共找到 637 条与 纸浆与纸板 相关的标准,共 43 页
この規格は,偏光を使用し光学的自動分折によってパルプの繊維長を測定する方法について規定する。この規格は,あらゆる種類のパルプに適用できる。ただし,O.2mm未満の長さの繊維状粒子はこの規格の対象外とし,測定結果には含めない。
Pulps -- Determination of fibre length by automated optical analysis -- Part 1: Polarized light method
この規格は,定速伸張形引張試験機を用い,紙及び板紙の引張強さ,引張破断伸び及び引張エネルギー吸収量の測定方法,並びに比引張強さ,比引張エネルギー吸収量及び引張弾性率の計算方法について規定する。この規格による試験は,必ず引張強さの測定を合む。その他の特性値の測定又は計算は,受渡当事者間の協定による。この規格は,すべての紙及び板紙に適用し,引強破断伸びが試験装置の測定範囲内であれば,引張破断伸びカ状きい紙にも適用する。この規格は,段ボール原紙には適用するが,段ボールそのものには適用しない。
Paper and board -- Determination of tensile properties -- Part 2: Constant rate of elongation method
이 규격은 원자 흡광 분석법이나 플라즈마 방출 분광법을 이용한 칼슘 함량 측정 방법에 대해
Paper, board and pulp-Determination of acid-soluble calcium
이 규격은 원자 흡광 분석법이나 플라즈마 방출 분광법을 이용한 철 함량 측정 방법에 대해서
Paper, board and pulp-Determination of acid-soluble iron
이 규격은 ISO/TC 6 또는 분과위원회 중 하나의 관할 아래서, 종이, 판지 및 펄프에
Paper, board and pulps ? International calibration of testing apparatus-Nomination and acceptance of standardizing and authorized laboratories
이 규격은 셰필드 장치를 이용한 종이 및 판지의 거칠기를 측정하기 위한 방법을 규정한다.
Paper and board-Determination of roughness/smoothness (air leak methods)-Part 3:Sheffield method
이 규격은 펄프 자체의 관련 특성을 평가하기 위해 수반되는 종이 시트에 대한 물리적 시험을
Pulps-Preparation of laboratory sheets for physical testing-Part 1:Conventional sheet-former method
이 규격은 셰필드 장치를 이용해서 단위 압력차하에서 종이 및 판지의 단위 면적을 통과하는
Paper and board #8211; Determination of air permeance (medium range) #8211; Part 4:Sheffield method
이 규격은 원자 흡광 분석법이나 플라즈마 방출 분광법을 이용한 구리 함량 측정 방법에
Paper, board and pulp-Determination of acid-soluble copper
This part of ISO 11093 specifies a method for the determination of the maximum flat crush resistance of wound paper and board cores.
Paper and board - Testing of cores - Determination of flat crush resistance
이 규격은 펄프로 제조한 실험실용 수초지의 물리적 특성을 측정하기 위한 시험 방법에 대
Pulps-Laboratory sheets-Determination of physical properties
이 규격은 Köhler Molin, Lhomargy, MIT 및 쇼퍼(Sc
Paper-Determination of folding endurance
이 규격은 베크법이라 불리는 종이 및 판지의 평활도를 측정하는 방법에 대하여 규정한다.
Paper and board-Determination of smoothness(Bekk method)
이 규격은 표준 조건하에서 사이징 처리된 종이나 골판지를 포함하는 판지의 물 흡수성을측
Paper and board-Determination of water absorptiveness-Cobb method
일반적으로 이 방법은 모든 종류의 펄프에 대하여 적용할 수 있다.
Pulps-Laboratory beating-Part 1:Valley beater method
이 규격은 액상의 펄프 현탁액의 지료 농도를 측정하는 방법을 규정한다. 이 규격은 기타
Pulps-Determination of stock concentration
이 규격은 종이 및 판지의 평량 측정 방법에 대하여 규정한다.
Paper and board-Determination of grammage
Pulps - Estimation of dirt and shives - Part 2: Inspection of mill sheeted pulp by transmitted light (ISO 5350-2:2006); German version EN ISO 5350-2:2006
This part of ISO 5350 specifies a method for the estimation by transmitted light of the visible dirt and shives in laboratory sheets prepared from pulp. It is, in principle, applicable to all kinds of pulp, although it is mainly intended for pulp that is not manufactured in sheet form.#,,#
Pulps - Estimation of dirt and shives - Part 1: Inspection of laboratory sheets by transmitted light (ISO 5350-1:2006); German version EN ISO 5350-1:2006
This part of ISO 5350 specifies a method using instrumental inspection by reflected light for the estimation of visible dirt and shives in pulp manufactured in sheets, in terms of Equivalent Black Area (EBA) of dirt specks within the physical area range of 0,02 mm2 to 3,0 mm2. Using the algorithm prescribed in this part of ISO 5350, the maximum dirt size is limited to 3,0 mm2. Extension to other speck sizes (for example, those greater than 3,0 mm2 in physical area) may require changes in equipment, calculation procedures, or both, and is not covered in this part of ISO 5350. This part of ISO 5350 cannot be used for physical area measurements, since it may not correctly measure the dirt specks for that mode of measurement. The specimen to be evaluated should have a brightness, as determined by ISO 3688, of 30 % or greater. It may be necessary to reform some pulp sheets into laboratory sheets, if the surface is too rough or textured. This part of ISO 5350 is also intended for recycled pulp.
Pulps - Estimation of dirt and shives - Instrumental inspection by reflected light using equivalent black area (EBA) method
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号