Y62 家用清洁、整容器具 标准查询与下载

DIN EN 60335-2-10:2009 家用和类似用途电器.安全性.第2-10部分:地板处理机和湿式擦洗机的特殊要求

Household and similar electrical appliances - Safety - Part 2-10: Particular requirements for floor treatment machines and wet scrubbing machines (IEC 60335-2-10:2002 + A1:2008); German version EN 60335-2-10:2003 + A1:2008

ANSI/ADA 120-2009 电动牙刷

Powered Toothbrushes

ANSI/UL 2158b-2009 电干衣机安全性标准

Standard for Safety for Electric Clothes Dryers

ANSI/ASTM F859:2009 无轨道传送型多槽热消毒商用洗碗机标准规格

Specification For Heat-Sanitizing Commercial Dishwashing Machines, Multiple Tank, Conveyor Rack Type

ANSI/ASTM F1237:2009 商用洗碗机、多罐、连续椭圆传送型、热消毒筒规范

Specification for Commercial Dishwashing Machines, Multiple-Tank, Continuous Oval-Conveyor Type, Heat Sanitizing

ANSI/ASSE 1004-2009 商用洗碗机回流预防要求

This standard applies to the backflow prevention device used on the potable water supply connected to a commercial dishwashing machine.

Backflow Prevention Requirements for Commercial Dishwashing Machines

ASTM F450-09 真空吸尘器软管的耐热性及可靠性的标准试验方法

These test methods can be used by buyers of vacuum cleaner hose to specify the test criteria the hose must meet to be acceptable for their purposes.1.1 These test methods cover the determination of the effect of anticipated stresses and strains that vacuum cleaner and extractor hoses will receive in normal use. 1.2 These test methods apply to plastic (regular and reinforced), nonelectric vacuum cleaner and extractor hoses for household use. 1.3 The following tests are included: Section Torsional flex6 Hot and cold flex with aging7 Abrasion, external surfaces8 Flex9 Pull test on hose fittings with aging10 Crush11 Stretch ratio12 Extractor hoses13 1.4 These test methods are individual tests as agreed upon between the hose and vacuum manufacturer. 1.5 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Methods for Vacuum Cleaner Hosex2014;Durability and Reliability (Plastic)

ANSI/ASTM F1284:2009 住宅中心真空清洁系统清除地毯内嵌污物的效果评估试验方法

Test Method For Evaluating Carpet Embedded Dirt Removal Effectiveness Of Residential Central Vacuum Cleaning Systems

ASTM F2756-09 测定真空吸尘器能量消耗的标准试验方法

This test method provides an indication of the amount of energy usage of the vacuum cleaner while operating over a specified cleaning area at a specified stroke speed and total number of cleaning strokes. The test area is divided into a number of strips, the strip being defined as the width of the power head or nozzle. For the purpose of this procedure, the cleaning area is specified as 10 m (15 500 in.), the stroke speed is defined as 0.5 ± 0.03 m/s (1.7 ± 0.1 ft/s), with a total of 8 strokes per strip. In order to provide a uniform basis for measuring the performance described in 1.1, standardized test carpets are employed in this procedure.1.1 This test method covers only a laboratory test for determining the energy usage-of household and commercial upright, canister, stick, and wet/dry vacuum cleaners operating on carpet when tested under specified conditions. 1.1.1 Vacuum cleaners, other than upright vacuum cleaners, that provide a carpet-cleaning function are tested in accordance with the carpet-cleaning instructions provided in the manufacturer’s instruction manual. If the manufacturer’s instruction manual does not contain instructions for a carpet-cleaning function, the vacuum cleaner is not within the scope of this procedure. 1.2 This test method is applicable to household and commercial types of vacuum cleaners. 1.3 The values stated in SI units are to be regarded as standard. The inch-pound units given in parentheses are mathematical conversions that are provided for information only and are not considered standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Standard Test Method for Determining Energy Consumption of Vacuum Cleaners

ASTM F608-09 家用/商用真空吸尘器去除地毯内藏污物的效果评定的标准试验方法

This test method provides an indication of the capability of the vacuum cleaner to remove embedded dirt from carpeting. This test method is based upon results of home cleaning tests so that, in most cases, a reasonable correlation exists between home and laboratory results. The amount of dirt picked up in the laboratory test may not be the same as in the home; however, it will show that, in most cases, a vacuum cleaner that performs well in the laboratory will perform well in a home. Laboratory results may differ due to variations in the homes, carpets, dirt, and other factors (see Section 6). In order to provide a uniform basis for measuring the performance described in 1.1, standardized test carpets and a standardized test dirt are employed in this procedure.1.1 This test method covers only a laboratory test for determining the relative carpet dirt removal effectiveness of household/commercial vacuum cleaners when tested under specified conditions. 1.2 This test method is applicable to household/commercial types of upright, canister, and combination cleaners. 1.3 The test method applies to embedded dirt removal from carpets, not the removal of surface litter and debris. 1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Evaluation of Carpet Embedded Dirt Removal Effectiveness of Household/Commercial Vacuum Cleaners

