Y14 自行车 标准查询与下载

ASTM F833-05a 客车及婴儿四轮车的消费者安全性能标准规范

1.1 This consumer safety specification establishes safety performance requirements, test methods, and requirements for labeling to minimize the hazards to children presented by carriages and strollers as identified in the introduction. 1.2 No carriage or stroller produced after the approval date of this consumer safety performance shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements herein. 1.3 The values stated in inch-pound units are to be regarded as the standard. The SI values given in parentheses are for information only. 1.4 The following precautionary caveat pertains only to the test method portion, Section 7, of this consumer safety specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Consumer Safety Performance Specification for Carriages and Strollers

GOST R ISO 7176-1-2005 轮椅.第1部分:静态稳定性的测定

Wheelchairs. Part 1. Determination of static stability

ASTM F833-05 客车及婴儿四轮车的消费者安全性能标准规范

1.1 This consumer safety specification establishes safety performance requirements, test methods, and requirements for labeling to minimize the hazards to children presented by carriages and strollers as identified in the introduction. 1.2 No carriage or stroller produced after the approval date of this consumer safety performance shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements herein. 1.3 The values stated in inch-pound units are to be regarded as the standard. The SI values given in parentheses are for information only. 1.4 The following precautionary caveat pertains only to the test method portion, Section 7, of this consumer safety specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Consumer Safety Performance Specification for Carriages and Strollers

ASTM F2115-05 装有发动机的人力踏车的标准规范

1.1 This specification covers the establishment of parameters for the design and manufacture of motorized treadmills.1.2 It is intent of this specification to specify products for use by individuals age 12 and above.1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Specification for Motorized Treadmills

BS EN 1929-2:2004 篮式手推车.用于载客传送带的有或无儿童乘坐设备的篮式手推车的要求、试验和检验

This document specifies requirements for the construction, performance, testing and safety specifications for general purpose self service basket trolleys, with or without a child carrying facility, intended to be used on passenger conveyors, accompanied by a user.

Basket trolleys - Requirements, tests and inspection for basket trolleys with of without a child carrying facility, intended to be used on passenger conveyors

BS ISO 10542-4:2004 残疾人或行动障碍人用技术系统和辅助设备.轮椅系固装置和乘车人安全束护系统.夹紧式系固装置

This part of ISO 10542 specifies test methods and requirements for design and performance, instructions to installers and users, and product marking and labelling of wheelchair tiedown and occupant-restraint systems (WTORS). It is applicable only to WTORS that use clamp-type tiedown to secure wheelchairs when used as a forward facing seat by an adult passenger or driver of a motor vehicle. This part of ISO 10542 is applicable primarily to complete WTORS, but a portion of this part of ISO 10542 can also be applied to components and sub-assemblies sold separately and for replacement parts. This part of ISO 10542 is applicable to WTORS intended for use with all types of manual and powered wheelchairs, including scooters with three or more wheels.

Technical systems and aids for disabled or handicapped persons - Wheelchair tiedown and occupant restraint systems - Clamping-type tiedown systems

NF S54-014:2004 儿童使用和保育用品.儿童安全带、学步绳及类似用品.安全要求和试验方法

Child use and care articles - Children's harnesses, reins and similar type articles - Safety requirements and test methods.

BS EN 14344:2004 儿童使用和保育用品.自行车用儿童座椅.安全要求和试验方法

This document specifies requirements for child seats for cycles, which are intended to be mounted on pedal cycles and electrically power assisted bicycles, in order to transport children with a weight from 9 kg up to 22 kg (approximately 9 months up to 5 years) and who are capable of sitting unaided. NOTE Some European countries have special legislation for child seats for cycles. Compliance with this document may not meet this legislation.

Child use and care articles - Child seats for cycles - Safety requirements and test methods

BS EN 1274:2004 儿童使用和护理用品.婴儿学步车.安全性要求和试验方法

This document covers powders, which are currently applicable in thermal spraying on the basis of their physical and chemical properties. This document specifies the composition and technical supply conditions of powders for thermal spraying.

Thermal spraying-Powders-Composition,technical supply conditions

ISO 7176-24:2004 轮椅.第24部分:使用者操作的爬梯设备的要求和试验方法

This part of ISO 7176 is applicable to user-operated stair-climbing chairs and user-operated stair-climbing wheelchair carriers where the stair-climbing device climbs backwards up the stairs, with the user facing downstairs, and climbs down the stairs in a forward position with the user facing downstairs. This part of ISO 7176 specifies requirements and test methods for electrically powered stair-climbing devices that are user-operated. It also includes ergonomic, labelling and disclosure requirements. This part of ISO 7176 specifies tests to demonstrate the stair-climbing device's ability to perform safely on stairs with a pitch of 35° or higher, if claimed by the manufacturer.

