GSO ISO 5414-2:2015由GSO 发布于 2015-09-03。
GSO ISO 5414-2:2015在国际标准分类中归属于: 25.060.20 分度和刀具/工件夹持装置。
GSO ISO 5414-2:2015 带夹紧螺钉的立铣刀夹头(立铣刀刀柄) 用于带扁平圆柱柄的刀具 第2部分:夹头连接尺寸和分类的最新版本是哪一版?
最新版本是 GSO ISO 5414-2:2015 。
This part of ISO 5414 specifies the dimensions of tool chucks (end mill holders) with clamp screws for tools with flatted cylindrical shanks in accordance with ISO 3338-2. It also specifies the designations of these chucks. Two types of connection are defined: — chucks with 7/24 taper shanks in accordance with ISO 297 for manual changers and with ISO 7388-1 for automatic changers, for tool shanks with either single flat or a double flat for manual and automatic changers; NOTE 1 This part of ISO 5414 specifies the dimensions of tool chucks with 7/24 taper shanks No. 30 for automatic changers although these are not standardized. — chucks with Morse taper shanks in accordance with ISO 296 and ISO 5413 for tool shanks with a single flat only. NOTE 2 The dimensions of the driving system of the tool shanks are dealt with in ISO 5414-1.
工件在线测量;……(完成测头开启、主轴定向、激活工件坐标系和刀具长度补偿编程)G65P9810X0Y0Z10F1000(保护定位)G65P9814D49.999(偏心标定)#601=#138(保存测量尺寸结果,并在计算机MES系统关联界面查看#601数据)……(完成抬起、关闭测头动作编程)这一届智能制造大赛对于选手在工件测头使用时的细节要求较多,考察选手的对测头硬件实用性应用掌握程度,大到测量结果通过网络和软件连接计算机显示...
2、主轴强力切削时停转问题主轴电动机与主轴连接的传动带松动会造成主轴传动转矩变小,强力切削时主轴转矩不足,产生报警,数控机床自动停机,这个问题可以通过重新调整主轴传动带的张紧力来解决。当主轴电动机与主轴连接的传动带表面有油时会造成主轴传动带打滑,强力切削时主轴转矩不足,产生报警,此时可以通过用汽油或酒精清洗后擦干净加以排除。...
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号