GSO ASTM D5580:2023由GSO 发布于 2023-09-10。
GSO ASTM D5580:2023在国际标准分类中归属于: 75.160.20 液体燃料。
GSO ASTM D5580:2023 用气相色谱法测定成品汽油中苯、甲苯、乙苯、对二甲苯、邻二甲苯、C9 和重芳烃以及总芳烃的标准试验方法的最新版本是哪一版?
最新版本是 GSO ASTM D5580:2023 。
1.1 This test method covers the determination of benzene, toluene, ethylbenzene, the xylenes, C9 and heavier aromatics, and total aromatics in finished motor gasoline by gas chromatography. 1.2 The aromatic hydrocarbons are separated without interferences from other hydrocarbons in finished gasoline. Nonaromatic hydrocarbons having a boiling point greater than n-dodecane may cause interferences with the determination of the C9 and heavier aromatics. For the C8 aromatics, p-xylene and m-xylene co-elute while ethylbenzene and o-xylene are separated. The C9 and heavier aromatics are determined as a single group. 1.3 This test method covers the following concentration ranges, in liquid volume %, for the preceding aromatics: benzene, 0.1 % to 5 %; toluene, 1 % to 15 %; individual C8 aromatics, 0.5 % to 10 %; total C9 and heavier aromatics, 5 % to 30 %, and total aromatics, 10 % to 80 %. 1.4 Results are reported to the nearest 0.01 % by either mass or by liquid volume. 1.5 This test method includes a relative bias section for U.S. EPA spark-ignition engine fuel regulations reporting for benzene based on Practice D6708 accuracy assessment between Test Method D5580 and Test Method D3606 as a possible Test Method D5580 alternative to Test Method D3606. The Practice D6708 derived correlation equation is only applicable for fuels in the benzene concentration range from 0.0 % to 2.31 % by volume as measured by Test Method D5580. The applicable Test Method D3606 range for benzene is from 0.0 % to 2.38 % by volume as reported by Test Method D3606. 1.6 This test method includes a relative bias section for U.S. EPA spark-ignition engine fuel regulations for total aromatics reporting based on Practice D6708 accuracy assessment between Test Method D5580 and Test Method D5769 as a possible Test Method D5580 alternative to Test Method D5769. The Practice D6708 derived correlation equation(s) is only applicable for fuels in the total aromatic concentration range from 5.4 % to 31.6 % by volume as measured by Test Method D5580 and a distillation temperature T95, at which 95 % of the sample has evaporated, as measured by Test Method D86 is in the range of 149.1 °C to 196.6 °C (300.4 °F to 385.9 °F). 1.6.1 The applicable Test Method D5769 range for total aromatics is from 3.7 % to 29.4 % by volume as reported by Test Method D5769 and the distillation temperature T95, at which 95 % of the sample has evaporated, when tested according to Test Method D86 ranged from 149.1 °C to 196.6 °C (300.4 °F to 385.9 °F). 1.7 This test method includes a relative bias section for spark-ignition engine fuels (gasolines) for benzene reporting based on Practice D6708 accuracy assessment between Test Method D5580 and Test Method D5769 as a possible Test Method D5580 alternative to Test Method D5769. The Practice D6708 derived correlation equation for benzene is applicable in the test method inclusive valid reporting concentration ranges, as determined from Practice D6708 data set and precision working limits of Test Method D5580, from 0.08 % to 2.34 % by volume as measured by Test Method D5580. 1.8 Many of the common alcohols and ethers that are added to gasoline to reduce carbon monoxide emissions and increase octane, do not interfere with the analysis. Ethers such as methyl tert-butylether (MTBE), ethyl tert-butylether (ETBE), tert-amylmethylether (TAME), and diisopropylether (DIPE) have been found to elute from the precolumn with the nonaromatic hydrocarbons to vent. Other oxygenates, including methanol and ethanol elute before benzene and the aromatic hydrocarbons. 1-Methylcyclopentene has also been found to elute from the precolumn to vent and does not interfere with benzene. 1.9 The values stated in SI units are to be regarded as standard. 1.9.1 Exception—The values given in parentheses are for information only. 1.10 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.11 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
GC-2060成品汽油中芳烃(醇类及醚类)分析 专用气相色谱仪技术方案 ★适用范围 适用于则定成品车用汽油中苯、甲苯、乙苯、二甲苯、C9以上重芳烃和总芳烃的含量。成品汽油中芳烃的分离不受非芳烃的干扰。沸点大于正十二烷的非芳烃会干扰C9以上重芳烃的测定。对于C8芳烃,对二甲苯和间二甲苯同时流出,而乙苯和邻二甲苯作为单峰检测。C9以上重芳烃作为一组峰检测。...
前言根据ASTM D5580标准测试方法,赛里安气相为汽油成品中芳烃的测定提供了解决方案。ASTM D5580介绍了用该法测定成品车用汽油中苯、甲苯、乙苯、二甲苯、C9和重芳烃及总芳烃的方法。在汽油中添加芳烃和醚,以减少一氧化碳排放,提高辛烷值。然而,芳烃对健康和环境都是有害的。汽油中苯和芳烃含量的测定对于评估产品质量和满足新的燃料法规是必要的。...
ASTM D5580 用气相色谱法测定成品汽油中苯、甲苯、乙苯、p/m二甲苯、o二甲苯、C9和重芳烃以及总芳烃的标准试验方法ASTM D3606 气相色谱法测定火花点火燃料中苯和甲苯的标准试验方法ASTM D5769 用气相色谱/质谱法测定成品汽油中苯、甲苯和总芳烃的标准试验方法ASTM D6839 多维气相色谱法测定火花点火发动机燃料中碳氢化合物类型、含氧化合物、苯和甲苯的标准试验方法 ASTM...
山东联众分析仪器有限公司,推出的一款专用色谱分析系统--GC-L6型汽油分析专用色谱仪器,该系统完成汽油中醇类、醚类等含氧化合物及苯的分析,其流程设计完全满足SH/T0663《汽油中某些醇类和醚类含氧化合物的测定》、SH/T0693《汽油中芳烃的测定》、GB17930-2006《车用汽油》、GB 18351-2004《车用乙醇汽油》中的规定。...
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号