FprEN IEC 60947-4-1:2023由欧洲电工标准化委员会 IX-CENELEC 发布于 -,并于 - 实施,于 - 废止。
FprEN IEC 60947-4-1:2023在国际标准分类中归属于: 29.120.99 其他电工器件。
FprEN IEC 60947-4-1:2023 低压开关设备和控制设备 第4-1部分:接触器和电机启动器 机电接触器和电机启动器的最新版本是哪一版?
最新版本是 FprEN IEC 60947-4-1:2023 。
IEC 60947-4-1:2023 is applicable to the following equipment: - electromechanical contactors and starters including motor protective switching devices (MPSD and IMPSD); - actuators of contactor relays; - contacts dedicated exclusively to the coil circuit of the contactor or the contactor relay; - dedicated accessories (e.g. dedicated wiring, dedicated latch accessory); intended to be connected to distribution circuits, motors circuits and other load circuits, the rated voltage of which does not exceed 1 000 V AC or 1 500 V DC. This fifth edition cancels and replaces the fourth edition published in 2018. This edition constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition: a) objective in the scope; b) instantaneous only motor protective switching device IMPSD (3.5.33); c) kinds of equipment (5.2.1); d) methods of overload protection of motors (5.2.6); e) adoption of the AC-7d from IEC 61095:2023 (in 5.4.2); f) separately mounted overload relay of a starter (in 5.7.3 b)); g) starter and contactor suitable for use downstream to basic drive module (6.1.2 w)); h) reference to IEC TS 63058 for environmental aspects (in 6.4); i) wiring subject to movement (in 8.1.3); j) use of voltage transient limiting device (8.1.18); k) accessible parts subject to temperature limits (in 8.2.2.3); l) reference to Annex X of IEC 60947-1:2020 for the co-ordination of MPSD with SCPD (8.2.5.4); m) reference to IEC TR 63216 with different EMC environments (8.3.1); n) reference to IEC TR 63201 for the embedded software design (8.4); o) reference to IEC TS 63208 for cybersecurity aspects (8.5); p) update and completion of the measurement method of the power consumption of the electromagnet (9.3.3.2.1.2); q) update of Annex C including rational about AC-3e; r) determination of the critical load current for photovoltaic applications (M.8.7).
公告指出,随着GB 14048.4-2010《低压开关设备和控制设备 第4-1部分:接触器和电动机起动器 机电式接触器和电动机起动器(含电动机保护器)》、GB4706.17-2010《家用和类似用途电器的安全 电动机-压缩机的特殊要求》标准(以下简称新版标准)的发布实施,相关指定认证机构应采用新版标准实施认证并出具新版标准认证证书;已按对应旧版标准获得强制性认证的产品,旧版标准认证证书持有人需要在公告规定的时间内向指定认证机构提交转换新版标准认证证书的申请并完成证书转换工作...
; GB/T 24975.4-2010 低压电器环境设计导则 第4部分:接触器; GB/T 30215-2013 飞机电磁继电器和接触器通用要求; AS 60470-2001 高压交流电流接触器和基于电流接触器的发动机启发器; AS/NZS 3947.4.3-2000 低压开关设备和控制器 第4.3部分:接触器和电动机起动器。 ...
产品体积小,结构紧凑,安装方便,在低压控制终端柜和1/4模数及以上各种抽屉柜中可直接安装使用,提高了控制回路的可靠性和自动化水平。 ARD3采用模块化的产品结构形式,包括主体控制模块、互感器模块和显示模块,并可根据需要选配ARD3的其他功能模块或附件,与接触器、电动机起动器等电器元件构成电动机控制保护单元,有远程自动控制、现场直接控制、面板指示、信号报警、现场总线通信等功能。...
用电设备指消耗电能的用电器具或电气设备,看图首先要看清楚有几个用电器,它们的类别、用途、接线方式及一些不同要求等。 第二步:要弄清楚用电设备是用什么电器元件控制的。控制电气设备的方法很多,有的直接用开关控制,有的用各种启动器控制,有的用接触器控制。 第三步:了解主电路中所用的控制电器及保护电器。前者是指除常规接触器以外的其他控制元件,如电源开关(转换开关及空气断路器)、万能转换开关。...
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号