ASTM D3329-03(2023)
用气相色谱法测定甲基异丁基酮纯度的标准测试方法

Standard Test Method for Purity of Methyl Isobutyl Ketone by Gas Chromatography


标准号
ASTM D3329-03(2023)
发布
2023年
发布单位
美国材料与试验协会
当前最新
ASTM D3329-03(2023)
 
 
适用范围
1.1  This test method covers the determination of the purity of methyl isobutyl ketone (MIBK) by gas chromatography and in addition provides a means for measuring certain impurities such as methyl isobutyl carbinol which are of interest. Impurities such as water and acidity are measured by other appropriate ASTM procedures and the results are used to normalize the chromatographic value. 1.2  The following applies to all specified limits in this standard; for purposes of determining conformance with this standard, an observed value or a calculated value shall be rounded off “to the nearest unit” in the last right-hand digit used in expressing the specification limit, in accordance with the round-off method of Practice E29 . 1.3  The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.4  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5  For specific hazard information and guidance, see the supplier’s Safety Data Sheet for the materials listed in this test method. 1.6  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D3329-03(2023)相似标准


推荐

工信部公示一批仪器及测试方法行业标准

SH/T 1786-2015 工业异戊烯纯度和烃类杂质含量测定 色谱法 本标准规定了色谱法测定工业异戊烯试样纯度和烃类杂质含量。 本标准适用于异戊烯试样中烃类组分含量测定,其最低检测浓度为0.005%(质量分数)。  ...

环氧乙烷EO残留色谱仪性能

环氧乙烷EO残留色谱仪检测范围:溶剂残留:适用于各种食品、药品包装塑料薄膜、纸塑复合膜、烟包等材料溶剂残留分析测试纯度分析:适用于各种包装印刷溶剂纯度分析水分分析:适用于包装印刷行业溶剂水分含量分析氯乙烯单体分析:适用于氯乙烯单体含量分析自动进样:可实现实验过程自动进行,减少人为误差   【环氧乙烷残留量检测—色谱法】1. 试验设备:色谱仪2....

氨苄西林钠检查方法

碱度取本品,加水制成每1ml中含0.1g溶液,室温放置10分钟后,依法测定(通则0631),pH值应为8.0~10.0。溶液澄清度与颜色取本品5份,各0.60g,分别加水5ml溶解后,溶液应澄清无色;如显浑浊,与1号浊度标准液(通则0902第一法)比较,均不得更浓;如显色,与黄绿色5号标准比色液(通则0901第一法)比较,均不得更深。有关物质照高效液相色谱法(通则0512)测定。...

色谱用途知多少

  色谱是分离和分析混合物中挥发性和半挥发性化合物常用分析技术。它也可以用来分离和纯化混合物成分。此外,色谱法可用于测定蒸汽压、溶解热和活度系数。该行业经常使用它来监控过程,以测试污染或确保过程按计划进行。色谱法可以检测血液酒精、药物纯度、食品纯度、精油质量。GC可用于有机或无机分析物,但样品必须是挥发性。理想情况下,样品成分应该具有不同沸点。  ...


ASTM D3329-03(2023) 中可能用到的仪器设备





Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号