Z15 大气环境有毒害物质分析方法 标准查询与下载

SANS 14065:2007 温室气体．对实施认可或其他形式的承认的温室气体验证和核验机构的要求

Specifies principles and requirements for bodies that undertake validation or verification of greenhouse gas (GHG) assertions.

Greenhouse gases - Requirements for greenhouse gas validation and verification bodies for use in accreditation or other forms of recognition

NF X43-055:2007 环境空气.大气中气体污染物的计量学测量法.环境空气的取样和校准气体的实施

Ambient air - Metrology applied to the measurement of gaseous atmospheric pollutants - Sampling of ambient air and implementation of calibration gases.

KS I ISO 16740:2007 工作场所空气.气载颗粒物质中六价铬的测定.用二苯基卡巴胼的离子色谱法和光谱测定法

이 규격은 작업장 내의 공기 중 6가크롬에 대하여 시간 가중 평균 질량 농도를 측정하기 위

Workplace air－Determination of hexavalent chromium in airborne particulate matter－Method by ion chromatography and spectrophotometric measurement using diphenyl carbazide

KS I ISO 12141:2007 固定污染源的排放.在低浓度时颗粒物质(粉尘)的质量浓度的测定.手工重量分析法

이 규격은 표준 상태 하에서 50 mg/m3 미만의 낮은 먼지 함량을 갖는 덕트 내의 기체

Stationary source emissions－Determination of mass concentration of particulate matter(dust) at low concentrations－Manual gravimetric method

DIN EN ISO 16000-7:2007 室内空气.第7部分:空气中石棉纤维浓度测定用取样策略

This part of ISO 16000 specifies procedures to be used in planning of air measurements to determine the concentrations of asbestos in indoor atmospheres. Careful planning of the measurement strategy is important, because the results can become the basis of recommendations for major building renovations, or for the return of a building to normal occupancy status after removal of asbestos-containing materials. This part of ISO 16000 uses the following definition for indoor environments as specified in ISO 16000-1: -- dwellings having living rooms, bedrooms, do-it-yourself (DIY) rooms, recreation rooms, cellars, kitchens and bathrooms; -- workrooms or workplaces in buildings which are not subject to health and safety inspections in regard to air pollutants (for example, offices and sales premises); -- public and commercial buildings (for example, hospitals, schools, kindergartens, sports halls, libraries, restaurants and bars, theatres and other function rooms); -- cabins of vehicles and public transport.

Indoor air - Part 7: Sampling strategy for determination of airborne asbestos fibre concentrations (ISO 16000-7:2007); English version of DIN EN ISO 16000-7:2007-11

BS 8485:2007 受开发影响的地面气体的表征和补救用实施规则

This British Standard gives recommendations and describes methods for the investigation and assessment of the ground gases methane and carbon dioxide during new development of affected sites, and is not intended for the assessment of completed developments. It details a process that can be used to effectively demonstrate that risks posed by the potential presence of ground gas have been adequately considered and addressed. It presents the assessment and decision making stages in the form of a process flowchart, accompanying information and explanatory guidance and, where appropriate, references to other guidance and information. The standard does not consider ground gases other than methane and carbon dioxide. NOTE Other gases might require specific risk assessments and have to be considered separately.

Code of practice for the characterization and remediation from ground gas in affected developments

ISO 16000-9:2006/cor 1:2007 室内空气.第9部分:建筑产品和家具挥发性有机化合物排放的测定.排放试验室法.技术勘误1

This standard is Indoor air - Part 9: Determination of the emission of volatile organic compounds from building products and furnishing - Emission test chamber method; Technical Corrigendum 1.

