ISO 10360-5-2020
ISO 10360-5-2020
ISO 10360-5-2020 发布历史
ISO 10360-5-2020由/ 发布于 0000-00-00，并于 0000-00-00 实施。
。
ISO 10360-5-2020 发布之时，引用了标准
- ISO 10360-1 产品几何量技术规范(GPS).坐标式测量设备(CMM)的验收和再鉴定试验.第1部分:词汇.技术勘误1*， 2002-11-01 更新
- ISO 10360-2 产品几何技术规范(GPS).坐标测量机(CMMs)的验收和复检.第2部分:用于测量线性尺寸规格的CMMs*， 2009-12-01 更新
- ISO 14253-1 产品几何量技术规范(GPS).工件的测量检验和测量设备.第1部分:按规范检验一致性或不一致性的判定规则*， 2017-10-01 更新
- ISO/IEC Guide 99:2007 计量学的国际词汇.基本与一般概念与相关术语(VIM)*， 2007-01-01 更新
* 在 ISO 10360-5-2020 发布之后有更新，请注意新发布标准的变化。
This document specifies acceptance and periodic reverification tests of CMM performance with contacting probing systems and is only applicable to CMMs using: — any type of contacting probing system; and — spherical or hemispherical stylus tip(s). NOTE CMM probing performance tests are specified by the maximum permissible errors (MPEs), due to the impracticality of isolating the performance of the probing system from that of the CMM, even on a small artefact such as a test sphere. This document applies to CMMs supplied with any of the following: a) single-stylus probing systems; b) multi-stylus probing systems with fixed multiple styli attached to a single probe (e.g. “star” stylus); c) multiple probing systems such as those with a stylus for each of their probes; d) systems with articulating probing systems; e) stylus and probe changing systems; f) manual (non-driven) and automated CMMs; g) installations including a scanning probe, capable of being used in a scanning mode. This document is not applicable to non-contacting probing systems, which require different testing procedures. The term ‘combined CMM and multi-stylus probing system size error’ has been shortened to ‘multi- stylus size error’ for convenience. This applies in similar cases. If it is desirable to isolate the probing system performance as far as is practical, the influence of the CMM can be minimized but not eliminated. See Annex C for more information.
