Z10 环境污染物监测方法 标准查询与下载

DB64/T 827-2012 引黄灌区农田排水水质监测技术规程

Technical Regulations for Water Quality Monitoring of Farmland Drainage in the Yellow River Diversion Irrigation Area

KS A ISO 11932:2012 放射性废弃物的再循环、再利用或处置放射能的固体物测定

이 표준은 원자력 시설의 운영과 해체 시에 발생되는 비방사성 폐기물의 재순환, 재사용 혹은

Activity measurements of solid materials considered for recycling, re-use, or disposal as non-radioactive waste

DB63/T 1144-2012 污染源自动监控系统数据采集技术规范

Technical specifications for data acquisition of pollution source automatic monitoring system

BS EN 16192:2011 废弃物特征.洗出液分析

Characterization of waste. Analysis of eluates

NF X30-485:2012 废弃物的表征.提出物的分析

Characterization of waste - Analysis of eluates.

DIN CEN/TR 16176:2012 废物特性描述.通过现场核实的X射线荧光光谱法元素组成的筛选方法.德文版本CEN/TR 16176-2011

Characterization of waste - Screening methods for elemental composition by X-ray fluorescence spectrometry for on-site verification; German version CEN/TR 16176:2011

DIN EN 16192:2012 废物特性描述.洗出液的分析.德文版本EN 16192-2011

Characterization of waste - Analysis of eluates; German version EN 16192:2011

DB64/T 710-2011 农村集中式饮用水水源地保护工程技术规范

Technical specifications for rural centralized drinking water source protection engineering

DB42/T 726-2011 湖北省环境空气质量自动监测站建设和验收规范

Specification requirements of construction and acceptance for Hubei Province ambient air quality automatic monitoring system

HJ 606-2011 工业污染源现场检查技术规范

本标准规定了工业污染源现场检查的准备工作、主要内容及技术要点。 本标准适用于各级环境保护主管部门的工业污染源现场检查工作。

Technical guideline for field inspection on industry enviromental pollution source

BS EN 15527:2008 废弃物的特性.用气相色谱质量分析(GC/MS)测定废弃物中的多环芳烃(PAH)

This European Standard specifies the quantitative determination of 16 polynuclear aromatic hydrocarbons (PAH) according to the priority list of the Environmental Protection Agency (EPA, 1982). This European Standard is applicable for wastes such as contaminated soil, sludge and rubble, bitumen or waste containing bitumen. This European Standard describes a gas chromatographic method with mass spectrometric detection (GCMS). Under the conditions specified in this document, a typical lower limit of application of 0,1 mg/kg for each individual PAH can be achieved. NOTE 1 This method may be applied to the analysis of other PAH compounds not specified in the scope provided its applicability has been proven by proper in-house validation experiments. NOTE 2 For some materials, e. g. bitumen, the lower limit of application of 0,1 mg/kg cannot be achieved due to interferences. NOTE 3 Under certain circumstances the method may be applicable to PAH concentrations lower than 0,1 mg/kg but it is in the responsibility of the laboratory to provide proper validation data for such low concentrations.

Characterization of waste - Determination of polycyclic aromatic hydrocarbons (PAH) in waste using gas chromatography mass spectrometry (GC/MS)

DIN EN 12920:2008 废弃物特性.在指定条件下测定废弃物浸出特性用方法学.德文版本EN 12920-2006+A1-2008

This standard specifies a methodology for the determination of the leaching behaviour of waste under specified conditions (i.e. for a specified scenario including a specified time frame) in order to provide a solution to a defined problem. This applies to disposal and recovery scenarios. NOTE 1 Recovery is the term defined in the European Waste Acts [1,3]. It includes re-use and recycling. The term "waste" includes all categories of waste, such as municipal waste, waste from extractive industry etc. The external conditions which have a direct influence on the release of constituents from waste are considered. Migration of constituents leached from the disposal or the recovery site into the surrounding environment is not considered. Also the assessment of toxicity to humans or ecological impacts on flora and fauna as a secondary effect after release of constituents from the waste is not considered. NOTE 2 Present knowledge of highly complex scenarios and wastes may limit the ability to provide a clear solution to a defined problem. An example may be the land filling of complex mixtures of wastes or the prediction of the acid generation behaviour waste from the extractive industry .

