Y31 纸浆与纸板 标准查询与下载

DIN 55437-1:2008 纸板检验.折皱.第1部分:折皱试样的试验室制备

Testing of board - Creasings - Part 1: Laboratory producing of test creasings

DIN 55437-3:2008 纸板检验.折皱.第3部分:技术质量测定

Testing of board - Creasings - Part 3: Determination of the technical quality

ISO 5269-3:2008 纸浆.物理测试用试验室薄板材的制备.第3部分:使用封闭水系统的常用快速Köthen纸页成形器

ISO 5269-3:2008 specifies two procedures for preparing a closed water system which is in retention equilibrium, to be used for the preparation of laboratory sheets from pulps with a high fines content. One procedure is applicable to the preparation of laboratory sheets using the conventional sheet former and the other using the Rapid-K'then sheet former. The sheets prepared prior to attaining retention equilibrium are discarded. ISO 5269-3:2008 is especially applicable to mechanical and chemimechanical pulps, as well as to pulps prepared from recycled fibres, i.e. pulps with a high fines content for which retention of fines is poor when using the open water system as described in ISO 5269-1 or ISO 5269-2. ISO 5269-3:2008 is not applicable to some very long-fibred pulps, such as those from unshortened cotton, flax and similar materials. After retention equilibrium is attained, the preparation of laboratory sheets for testing the physical properties follows the procedures described in ISO 5269-1 (conventional sheet former) or ISO 5269-2 (Rapid-K'then sheet former), whichever is relevant. ISO 5269-3:2008 is generally not applicable for the preparation of laboratory sheets from chemical pulps for which ISO 5269-1 or ISO 5269-2 are used. ISO 5269-3:2008 is not applicable for the preparation of laboratory sheets for measuring ISO brightness. These sheets can be prepared in accordance with ISO 3688.

Pulps - Preparation of laboratory sheets for physical testing - Part 3: Conventional and Rapid-Köthen sheet formers using a closed water system

JIS P 8227:2008 纸浆.湿法或干法零距抗张强度的测定

この規格は.試験用手すき紙(以下，“シート”という。)のゼロスパン引張強さの試験方法について規定する。

Pulps -- Determination of zero-span tensile strength, wet or dry

KS M ISO 8226-2:2008 纸和纸板.湿膨胀率测量.第2部分:达最大相对湿度86%的湿膨胀率

이 규격은 상대습도가 (33±2) %∼(84±2) %까지 변화했을 때, 종이 및 판지의 흡

Paper and board－Measurement of hygroexpansivity－Part 2：Hygroexpansivity up to a maximum relative humidity of 86 %

KS M ISO 8791-1:2008 纸和纸板.粗糙度/平滑度的测定(空气泄漏法).第1部分:通用方法

이 규격은 공기 누출법에 의한 종이 및 판지의 거칠기/평활도 측정에 대한 기본적인 요구사항

Paper and board－Determination of roughness/smoothness (air leak methods)－Part 1：General method

KS M ISO 8226-1:2008 纸和纸板.湿膨胀性的测量.第1部分:最大相对湿度达百分之六十八的湿膨胀性

이 규격은 상대습도가 (33±2) %∼(66±2) %까지 변화했을 때, 종이 및 판지의 흡

Paper and board－Measurement of hygroexpansivity－Part 1：Hygroexpansivity up to a maximum relative humidity of 68 %

KS M ISO 8791-2:2008 纸和纸板.粗糙度/平滑度的测定(空气泄漏法).第2部分:板特森法

이 규격은 벤슨(Bendtsen) 시험 장치를 이용한 종이 및 판지의 거칠기 측정방법에 대

Paper and board-Determination of roughness/smoothness (air leak methods)-Part 2:Bendtsen method

BS ISO 5350-3:2008 纸浆.污物和碎片的评估.使用反射光的等值黑色面积(EBA)法进行目视检验

This part of ISO 5350 specifies a procedure for the estimation of the visible dirt and shives by reflected light using the Equivalent Black Area (EBA) method in pulps. It is, in principle, applicable to all types of dry or wet pulp, manufactured in sheets or rolls, including recycled pulp. NOTE The result of inspection by reflected light represents only the number of specks visible on the surface or near the surface of the pulp sheet. Particles which are embedded in the sheet cannot be detected.

