Y43 牙膏、肥皂、洗涤剂 标准查询与下载

QB/T 2486-2000 洗衣皂

本标准规定了洗衣皂的产品分类、技术要求、试验方法、检验规则和标志、包装、运输，贮存要求。 本标准适用于冷板冷却、真空冷却压条等工艺生产的块、条状洗衣皂，不适用于加有其他表面活性剂及含有药物的洗衣皂。

Laundry soap

JIS K 3303:2000 洗衣粉

この規格は，衣料などの洗濯に使用する粉末状・粒状などの粉末石けんについて規定する。

Laundry powdered soaps

ASTM E2082-00 洗发剂特性的描述性分析标准导则

1.1 The objective of this guide is to provide procedures which may be used in the design, execution, and analysis of studies to quantitatively assess the objective sensory attributes of shampoos. This is one of many appropriate techniques used in the hair-care industry. These attributes can then be used to define performance of shampoos and to provide direction in product formulation, research guidance testing, and claim substantiation. This guide includes the sensory properties involved in dispensing a product, as well as the attributes pertinent to shampooing tresses, half and whole heads. Although this guide is specific to shampoos, the procedures should be applicable to most hair-care products.1.2 Guidelines are provided for the definition of terminology, procedures for manipulation of products, identification/selection of hair type, and judge training. References for rating scales are not provided in this guide. The user should be aware that some sensory practices may require the use of attribute references (anchors) when training the judges.

Standard Guide for Descriptive Analysis of Shampoo Performance

DLA A-A-461 B REINST NOTICE 2-2000 洗手液(包装好的预湿纸巾)

MIL-B-44421, dated 21 February 1991, is hereby reinstated and may be used for acquisition.

HAND CLEANER (PRE-MOISTENED PAPER TOWELETTE IN PACKET)

ASTM D459-00(2007) 肥皂和其他洗涤剂的有关标准术语

1.1 This terminology covers soaps and other detergents.

Standard Terminology Relating to Soaps and Other Detergents

ASTM D4081-00(2006) 干洗剂的标准规范.全氯乙烷级

1.1 This specification covers drycleaning-grade perchloroethylene suitable for use in the drycleaning industry. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropraite safety and health practices and determine the applicability of regulatory limitations prior to use.Note 1Practice D 3844 provides additional important information on proper labeling.

Standard Specification for Drycleaning-Grade Perchloroethylene

ASTM D459-00 肥皂和其他洗涤剂的有关标准术语

This terminology covers soaps and other detergents.

Standard Terminology Relating to Soaps and Other Detergents

VC 8054-1999 消毒剂和洗涤消毒剂

Covers requirements for disinfectants and detergent-disinfectants intended for use on inanimate surfaces.

Disinfectants and detergent-disinfectants

MH/T 6007-1999 飞机清洗剂

aircraft cleaning agent

JIS K 3362:1998 合成洗涤剂的测试方法

この規格は，家庭用の合成洗剤の試験方法について規定する。

Testing methods for synthetic detergent

QB/T 2387-1998 洗衣皂粉

laundry soap powder

DLA MIL-DTL-12468 D-1998 STB型去污剂

This specification covers one type of decontaminating agent.

DECONTAMINATING AGENT, STB

ARMY MIL-PRF-372 D-1998 (小型武器枪膛和自动飞行武器用)洗涤剂

This specification covers one type of bore cleaner for use in the removal of primer salts and as a temporary preservative for metallic items.

CLEANING COMPOUND, SOLVENT (FOR BORE OF SMALL ARMS AND AUTOMATIC AIRCRAFT WEAPONS)

NAVY A-A-59150 A-1998 氢氟醚(HFE)溶解洗涤剂

This commercial item description (CID) covers the requirements for a hydrofluoroether (HFE) cleaning compound solvent.

