance tests are included for the assessment of compliance with the requirements.
Respiratory equipment - Open-circuit self-contained compressed air diving apparatus - Requirements, testing, marking
This notice should be filed in fiont of MIL-C-43647, dated 18 June 1969. MIL-C-43647 is inactive for new design and is no longer used, except for replacement purposes.
CASE, INDIVIDUAL, SURVIVAL KIT, ARMY
MIL-R-43608A, dated 10 September 1990, is inactive for new design and is no longer used, except for replacement purposes.
RIP CORD, PARACHUTE, PERSONNEL: GENERAL SPECIFICATION FOR
This amendment forms a part of MlL-L-S1561G(AS), dated O1 June 1994, and is approved for use by the Naval Air Systems Command, Department of the Navy and is available for use by all Departments and Agencies of the Department of Defense.
LIFE PRESERVER ASSEMBLIES, INFLATABLE, AIRCREWMEN AND PASSENGER, CEMENTED AND HEAT SEALED
This standard specifies functional and safety requirements and test methods applicable to combined buoyancy and rescue devices. This standard is applicable to combined buoyancy and rescue devices for use by divers as defined in 3.1. This standard does not apply to buoyancy compensators, which are dealt with in EN 1809.
Diving accessories - Combined buoyancy and rescue devices - Functional and safety requirements, test methods
MIL-P-21904A, dated 18 March 1992, is inactive for new design and is no longer used, except for replacement purposes.
PARACHUTES FOR UNDERWATER MINES; GENERAL SPECIFICATION FOR
This part of IEC 61097 specifies the minimum operational and performance requirements, technical characteristics, methods of testing and required test results for Inmarsat-B maritime class 1 ship earth stations (SES), capable of transmitting and receiving distress and safety communications using telephony and direct-printing telegraphy, as required by regulation IV / 10.1 and 14.1 of the 1988 amendments to the 1974 International Convention for the Safety of Life at Sea (SOLAS), for use in the GMDSS. In order to meet the carriage requirements of the GMDSS in respect of receipt of SafetyNET broadcasts, it is necessary to install an additional EGC receiver or a combined Inmarsat-C/EGC receiver. This standard takes account of IMO Resolution A.694, to which IEC 60945 is associated. When a requirement in this standard is different from IEC 60945, the requirement in this standard takes precedence. This standard incorporates the performance standards of IMO Resolution A.808. It also incorporates the relevant ITU Radio regulations. This standard does not incorporate the Inmarsat system requirements needed for Inmarsat type approval. For these, the latest edition of the Inmarsat-B system definition manual (SDM) shall be consulted. When a requirement in this standard is different from one in the Inmarsat-B SDM, reference shall be made to the most recent IMO and ITU applicable documents to resolve the difficulty. NOTE - All text of this standard, the wording of which is identical to that in the IMO SOLAS Convention 1974 as amended and IMO Resolution A.808, is printed in italics and it is followed by the resolution or recommendation and paragraph number indicated between brackets.
Global maritime distress and safety system (GMDSS) - Part 10: Inmarsat-B ship earth station equipment - Operational and performance requirements, methods of testing and required test results
MS70093A, dated 30 September 1966, is inactive for new design and
BALL END, WIRE ROPE, SWAGING, PARACHUTE RIPCORD CABLE
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号