共找到 599 条与 夹具 相关的标准,共 40 页
Lock nut for multifunctional combined stamping formwork element
Multi-functional combined stamping die frame element unloading rubber
Multi-functional combined stamping formwork element wedge pin
Multi-functional combined stamping die base element handle
Multi-functional combined stamping mold frame element backing plate
Multifunctional combined stamping formwork element with shoulder hex nut
This amendment forms a part of Military Specification MIL-I-52997(ME), dated 16 February 1982, and is approved for use by the USA Belvoir Research and Development Center, Department of the Army and is available for use by all Departments and Agencies of the Department of Defense.
INSTALLATION FIXTURE KIT, ROLLER, MINE CLEARING: TRACK-WIDTH, TANK-MOUNTED
This amendment forms a part of MIL-M-53008(ME), dated 8 July 1982, and is approved for use within the USA Belvoir Research and Development Center, Department of the Army and is available for use by all Departments and Agencies of the Department of Defense.
MOUNTING KIT, ROLLER, MINE CLEARING: TRACK-WIDTH, TANK-MOUNTED
Plastic Injection Mold Type III Sprue Injection Mold Base
Plastic Injection Mold Type II Sprue Injection Mold Base
Plastic Injection Mold Type I Sprue Injection Mold Base
Plastic injection mold type Ⅲ point sprue injection mold base
Plastic Injection Mold Type IV Point Sprue Injection Mold Base
Plastic Injection Mold Type V Point Sprue Injection Mold Base
Plastic injection mold type VII point runner injection mold base
Plastic injection mold type Ⅷ point runner injection mold base
Plastic injection mold type Ⅱ point runner injection mold base
Plastic Injection Mold Type I Point Sprue Injection Mold Base
Plastic Injection Mold VI Type Sprue Injection Mold Base
Plastic Injection Mold Type V Sprue Injection Mold Base
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号