Indoor air - Part 9: Determination of the emission of volatile organic compounds from building products and furnishing - Emission test chamber method; Technical Corrigendum 1

DIN EN ISO 20988:2007 空气质量.评定测量不确定度指南(ISO 20988:2007)

This International Standard provides comprehensive guidance and specific statistical procedures for uncertainty estimation in air quality measurements including measurements of ambient air, stationary source emissions, indoor air, workplace atmospheres and meteorology. It applies the general recommendations of the Guide to the Expression of Uncertainty in Measurement (GUM) to boundary conditions met in air quality measurement. The boundary conditions considered include measurands varying rapidly in time, as well as the presence of bias in a series of observations obtained under conditions of intended use of methods of air quality measurement. The methods of measurement considered comprise -- methods corrected for systematic effects by repeated observation of reference materials, -- methods calibrated by paired measurement with a reference method, -- methods not corrected for systematic effects because they are unbiased by design, and -- methods not corrected for systematic effects in intended use deliberately taking into account a bias. Experimental data for uncertainty estimation can be provided either by a single experimental design in a direct approach or by a combination of different experimental designs in an indirect approach.

Air quality - Guidelines for estimating measurement uncertainty (ISO 20988:2007); English version of DIN EN ISO 20988:2007-09

ISO 16000-7:2007 室内空气.第7部分:空气中石棉纤维浓度测定用取样策略

This part of ISO 16000 specifies procedures to be used in planning of air measurements to determine the concentrations of asbestos in indoor atmospheres. Careful planning of the mensurement strategy is important,because the results can become the basis of recommendations for major building renovations,or for the return of a building to normal occupancy status after removal of asbestos-containing materials. This part of ISO 16000 uses the following definition for indoor environments as specified in ISO 16000-1: -- dwellings having living rooms,bedrooms,do-it-yourself(DIY)rooms,recreation rooms,cellars,kitchens and bathrooms; -- workrooms or workplaces in buildings which are not subject to health and safety inspections in regard to air pollutants ; -- public and commercial buildings; -- cabins of vehicles and public transport.

Indoor air - Part 7: Sampling strategy for determination of airborne asbestos fibre concentrations

ISO 14966:2002/cor 1:2007 环境空气.无机纤维颗粒数值浓度的测定.扫描电子显微镜法.技术勘误1

This is Technical Corrigendum 1 to ISO 14966-2002 (Ambient air— Determination of numerical concentration of inorganic fibrous particles — Scanning electron microscopy method — )

Ambient air - Determination of numerical concentration of inorganic fibrous particles - Scanning electron microscopy method; Technical Corrigendum 1

KS I ISO 14965:2007 空气质量.非甲烷总烃的测定.低温预浓缩和直接火焰离子化检测法

이 규격은 대기 중의 총 비메탄 휘발성 유기화합물(NMVOC)의 시료채취와 농축을 측정하는

Air quality－Determination of total non-methane organic compounds－Cryogenic preconcentration and direct flame ionization detection method

KS I ISO 7168-2:2007 空气质量.数据交换.第2部分:压缩数据格式

이 규격은 공기의 질 데이터의 표현을 위한 요약된 데이터 형식에 대해 자세히 기술하였다.

Air quality－Exchange of data－Part 2：Condensed data format

KS I ISO 7168-1:2007 空气质量.数据交换.第1部分:一般数据格式

이 규격은 공기의 질 데이터와 관련된 정보의 교환을 위한 일반적인 데이터 형식에 대해 자세

Air quality－Exchange of data－Part 1：General data format

BS EN ISO 14065:2012 温室气体.认证或承认的其他形式用温室气体确认和验证机构的要求

Greenhouse gases. Requirements for greenhouse gas validation and verification bodies for use in accreditation or other forms of recognition

BS EN 1093-3:2006 机械安全.空气中有害物质排放的评估.第3部分:特定污染物排放率的测量用试验台方法

This European Standard specifies a test bench method for the measurement of the emission rate of a given airborne hazardous substance from machines using a test bench under specified operating conditions of the machine. The measurement of the emission rates of a given pollutant emitted from machines can serve for: a) the evaluation of the performance of a machine; b) the evaluation of the reduction of pollutant emissions of the machine; c) the comparison of machines within groups of machines with the same intended use (groups are defined by the function and materials processed); d) the ranking of machines from the same group according to their emission rates; e) the determination of the state of the art of machines with respect to their emission rates. This European Standard is not applicable to machinery which is manufactured before the date of its publication as an EN.