CLEANING COMPOUND, SOLVENT, HYDROFLUOROETHER (HFE)

QB/T 2345-1997 脂肪烷基二甲基甜菜碱平均相对分子质量的测定 气液色谱法

本标准规定了测定脂肪烷基二甲基甜菜碱平均相对分子质量的填充住气液色谱法。 本标准适用于单一类型试样的测定，不适用于与其他组分的混合物和含有其他干扰性有机化合物的试样。

Determination of the Average Relative Molecular Mass of Fatty Alkyl Dimethyl Betaines by Gas-Liquid Chromatography

QB/T 2344-1997 两性表面活性剂 脂肪烷基二甲基甜菜碱

本标准规定了脂肪烷基二甲基甜菜域的技术要求、试验方法、检验规则和标志、包装、运输、贮存要求。 本标准适用于脂肪烷基二甲基甜菜碱。

Amphoteric Surfactant Fatty Alkyl Dimethyl Betaine

QB/T 2346-1997 牙膏用二氧化硅

本标准规定了牙膏用磨擦型二氧化硅的技术要求、试验方法、检验规则及标志、包装运输、贮存。 本标准适用于用化学反应方法制备之磨擦型二氧化硅，主要用于牙膏。

Silicon dioxide for toothpaste

ASTM D2960-98 使用自然污染织物和家用织物做受控洗涤试验的试验方法

1.1 This test method covers a testing technique which may be used for comparing the cleaning and whitening or brightening performance of any pair of home laundering products or home laundering procedures. This testing is done on naturally soiled family items in home laundering equipment in a laboratory under controlled conditions on a paired comparison basis. 1.2 There is no single assessment that will give the overall performance of a laundry product. A single test can only predict how products compare under the particular conditions chosen for evaluation and cannot be expected to reflect their comparative performance under the many other possible conditions of use. A series of assessments is always necessary in order to evaluate the many aspects of product performance. While there are laboratory methods for measuring individual aspects of performance (for example redeposition, solubility), it is necessary to conduct confirming tests under controlled but practical home laundering conditions to simulate consumer experience more closely. 1.2.1 Among the variables that can affect the performance of home laundering products or procedures and that must be considered in designing tests for their evaluation are: type of fiber, fabric construction, fabric finish, types of items to be washed, load size, kind and level of soils or stains, water hardness, water temperature, pretreatments, the presence of various laundering aids, the concentration of products in the laundering solution, sequence of addition of products, water, laundry, wash time, rate and type of agitation, spin speed, drying or ironing methods, and conditions under which the items are judged. 1.3 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use .

Standard Test Method of Controlled Laundering Test Using Naturally Soiled Fabrics and Household Appliances

ASTM D6361/D6361M-98(2010)e1 清洁剂的选择与处理用标准指南

This guide is to be used by anyone developing cleaning requirements for specifications for manufacturing, maintenance, or overhaul. This guide has been designed to be application specific for each cleaning task and to assure the design engineer that the process selected by the industrial or manufacturing engineer will be compatible with both the part material and the subsequent process(es). This guide allows the industrial or manufacturing engineer to customize the selection of the cleaning product based on the materials of the part being cleaned; the cleanliness required for the subsequent process(es); and the environmental, cost, and health and safety concerns.1.1 This guide is intended to assist design engineers, manufacturing/industrial engineers, and production managers in selecting the best fit cleaning agent and process. This guide takes into account environmental pollution prevention factors in a selection process. 1.2 This guide is not to be considered as a database of acceptable materials. It will guide the engineers and managers through the cleaning material selection process, calling for engineers to customize their selection based on the cleaning requirements for the cleaning tasks at hand. If a part can be cleaned, and kept clean, it can be cycled through several process steps that have cleaning requirements. This eliminates extra cleaning process steps during the total process. A total life cycle cost analysis or performance/cost of ownership study is recommended to compare the methods available. 1.3 This guide is for general industry manufacturing, equipment maintenance and remanufacturing operations, and to some extent precision cleaning of mechanical parts and assemblies. It is not intended to be used for optical, medical, or electronics applications, nor is it intended for dry-cleaning or super-critical fluid cleaning. 1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

Standard Guide for Selecting Cleaning Agents and Processes

JIS K 3304:1997 肥皂的测试方法

Testing methods for soaps