Wheelchairs - Part 24: Requirements and test methods for user-operated stair-climbing devices

JIS D 9301 ERRATUM 1:2004 勘误

ERRATUM

BS ISO 10542-5:2004 残疾人或行动障碍人用技术设备和辅助装置.轮椅系固装置和乘车人安全束护系统.专用轮椅设备

This part of ISO 10542 specifies test methods as well as requirements for design and performance, for instructions and warnings to installers and users, and for product marking and labelling of wheelchair tiedown and occupant restraint systems (WTORS). It applies only to WTORS that are intended to be used with particular makes and models of wheelchairs when used as a forward-facing seat by a passenger or a driver of a motor vehicle. This part of ISO 10542 applies to WTORS intended for use with manual or powered wheelchairs, including scooters with three or more wheels, intended for use by children or adults of mass equal to or greater than 22 kg. This part of ISO 10542 applies primarily to complete WTORS, but portions of this International Standard can also be applied to components and subassemblies sold separately and for replacement parts.

Technical systems and aids for disabled or handicapped persons - Wheelchair tiedown and occupant-restraint systems - Systems for specific wheelchairs

JIS D 9301:2004 自行车.总规范

この規格は，JIS D 9111に規定する一般用自転車 (以下，自転車という。)について規定する。注 一般用自転車とは，スポーッ車，シティ車，実用車，子供車又はコンパクト車をいう。

Bicycles -- General specification

JIS D 9417:2004 自行车.链条

この規格は，主としてJIS D 9111に規定する一般用自転車及び幼児用自転車に用いるチニーン(以下，チェーンという。)について規定する。

Bicycles -- Chains

JIS D 9403:2004 自行车.车架零件

この規格は, JIS D 9401に定める自転車用フレームに用いるフレーム部品(へッド部品，ハンガ部品及びシート部品)について規定する。

Bicycles -- Frame parts

JIS D 9419:2004 自行车.轮毂

この規格は，主にJIS D 9111に定める一般用自転車及び幼児用自転車に用いるハブについて規定する。

Bicycles -- Hubs

JIS D 9416:2004 自行车.脚蹬

この規格は，主にJIS D 9111に定める一般用自転車及び幼児用自転車に用いるペダル(以下，ペダルという。)について規定する。

Bicycles -- Pedals

JIS D 9413:2004 自行车.车把

この規格は，JIS D 9111に定める一般用自転車及び幼児用白転車に用いるにぎり。ハンドルバーテープ(以下，バーテープという。)，エンドプラグ及びエンドキャップ(以下，これらを総称する場合は，"にぎりなど"という。)について規定する。

Bicycles -- Handle grips

ASTM F2194-04 小儿睡车和摇篮的用户安全标准规范

1.1 This consumer safety performance specification establishes performance requirements, test methods, and marking requirements to promote safe use of bassinets and cradles.1.2 This consumer safety performance specification is intended to minimize the risks of incidents to an infant resulting from normal use and reasonably foreseeable misuse of a bassinet or cradle.1.3 This specification covers products intended to provide sleeping accommodations (excluding full-size cribs, non-full-size cribs, and bassinets attached to play yards or swings) for an infant up to approximately 5 months in age. Products used in conjunction with a play yard, non-full-size crib, or an infant swing are not covered by this standard.1.4 No bassinet or cradle produced after the approval date of this consumer safety performance specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein.1.5 This safety performance specification is not intended to address incidents and injuries resulting from alteration or unreasonable abuse or misuse of the product by a child or child care giver.1.6 The following precautionary caveat pertains only to the test method portion Section 7 of this consumer safety specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.

Standard Consumer Safety Specification for Bassinets and Cradles

ASTM F2194-04a 小儿睡车和摇篮的用户安全标准规范

1.1 This consumer safety performance specification establishes performance requirements, test methods, and marking requirements to promote safe use of bassinets and cradles.1.2 This consumer safety performance specification is intended to minimize the risks of incidents to an infant resulting from normal use and reasonably foreseeable misuse of a bassinet or cradle.1.3 This specification covers products intended to provide sleeping accommodations (excluding full-size cribs, non-full-size cribs, and bassinets attached to play yards or swings) for an infant up to approximately 5 months in age. Products used in conjunction with a play yard, non-full-size crib, or an infant swing are not covered by this standard.1.4 No bassinet or cradle produced after the approval date of this consumer safety performance specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein.1.5 This safety performance specification is not intended to address incidents and injuries resulting from alteration or unreasonable abuse or misuse of the product by a child or child care giver.1.6 The following precautionary caveat pertains only to the test method portion Section 7 of this consumer safety specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.

Standard Consumer Safety Specification for Bassinets and Cradles