Safety of machinery - Evaluation of the emission of airborne hazardous substances - Part 3: Test bench method for the measurement of the emission rate of a given pollutant

DIN EN ISO 16000-5:2007 室内空气.第5部分:挥发性有机化合物(VOCs)的抽样策略

This part of ISO 16000 is intended as an aid to planning volatile organic compound(VOC)indoor pollution measurements In the case of indoor air measurements，the careful planning of sampling and the entire measurement strategy are of particular significance since the result of the measurement may have far-reaching consequences，for example，with regard to the need for remediaI action or the success of such an action． An inappropriate measurement strategy may contribute to the complete uncertainty of the measurement result in a larger extent than the measurement procedure itself. This part of ISO 16000 uses the definition for indoor environment defined in ISO 16000—1.

Indoor air - Part 5: Sampling strategy for volatile organic compounds (VOCs) (ISO 16000-5:2007)English version of DIN EN ISO 16000-5:2007-05

ANSI/ASTM F2608:2007 作为真空清洁处理工艺结果测定房间空气微粒数改变的试验方法

This test method provides a laboratory test for the measurement of particulate generated as a direct result of the vacuuming process. This test method is applicable to all residential/commercial uprights, canisters, stickvacs, central vacuum systems, and combination cleaners. This test method applies to test dust removal from floor coverings not the removal of surface litter and debris. The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only This test method may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Test Method for Determining the Change in Room Air Particulate Counts as a Result of the Vacuum Cleaning Process

BS EN ISO 16000-5:2007 室内空气.挥发性有机化合物(VOCs)取样法

ISO 16000-5:2007 is intended as an aid to planning volatile organic compound (VOC) indoor pollution measurements. In the case of indoor air measurements, the careful planning of sampling and the entire measurement strategy are of particular significance since the result of the measurement may have far-reaching consequences, for example, with regard to the need for remedial action or the success of such an action. An inappropriate measurement strategy may contribute to the complete uncertainty of the measurement result in a larger extent than the measurement procedure itself.

Indoor air - Sampling strategy for volatile organic compounds (VOCs)

JIS A 1965:2007 通过在泰纳克斯TA(R)吸附剂上活性取样、热解吸附作用和使用MS/FID气相色谱法测定室内和试验室空气中挥发性有机化合物

この規格は，室内空気中の揮発性有機化合物(以下,VOCという。)を定量する方法並びに放散試験チャンバー及び放散試験セルなどを用いて建築材料から放散されるVOCを定量するためにサンプリングした空気中のVOCを定量する方法について規定する。この方法はTerm TA®吸着剤を用。いて捕集し，加熱脱離及びガスクロマトグラフ分析に基づく[1]。また，1μg/m以下から数mg/mまでの濃度範囲の，無極性及び微極性VOCに対して有効な測定方法である。なお，この規格で規定する原理を用いて，幾っかの高揮発性有機化合物（以下,vVOCという。)及び準揮発性有機化合物(以下,sVOCという。)を同様に分析することができる。注()ここに示す"Tenax TA.®"は,この規格の使用者の便宜のために，一般に入手できるものとして掲げた。同じ効果を得られることを証明することができれば，これと同等の他のものを用いてもよい。

Determination of volatile organic compounds in indoor and test chamber air by active sampling on Tenax TA(R) sorbent, thermal desorption and gas chromatography using MS/FID

DIN EN 14902 Berichtigung 1:2007 环境空气质量.悬浮颗粒物质的PM10部分中Pb、Cd、As和Ni的标准测量方法.DIN EN 14902-2005的技术勘误

Ambient air quality - Standard method for the measurement of Pb, Cd, As and Ni in the PM10 fraction of suspended particulate matter; German version EN 14902:2005, Corrigenda to DIN EN 14902:2005-10; German version EN 14902:2005/AC:2006