ASTM F1284-09 评价住宅中央控制真空吸尘器吸除地毯脏物效力的试验方法

This test method provides a laboratory test for determining the relative carpet dirt removal effectiveness of residential central vacuum cleaning systems when tested under standard conditions and on representative types of carpets. This laboratory test method may not give a representation of carpet embedded dirt cleaning effectiveness in the home. In order to provide a uniform basis for measuring performance as described in 1.2, standardized test carpets and standardized test dirt are employed in this procedure. The results reflect a non-loaded cleaning capability and may not be representative of cleaning capabilities under dirt loading conditions.1.1 1.1nbsp;nbsp;nbsp;This test method covers only a laboratory test for determining the relative carpet dirt removal effectives of residential central vacuum cleaning systems when tested under specified conditions. 1.2 This test method is applicable to residential central vacuum cleaning systems intended for cleaning carpets. 1.3 This test method applies only to embedded dirt removal from carpets, not the removal of surface litter and debris. 1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. X1.1.1 The purpose of this test is to determine a ratio of a carpet-embedded dirt removal effectiveness and a home-carpet embedded removal effectiveness rating which can be used for comparing one or more vacuum cleaners against a standard vacuum cleaner and determining correlation with laboratory ASTM tests. The results are representative of the geographic area covered by the test homes.

Standard Test Method for Evaluating Carpet Embedded Dirt Removal Effectiveness of Residential Central Vacuum Cleaning Systems

ANSI/NSF 29(i3)-2009 大型喷雾式洗碗机用清洁剂和化学制剂进料器

Detergent and chemical feeders for commercial spray-type dishwashing machines

ASTM F25/F25M-09 电子及类似用途用的清洁室及其它防尘区域空气中粒状杂质的筛分和计算的标准试验方法

1.1 This test method covers counting and sizing airborne particulate matter 5 µm and larger (macroparticles). The sampling areas are specifically those with contamination levels typical of cleanrooms and dust-controlled areas. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.

Standard Test Method for Sizing and Counting Airborne Particulate Contamination in Cleanrooms and Other Dust-Controlled Areas

ANSI/UL 2158a-2009 电干衣机安全性标准

Standard for Safety for Electric Clothes Dryers

ANSI/UL 2158-2009 电动衣物烘干机的安全性标准

Addition of Fire Containment Requirements.

Standard for Safety for Electric Clothes Dryers

BS EN ISO 10472-5:2008 工业洗衣机用安全要求.织物熨烫机、进布机和折布机

This part of ISO 10472 covers, together with ISO 10472-1, most significant hazards associated with flatwork ironers, feeders and folders, such as: — cylinder and bed ironers for flatwork finishing having a contact area (for bed ironers under pressure) > 0,25 m²; — flatwork feeding machines for the automatic feeding of flatwork into bed or cylinder ironers, or directly to folders; — flatwork folding machines for the automatic folding of flatwork in association with cylinder and bed ironers; — folding machines for the automatic folding of small pieces (excluding endless towels); — multi-function machines. This part of ISO 10472 complements the basic requirements as laid down in ISO/TR 12100-1 and ISO/TR 12100-2. It also gives guidance to the designer on assessing the risks associated with the hazards (see EN 1050) and on selecting measures for attaining the required safety level. This part of ISO 10472 does not apply to ancillary equipment, e. g chemical supply pumps, steam valves and supply pipe work, vent systems, work feed systems and discharge systems and ducting to the atmosphere.

Safety requirements for industrial laundry machinery - Part 5: Flatwork ironers, feeders and folders

BS EN ISO 10472-6:2008 工业洗衣机的安全要求.熨烫及熔压机

This part of ISO 10472 covers, together with ISO 10472-1, most significant hazards associated with ironing and fusing presses used in the laundry, garment and dry-cleaning industry, and in particular: — scissor presses; — cabinet presses; — drawer presses; — rotary presses (carousel) and other presses with multiple bucks. This part of ISO 10472 complements the basic requirements as laid down in ISO/TR 12100-1 and ISO/TR 12100-2. It also gives guidance to the designer on assessing the risks associated with the hazards (see EN 1050) and on selecting measures for attaining the required safety level. This part of ISO 10472 does not apply to ancillary equipment, e. g steam boilers, steam valves and supply pipe work, vent systems, work feed systems and discharge systems, and ducting to the atmosphere.

Safety requirements for industrial laundry machinery - Part 6: Ironing and fusing presses

NF C73-805/A2:2008 家用和类似用途电器.安全性.第2-5部分:洗碗机的特殊要求

Household and similar electrical appliances - Safety - Part 2-5 : particular requirements for dishwashers.

IEC 59F/184/DPAS:2008 IEC/PAS 62611,Ed.1:商用真空吸尘器.性能测量方法

IEC/PAS 62611, Ed. 1: Vacuum cleaners for commercial use - Methods of measuring the performance

DIN EN 60335-2-62:2008 家用和类似用途电器.安全性.第2-62部分:商业电洗池的详细要求(IEC 60335-2-62-2002 + A1-2008).德文版本EN 60335-2-62-2003+勘误表2007+A1-2008

Household and similar electrical appliances - Safety - Part 2-62: Particular requirements for commercial electric rinsing sinks (IEC 60335-2-62:2002 + A1:2008); German version EN 60335-2-62:2003 + Corrigendum 2007 + A1:2008