SAE J2983-2019
SAE J 2983-2012

Recommended Practice for Determining Material Properties of Li-Battery Separator

SAE J2983-2019 发布历史

This SAE RP provides a set of test methods and practices for the characterization of the properties of Li-battery separator. The test methods in this RP have been grouped into one of three categories: 1. Manufacturing parameters: Minimum set of separator properties to be measured 2. Chemistry/Customer specific parameters: Properties that are dependent on the application@ customer needs and/or requirements@ manufacturing process etc. This RP will include the current best practice methodologies for these tests@ with an understanding that the best practice methodologies are evolving as more information is learned. 3. RD parameters: Properties that are dependent on the application@ customer needs and/or requirements@ manufacturing process etc. The methodologies in this 3rd section are under development and have not yet achieved broad application. It is not within the scope of this document to establish criteria for the test results@ as this is usually established between the vendor and customer.

SAE J2983-2019由SAE - SAE International 发布于 2019-01-01，并于 2019-01-01 实施。

SAE J2983-2019的历代版本如下：

• 2012年12月03日 SAE J2983-2012 确定锂电池隔板材料性能的推荐性实施规程
• 2019年01月01日 SAE J2983-2019 SAE J 2983-2012

标准号

SAE J2983-2019

发布日期

2019年01月01日

实施日期

2019年01月01日

废止日期

无

中国标准分类号

/

国际标准分类号

/

发布单位

SAE - SAE International

适用范围

This SAE RP provides a set of test methods and practices for the characterization of the properties of Li-battery separator. The test methods in this RP have been grouped into one of three categories: 1. Manufacturing parameters: Minimum set of separator properties to be measured 2. Chemistry/Customer specific parameters: Properties that are dependent on the application@ customer needs and/or requirements@ manufacturing process etc. This RP will include the current best practice methodologies for these tests@ with an understanding that the best practice methodologies are evolving as more information is learned. 3. RD parameters: Properties that are dependent on the application@ customer needs and/or requirements@ manufacturing process etc. The methodologies in this 3rd section are under development and have not yet achieved broad application. It is not within the scope of this document to establish criteria for the test results@ as this is usually established between the vendor and customer.