CSA/ANSI Z21.23:22 • CSA 6.6-2022由SCC 发布于 2022-02-01。
CSA/ANSI Z21.23:22 • CSA 6.6-2022在国际标准分类中归属于: 17.200.20 温度测量仪器仪表。
CSA/ANSI Z21.23:22 • CSA 6.6-2022 的最新版本是哪一版？
最新版本是 CSA/ANSI Z21.23:22 • CSA 6.6-2022 。
CSA/ANSI Z21.23:22 • CSA 6.6-2022 由 ANSI Z21.23-2010 燃气器具恒温器 变更而来。
1 Scope 1.1 This Standard applies to newly produced gas appliance thermostats of the integral gas valve type having a maximum operating gas pressure of 1/2 psi (3.5 kPa) or electric type (see Clause 3), constructed entirely of new, unused parts and materials. This Standard does not apply to an electric type comfort heating thermostat (wallmounted) for installation remote from an appliance. When the operating performance characteristics of the thermostat can be affected by the separate components, such as power supply, transformer, and valve(s), the thermostat is to be tested as part of a complete system. Compliance of a device with this Standard does not imply that such device is acceptable for use on gas appliances without supplemental tests with the device applied to the particular appliance design. 1.2 An accessory incorporated as an integral part of a thermostat is to comply with all provisions of the applicable standard for such a device. 1.3 All references to psi throughout this Standard are considered gauge pressures, unless otherwise specified. 1.4 In this Standard, “shall” is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the Standard; “should” is used to express a recommendation or that which is advised but not required; and “may” is used to express an option or that which is permissible within the limits of the Standard. Notes accompanying clauses do not include requirements or alternative requirements; the purpose of a note accompanying a clause is to separate from the text explanatory or informative material. Notes to tables and figures are considered part of the table or figure and may be written as requirements. Annexes are designated normative (mandatory) or informative (non-mandatory) to define their application. 1.5 The values given in imperial units are the units of record for the purposes of this Standard. The values given in parentheses are for information and comparison only. Note: See Annex B.
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证：京ICP证110310号