共找到 548 条与 航空器及其附件综合 相关的标准,共 37 页
Military helicopter demonstation requirements
Specifications and data of contract requirements for naval aircrafts and helicopters
本标准规定了机载火力控制系统(以下简称火控系统)误差分配的原则和方法,作为火控系统设计的基本依据。 本标准适用于各种类型机载火控系统。
General requirements for error distribution of airborne fire control system
本标准规定了机载火控设备定型地面试验的要求、准备、项目、顺序和方法。 本标准适用于机载火控设备设计定型和生产定型的地面试验(以下简称定型试验),可作为编写机载火控设备专用规范(或技术条件)中有关规定的依据。当机载火控设备的设计、工艺、材料及主要零部件(元器件)有较大改变可能影响设备性能时、长期停产又恢复生产时、设备转厂生产时、以及需要进行鉴定的地面试验时,亦可参照使用。
Airborne fire control equipment finalized ground test procedures
本规范规定了机载武器悬挂装置和辅助设备(以下简称悬挂装置)的一般要求。 本规范适用于飞机、直升机上用来悬挂、运载和发射或投放武器和装备的装置,也适用于安装在悬挂装置上用来操纵和控制悬挂装置工作的各种设备。本规范不适用于用来计算发射点或投放点的设备。
General specification for airborne weapon suspension and auxiliary equipment
General specification for windshield system of fixed-wing aircraft
This industrial Standard for the aerospace sector has been drawn up under the responsibilit of AECMA.
Aerospace Series Part 003 - Detail Specification Sheet. Grommet Nut, Style A.
この規格は,航空機で使用する機械式及び電気機械式指示器に対して一般的に適用する要求事項について規定する。この規格は,個々の指示器の仕様書と一緒に読まなければならない。
Aircraft -- Mechanical and electromechanical indicators -- General requirements
This amendment forms a part of MIL-D-85520(AS), dated 10 March 1983, and i s approved for use by all Departments and Agencies of the Department of Defense.
DESIGN AND INSTALLATION OF ON BOARD OXYGEN GENERATING SYSTEMS IN AIRCRAFT, GENERAL SPECIFICATION FOR
This specification d e f i n e s the d e s i g n and construction requirements
TIE-DOWNS, AIRFRAME DESIGN, REQUIREMENTS FOR
本标准规定了不锈、耐热钢熔模铸造压气机静子叶片的技术要求、试验方法、检验规则和交付方式。 本标准适用于航空用ZG1Cr17Ni3不锈、耐热钢熔模铸造压气机静子叶片铸件。其它航空用不锈、耐热钢熔模铸造此类叶片亦应参照使用。
Stainless, heat-resistant steel investment casting compressor stator blades
Issuance and management of airworthiness directives
This specification establishes the requirements for the design, performance, manufacture, and acceptance of voltmeters for indicating the available capacity of storage batteries in aircraft and providing a warning signal when the available capacity becomes dangerously low.
VOLTMETER, DC, AIRCRAFT, DIGITAL DISPLAY GENERAL SPECIFICATION FOR
本标准规定了民用飞机机载设备射频敏感性的试验方法与要求,是《民用飞机机载设备环境条件和试验方法》系列标准的组成部分。 本标准适用于机载设备对射频、辐射干扰的敏感性测量,确定设备能否承受某一射频场耦合到设备中的射频电压。
Environmental conditions and test methods for radio frequency susceptibility test of airborne equipment of civil aircraft
本标准规定了飞机和航炮安装设计时必须考虑的炮口冲击波压力场和温度场防护的一般要求。 本标准适用于安装航炮的歼击机、强击机、轰炸机、教练机和武装直升机等各种飞机。本标准原则上也适用于安装航空机关枪的各种飞机。
The installation of aircraft guns requires the protection of the muzzle shock wave pressure field and temperature field
本标准规定了航空电磁铁的技术要求、试验方法和检验规定。 本标准适用于飞机上使用的直流27伏电磁铁的新品研制及其批生产。
General technical conditions for aviation electromagnets
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号