1 Scope
This International Standard specifies requirements and tests for cable cleats used for securing cables in electrical installations and for intermediate restraints used for holding cables together in formation in electrical installations. Cable cleats provide resistance to electromechanical forces where declared. This document includes cable cleats that rely on a mounting surface specified by the manufacturer for axial and/or lateral retention of cables.
Various types of cable cleats and intermediate restraints are shown in Annex A.
NOTE Requirements for manufacturers in this document also apply to importers and responsible vendors where appropriate.
This document does not apply to cable ties.
1DV Replace Clause 1 with the following:
1.1DV
This Standard specifies requirements and tests for
a)
cable cleats that provide resistance to electromechanical forces;
b)
cable cleats that are used for securing cables in electrical installations;
c)
intermediate restraints that are used for holding cables together in formation in electrical installations; and
d)
cable cleats and intermediate restraints that are installed in accordance with CSA C22.1 (CE Code, Part I).
1.2DV
This Standard includes cable cleats that rely on a mounting surface specified by the manufacturer for axial and lateral retention of cables.
1.3DV
This Standard does not apply to cablebus (which are covered in CSA C22.2 No. 273).
1.4DV
This Standard does not apply to metallic or nonmetallic cable ties (which are covered in CSA C22.2 No. 62275).
1.5DV
This Standard does not apply to devices without a short-circuit current rating such as wire or cable management clamps, clips, hangers, mounts, positioning devices, staples, straps, or similar devices (which are covered in CSA C22.2 No. 18.4 and CSA C22.2 No. 18.5).
1.6DV
Various types of cable cleats and intermediate restraints are shown in Annex A.
Note: Requirements for manufacturers in this Standard also apply to importers and responsible vendors, where appropriate.