SAE AMS 2759C-2000
钢部件热处理的一般要求
Heat Treatment of Steel Parts General Requirements
SAE AMS 2759C-2000 发布历史
This specification establishes general requirements for the processes listed in 3.3.1 for heat treatment of steel parts (See 8.2.1) by users or their vendors or subcontractors. Reference to AMS 2759 on a drawing, fabrication order, purchase order, etc constitutes a requirement to conform to the applicable provisions of the documents listed in 3.3.1 for the hear treatment of steel parts of the particular alloy described. Parts made from steels orther than those specified in the detail specifications may be heat treated in accordance with the applicable requirements using processing temperatures, times, and other parameters recommended by the material producer unless otherwise specified by purchaser. The conditions (temperatures, soaking times, cooling rates, etc) used by material producers, forge shops, and foundries for qualification of response to heat treatment of their products shall conform to the requirements of the specifications listed in 3.3.1. Heat treatment of raw material by raw material producers, forge shops, or foundries should be in accordance with the material procurement specification. Processes such as vacuum-furnace heat treating, flame hardening, induction through-hardening, austempering, martempering, and hot oil quenching are recognized heat treating processes, but their requirements are not completely covered by this specification.
SAE AMS 2759C-2000由美国机动车工程师协会 US-SAE 发布于 2000-06-01。
SAE AMS 2759C-2000 在中国标准分类中归属于: J36 热处理，在国际标准分类中归属于: 49.025.10 钢。
SAE AMS 2759C-2000的历代版本如下：
- 2000年06月01日 SAE AMS 2759C-2000 钢部件热处理的一般要求
SAE AMS 2759C-2000 钢部件热处理的一般要求 于 2006-02-01 变更为 SAE AMS 2759D-2006 钢零件热处理一般要求。
- 标准号
- SAE AMS 2759C-2000
- 发布日期
- 2000年06月01日
- 实施日期
- 废止日期
- 无
- 中国标准分类号
- J36
- 国际标准分类号
- 49.025.10
- 发布单位
- US-SAE
- 代替标准
- SAE AMS 2759D-2006
- 适用范围
- This specification establishes general requirements for the processes listed in 3.3.1 for heat treatment of steel parts (See 8.2.1) by users or their vendors or subcontractors. Reference to AMS 2759 on a drawing, fabrication order, purchase order, etc constitutes a requirement to conform to the applicable provisions of the documents listed in 3.3.1 for the hear treatment of steel parts of the particular alloy described. Parts made from steels orther than those specified in the detail specifications may be heat treated in accordance with the applicable requirements using processing temperatures, times, and other parameters recommended by the material producer unless otherwise specified by purchaser. The conditions (temperatures, soaking times, cooling rates, etc) used by material producers, forge shops, and foundries for qualification of response to heat treatment of their products shall conform to the requirements of the specifications listed in 3.3.1. Heat treatment of raw material by raw material producers, forge shops, or foundries should be in accordance with the material procurement specification. Processes such as vacuum-furnace heat treating, flame hardening, induction through-hardening, austempering, martempering, and hot oil quenching are recognized heat treating processes, but their requirements are not completely covered by this specification.