·可检测厚度、直径(长度)、硬度和质量四个参数
·测量原理:恒力法和恒速法
·硬度测量范围:2-330±1N
·可选硬度单位:N、Kp、Sc(硬度),mm、inch(尺寸)
·厚度测量范围:2-15mm
·直径测量范围:2-30mm
·片重:0.0001-100g,精度:0.1mg
·检测速度:10-15次/min
·接口:RS 232和打印机接口
Parameter | Specification |
Number of Testing Stations | 4 (Hardness, Thickness, Diameter and Weight) |
Hardness Testing Range | 2.0 – 300.0N (optional 5.0 – 500.0N) |
Hardness Accuracy | Better than 1N |
Thickness Testing Range | 2.00 – 15.00mm |
Thickness Accuracy | Better than ±0.02mm |
Diameter Testing Range | 2.00 – 30.00mm |
Diameter Accuracy | Better than ±0.02mm |
Weight Measurement | By internal Mettler-Toledo balance cell |
Weight Testing Range | 0.0001g – 50.0000g |
Weight Accuracy | 0.1mg |
Sample Handling | Semi- or fully automated using single or multi-batch feeder |
Testing Speed | 10 to 15 tests per minute depending on sample hardness |
Flap Control | Flap speed and opening angle steplessly adjustable |
Number of Tests | Up to 250 tests in one test run |
Measuring Units | Thickness and diameter selectable between millimeter (mm) and inches (IN) Hardness selectable between Newton (N), Kilopond (kp) and Strong Cobb (Sc) |
Force Mode | Selectable between linear force increase and linear speed increase |
Force Rate | 5 – 200N/sec. (linear force increase) or 5 – 200mm/Min. (linear speed increase) |
Calibration Procedure | Using certified 1-30 mm reference blocks, 50g (for balance) and 5 to 50kg (for load cell) reference weights |
Break Force Validation | Using the PT-MT3 magnetic tablet at 10 to 480N |
Interface | RS232 serial port for PC connection |
Instrument Housing | Stainless steel (304) to meet GLP requirements |
Power | 110/230 Volt, 50/60 Hz |
Packaging Dimensions | Approx. 90cm x 65cm x 75cm (D x W x H); approx. 118cm x 76cm x 70cm incl. WHT SM |
Net / Gross Weight | Approx. 45 / 70 kg |
Net / Gross Weight | Approx. 73 / 105 kg incl. WHT SM |
Certification | All components certified to USP / EP requirements |
CE / EMC Certification | All CE / EMC Certification provided |
Validation | All IQ & OQ documents included |