This British Standard specifies the dimensions
required for correct mating of "contact" type
couplings for connecting the pneumatic braking
system of towing vehicles to trailers or semi-trailers.
If not specifically dimensioned, the couplings may
follow a form to suit the manufacturer. This British
Standard also specifies performance requirements for
the couplings, identity markings, serviceability,
inspections, and maintenance.
The layout and position of the couplings on the
vehicle are defined in BS AU 195a: 1991 and are not
incorporated in this revised British Standard.
Rubber hose assemblies are specified in
BS AU 110a: 1995 and are not incorporated in this
revised British Standard.
Coiled pipe assemblies are specified in
ISO 7375-1:1996, ISO 7375-2:1998, ISO 7628-1:1998,
and ISO 7628-2:1998, and are not incorporated in this
revised British Standard.
This British Standard applies to two-line pneumatic
braking systems and to three line pneumatic braking
systems that include a secondary line.
This British Standard specifies C type and CA type
"contact" couplings. C type couplings are used in two
line braking systems, and the CA type exclusively for
the secondary line of a three line braking system.
Each of the assemblies specified in this British
Standard are intentionally physically
non-interchangeable. It is further intended that each
of the assemblies cannot be dismantled or repaired.
This British Standard specifies the following:
a) the form and dimensions of the mating parts of the C type "contact" coupling and for the self-sealing valve and valve lifter to be incorporated in the coupling, to enable it to be used on the control or on the supply line of a two-line or three-line pneumatic braking system;
b) the form and dimensions of the mating parts of the CA type "contact" coupling and for the self-sealing valve incorporated into the female coupling, to enable it to be used on the secondary line of a three-line pneumatic braking system.