ASTM A194/A194M-23
用于高压或高温或两者的螺栓的碳钢、合金钢和不锈钢螺母的标准规范

Standard Specification for Carbon Steel, Alloy Steel, and Stainless Steel Nuts for Bolts for High Pressure or High Temperature Service, or Both

被代替

标准号

ASTM A194/A194M-23

发布

2023年

发布单位

美国材料与试验协会

替代标准

ASTM A194/A194M-24

当前最新

ASTM A194/A194M-24

 

 

引用标准

ASTM A153/A153M ASTM A276/A276M ASTM A320/A320M ASTM A370 ASTM A962/A962M ASTM B633 ASTM B695 ASTM B696 ASTM B766 ASTM E112 ASTM E566 ASTM F1941/F1941M ASTM F2329/F2329M ASTM F606/F606M

适用范围

1.1 This specification2 covers a variety of carbon, alloy, and martensitic stainless steel nuts in the size range 1⁄4 through 4 in. and metric M12 through M100 nominal. It also covers austenitic stainless steel nuts in the size range 1⁄4 in. and M12 nominal and above. These nuts are intended for high-pressure or high-temperature service, or both. Grade substitutions without the purchaser’s permission are not allowed. 1.2 Bars from which the nuts are made shall be hot-wrought. The material may be further processed by centerless grinding or by cold drawing. Austenitic stainless steel may be solution annealed or annealed and strain-hardened. When annealed and strain hardened austenitic stainless steel is ordered in accordance with Supplementary Requirement S1, the purchaser should take special care to ensure that 8.2.2, Supplementary Requirement S1, and Appendix X1 are thoroughly understood. 1.3 Supplementary requirements of an optional nature are provided. These shall apply only when specified in the inquiry, contract, and order. 1.4 This specification is expressed in both inch-pound units and in SI units. However, unless the order specifies the applicable “M” specification designation (SI units), the material shall be furnished to inch-pound units. 1.5 The values stated in either inch-pound units or SI units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. Within the text, the SI units are shown in brackets. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM A194/A194M-23相似标准

推荐

谁引用了ASTM A194/A194M-23 更多引用