Pulps - Estimation of dirt and shives - Visual inspection by reflected light using equivalent black area (EBA) method

KS M ISO TR 24498:2008 纸、纸板和纸浆.测定试验方法的不确定度

이 표준은 펄프, 종이 및 판지에 대한 시험방법에서 정밀도 측정을 위한 최적의 방법을 선택

Paper, board and pulps－Estimation of uncertainty for test methods

SANS 756:2008 誊写纸(公制单位)

Covers duplicator paper for use with duplicator machines other than spirit duplicators and specifies requirements for materials and size of sheets. The methods of test include dimensional examination, fibre analysis, and determination of bursting strengt

Duplicator paper (metric units)

BS ISO 8791-4:2008 纸和纸板.粗糙度/平滑度的测定(空气泄漏法).印刷面法

This part of ISO 8791 specifies a method for determining the roughness of paper and board using an apparatus which complies with the Print-surf method, as defined in this part of ISO 8791. It is applicable to all printing papers and boards with which it is possible to form a substantially airtight seal against the guard lands of the measuring head.

Paper and board. Determination of roughness/smoothness (air leak methods). Print-surf method

GOST R 53207-2008 波状纸板平面层用硬纸板.规范

Cardboard for plain layers of corrugated cardboard. Specifications

BS ISO 17812:2007 纸、纸板和纸浆.镁总含量、钙总含量、锰总含量、铁总含量和铜总含量的测定

This International Standard specifies the procedure for the determination of total magnesium, total calcium, total manganese, total iron and total copper by atomic absorption spectrometry or by plasma emission spectrometry. The total content comprises the acid-soluble part of the element plus the acid-insoluble part of the element. It is applicable to all types of paper, board and pulps.

Paper, board and pulps - Determination of total magnesium, total calcium, total manganese, total iron and total copper

QB/T 1678-2007 漂白硫酸盐木浆

本标准规定了漂白硫酸盐木浆的分类、技术要求、试验方法、检验规则和标志、包装、运输、贮存。 本标准适用于各种文化、印刷、生活用纸等纸种的漂白硫酸盐木浆。

Bleached sulphate woodpulp

ISO 5350-3:2007 纸浆.污物和碎片的评估.第3部分:使用反射光的等值黑色面积(EBA)法进行目视检验

This part of ISO 5350 specifies a procedure for the estimation of the visible dirt and shives by reflected light using the Equivalent Black Area (EBA) method in pulps. It is, in principle, applicable to all types of dry or wet pulp, manufactured in sheets or rolls, including recycled pulp. NOTE The result of inspection by reflected light represents only the number of specks visible on the surface or near the surface of the pulp sheet. Particles which are embedded in the sheet cannot be detected.

Pulps - Estimation of dirt and shives - Part 3: Visual inspection by reflected light using Equivalent Black Area (EBA) method

KS M ISO 5647:2007 纸和纸板.二氧化钛含量测定

이 규격은 모든 종류의 종이와 판지, 특히 특수 도공/충전된 지류에 포함되어 있는 이산화티

Paper and board－Determination of titanium dioxide content

KS M ISO 9668:2007 纸浆.镁含量的测定.火焰原子吸收光谱法

이 규격은 펄프의 마그네슘 함량 측정을 위한 불꽃 원자 흡광 분석법에 대하여 규정한다. 이

Pulps-Determination of magnesium content-Flame atomic absorption spectrometric method

KS M ISO 5630-4:2007 纸和纸板.加速老化.第4部分:在120℃或150℃的情况下进行干热处理

이 규격은 종이나 판지의 상대적으로 높은 온도에서의 건열(乾熱) 처리 절차와 건열 처리된

Paper and board－Accelerated ageing－Part 4：Dry heat treatment at 120 ℃ or 150 ℃

SANS 431:2007 瓦楞纸板用衬垫和凹槽

Covers lining and fluting used in the manufacture of corrugated board containers for packaging. Specifies the tensile strength, bursting strength, tearing resistance and water absorptiveness of liners (grammage range 120-440 g/m ) and the tensile strengt

Liners and fluting for corrugated board