60664-1980
Coordination De L?Isolement Dans Les Systemes (Reseaux) A Basse Tension Y Compris Les Distances D?Isolement Dans L?Air Et Les Lignes De Fuite Des Materiels (Edition 1.0; See IEC 60664-1)

Insulation Co-ordination within Low-Voltage Systems including Clearances and Creepage Distances for Equipment (Edition 1.0; See IEC 60664-1)


60664-1980 发布历史

This report deals with the Co-ordination of insulation in low-voltage installations including clearances and creepage distances for equipment@ bearing a rated voltage up to 1 200 V d.c. or up to 1 000 V a.c. with rated frequencies up to 30 kHz and for use up to 2 000 m above sea level. The minimum clearances indicated in this report do not apply where ionized gases (e.g. flames or arcs) occur. Special requirements for such situations may be specified at the discretion of the relevant Technical Committee. This report does not deal explicitly with distances through solid or liquid insulation@ with gases other than air or with compressed gases. However@ it is recommended that any solid insulation be so dimensioned that a clearance will flash over at a value of voltage so low that no damage will be done to the solid insulation. Notes1. -The rated voltages 1 000 V a.c. and 1 200 V d.c. are traditional IEC limits for low-voltage equipment and only represent the formal limitation of the scope. Higher voltages may exist in circuits internal to the equipment.* 2. -The altitude of 2 000 in above sea level is tlie traditional highest altitude for low-voltage cquipment covered by IEC standards. Requircincnts for altitudes exceeding 2 000 m can be derived from Appendix A. * Attention is however drawn to the fact that Technical Committee No. 64@ Sub-committee 17R and Sub-Committee 17D consider 1 500 V d.c. as the upper limit of the low-voltage range.

60664-1980由IEC - International Electrotechnical Commission 发布于 1980-01-01,并于 2003-06-04 实施。

60664-1980的历代版本如下:

  • 2002年11月01日 60664-1 CORR 1-2002 Coordination de l’isolement des matériels dans les systèmes (réseaux) à basse tension – Partie 1: Principes@ prescriptions et essais CORRIGENDUM 1 (Edition 1.2)
  • 1992年10月01日 60664-1-1992 Coordination De L?Isolement Des Materiels Dans Les Systemes (Reseaux) A Basse Tension - Partie 1: Principes@ Prescriptions Et Essais (Edition 1.0; Amemdment 1: 02/2000)
  • 2000年04月01日 60664-1-2000 Coordination De L?Isolement Des Materiels Dans Les Systemes (Reseaux) A Basse Tension - Partie 1: Principes@ Prescriptions Et Essais (Edition 1.1; Edition 1: 1992 Consolidated with Amendment 1: 2000; Amendment 2: 05/2002)
  • 2002年06月01日 60664-1-2002 Coordination de l'isolement des matériels dans les systèmes (réseaux) à basse tension – Partie 1: Principes@ prescriptions et essais (Edition 1.2; Edition 1: 1992 Consolidated with Amendments 1: 2000 and 2: 2002)
  • 1980年01月01日 60664-1980 Coordination De L?Isolement Dans Les Systemes (Reseaux) A Basse Tension Y Compris Les Distances D?Isolement Dans L?Air Et Les Lignes De Fuite Des Materiels (Edition 1.0; See IEC 60664-1)
  • 2016年11月01日 60664-3 (REDLINE + STANDARD)-2016
  • 2010年05月01日 60664-3 AMD 1-2010 AMENDEMENT 1 Coordination de l'isolement des matériels dans les systèmes (réseaux) à basse tension – Partie 3: Utilisation de revêtement@ d'empotage ou de moulage pour la protection contre la pollution (Edition 2.0)
  • 2010年11月01日 60664-3 CORR 1-2010 Coordination de l'isolement des matériels dans les systèmes (réseaux) à basse tension – Partie 3: Utilisation de revêtement@ d'empotage ou de moulage pour la protection contre la pollution CORRIGENDUM 1 (Edition 2.1)
  • 1992年01月01日 60664-3-1992 Coordination de l’isolement des matériels dans les systèmes (réseaux) à basse tension Partie 3: Utilisation de revêtements pour réaliser la coordination de l’isolement des cartes imprimées équipées (Edition 1.0)
  • 2003年02月01日 60664-3-2003 Coordination de l?isolement des matériels dans les systèmes (réseaux) à basse tension Partie 3: Utilisation de revêtement@ d?empotage ou de moulage pour la protection contre la pollution (Edition 2.0)
  • 2010年08月01日 60664-3-2010 Insulation coordination for equipment within low-voltage systems – Part 3: Use of coating@ potting or moulding for protection against pollution (Edition 2.1 Consolidated Reprint)
  • 1997年09月01日 60664-4-1997 Insulation Coordination for Equipment within Low-Voltage Systems - Part 4: Considerations of High-Frequency Voltage Stress (Edition 1.0)
  • 2003年08月01日 60664-5-2003 Coordination de l?isolement des matériels dans les systèmes (réseaux) à basse tension Partie 5: Méthode détaillée de détermination des distances d?isolement dans l?air et des lignes de fuite inférieures ou égales à 2 mm (Edition 1.0)
  • 2007年07月01日 60664-5-2007 Coordination de l'isolement des matériels dans les systèmes (réseaux) à basse tension – Partie 5: Méthode détaillée de détermination des distances d’isolement dans l’air et des lignes de fuite inférieures ou égales à 2 mm (Edition 2.0)

 

 

非常抱歉,我们暂时无法提供预览,您可以试试: 免费下载 60664-1980 前三页,或者稍后再访问。

点击下载后,生成下载文件时间比较长,请耐心等待......

 



标准号
60664-1980
发布日期
1980年01月01日
实施日期
2003年06月04日
废止日期
中国标准分类号
/
国际标准分类号
/
发布单位
IEC - International Electrotechnical Commission
引用标准
56
适用范围
This report deals with the Co-ordination of insulation in low-voltage installations including clearances and creepage distances for equipment@ bearing a rated voltage up to 1 200 V d.c. or up to 1 000 V a.c. with rated frequencies up to 30 kHz and for use up to 2 000 m above sea level. The minimum clearances indicated in this report do not apply where ionized gases (e.g. flames or arcs) occur. Special requirements for such situations may be specified at the discretion of the relevant Technical Committee. This report does not deal explicitly with distances through solid or liquid insulation@ with gases other than air or with compressed gases. However@ it is recommended that any solid insulation be so dimensioned that a clearance will flash over at a value of voltage so low that no damage will be done to the solid insulation. Notes1. -The rated voltages 1 000 V a.c. and 1 200 V d.c. are traditional IEC limits for low-voltage equipment and only represent the formal limitation of the scope. Higher voltages may exist in circuits internal to the equipment.* 2. -The altitude of 2 000 in above sea level is tlie traditional highest altitude for low-voltage cquipment covered by IEC standards. Requircincnts for altitudes exceeding 2 000 m can be derived from Appendix A. * Attention is however drawn to the fact that Technical Committee No. 64@ Sub-committee 17R and Sub-Committee 17D consider 1 500 V d.c. as the upper limit of the low-voltage range.




Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号