Characterization of waste - Methodology for the determination of the leaching behaviour of waste under specified conditions ; German version EN 12920:2006+A1:2008

HJ/T 397-2007 固定源废气监测技术规范

本标准规定了在烟道、烟囱及排气筒等固定污染源排放废气中，颗粒物与气态污染物监测的手工采样和测定技术方法，以及便携式仪器监测方法。对固定源废气监测的准备、废气排放参数的测定、排气中颗粒物和气态污染物采样与测定方法、监测的质量保证等作了相应的规定。 本标准适用于各级环境监测站，工业、企业环境监测专业机构及环境科学研究部门等开展固定污染源废气污染物排放监测，建设项目竣工环保验收监测，污染防治设施治理效果监测，烟气连续排放监测系统验证监测，清洁生产工艺及污染防治技术研究性监测等。

Technical specifications for emission monitoring of stationary source

HJ/T 398-2007 固定污染源排放 烟气黑度的测定 林格曼烟气黑度图法

本标准规定了测定烟气黑度的林格曼烟气黑度图法，包括观测位置和条件、观测方法、计算方法以及标准林格曼烟气黑度图的规格。 本标准适用于固定污染源排放的灰色或黑色烟气在排放口处黑度的监测，不适用于其他颜色烟气的监测。

Stationary source emission - Determination of blackness of smoke plumes - RingeImann smoke chart

HJ/T 365-2007 危险废物(含医疗废物)焚烧处置设施二噁英排放监测技术规范

本标准规定了危险废物焚烧处置设施二噁英排放监测的点位布设、采样时的运行工况、采样器材、分析方法、质量保证和质量控制、数据处理、结果表达和监测报告等技术要求。 本标准适用于危险废物焚烧处置设施、医疗废物焚烧处理设施和水泥窑共处置危险废物设施建设项目竣工环境保护验收、监督性监测过程中的二噁英类监测。委托监测应参照本标准执行。 生活垃圾焚烧设施二噁英排放监测可参照本标准执行。

Technical guideline of monitoring on dioxins emission from hazardous waste (including medical waste) incinerators

HJ/T 75-2007 固定污染源烟气排放连续监测技术规范(试行)

1.1 本标准规定了固定污染源烟气排放连续监测系统（Continuous Emissions Monitodng System,CEMS）中的颗粒物CEMS、气态污染物（含S0、NO等）CEMS和有关排气参数（含氧量等）连续监测系统（Continuous Monitodng System CMS）的主要技术指标、检测项目、安装位置、调试检测方法、验收方法、日常运行管理、日常运行质量保证、数据审核和上报数据的格式。 1.2 本标准适用于以固体、液体为燃料或原料的火电厂锅炉、工业/民用锅炉以及工业炉窑等固定污染源的CEMS。 1.3 生活垃圾焚烧炉、危险废物焚烧炉及以气体为燃料或原料的固定污染源CEMS可参照本标准执行。

Specifications for continuous emissions monitoring of flue gas emitted from stationary sources (on trial)

HJ/T 76-2007 固定污染源烟气排放连续监测系统技术要求及检测方法(试行)

本标准规定了固定污染源烟气排放连续监测系统的主要技术指标、检测项目、检测方法和检测时的质量保证措施。 本标准适用于监测固定污染源烟气参数，烟气中颗粒物、二氧化硫、氮氧化物浓度和排放总量的连续监测系统。

Specifications and test procedures for continuous emission monitoring systems of flue gas emitted from stationary sources (on trial)

DIN EN 14582:2007 废弃物的特性.卤素含量和硫含量.密封设备中氧的燃烧和测定方法

This standard specifies a combustion method for the determination lf halogen and sulphur contents in materials by combustion in a closed system containing oxygen(calorimetric bomb),and the subsequent analysis of the combustion product using different analytical techniques. This method is applicable to soled,pasty and liquid samples xontaining more than 0,025g/kg of halogen and/or 0,025g/kg of sulphur content.The limit of detection depends on the element,the matrix and the determination technique used. lnsoluble halides and sulphate present in the original sample or produced during the combustion step are not completely determined by these methods.

Characterization of waste - Halogen and sulfur content - Oxygen combustion in closed systems and determination methods English version of DIN EN 14582:2007-06

HJ/T 298-2007 危险废物鉴别技术规范

本标准规定了固体废物的危险特性鉴别中样品的采集和检测，以及检测结果的判断等过程的技术要求。 本标准中的固体废物包括固态、半固态废物和液态废物（排入水体的废水除外）。 本标准适用于固体废物的危险特性鉴别，不适用于突发环境污染事故产生的危险废物的应急鉴别。

Technical specifications on identification for hazardous waste

NF X30-463:2007 废弃物特征.废弃物、污泥和沉淀物灼烧损失的测定

Characterization of waste - Determination of loss on ignition in waste, sludge and sediments.