IEC 61204:2001
直流输出低压供电装置.性能特性

Low-voltage power supply devices, d.c. output - Performance characteristics


IEC 61204:2001 发布历史

IEC 61204:2001由国际电工委员会 IX-IEC 发布于 2001-05。

IEC 61204:2001 在中国标准分类中归属于: K81 交直流电源装置,在国际标准分类中归属于: 29.200 整流器、转换器、稳压电源。

本标准有修改采用的 中文版 GB/T 17478-2004 低压直流电源设备的性能特性

IEC 61204:2001的历代版本如下:

 

This international Standard describes a method for specifying requirements for low-voltage power supply devices (including switching types) providing d.c. output(s) up to 200 V d.c. at a power level of up to 30 kW, operating from a.c. or d.c. source voltages of up to 600 V. The devices are for use within class I equipment or for free-standing operation when used with adequate electrical and mechanical protection. This standard is intended to be used for all types of a.c. or d.c. driver power supplies with any number of outputs, specially produced for an unknown final application. In the case where power supplies are developed as a component of equipment covered by specific product standards, these standards apply; the additional application of IEC 61204 may be useful as an option, especially if the performance characteristics are not sufficiently covered by the product standard. It permits to specify a power unit to meet a particular application by the specification of parameters at required performance levels, to establish the essential definitions related to this type of equipment, and to establish a selection of levels of performance. These levels are carefully graded to enable manufacturers and users to select and specify a range of power supply devices suitable for their application.

IEC 61204:2001

标准号
IEC 61204:2001
发布
2001年
中文版
GB/T 17478-2004 (修改采用的中文版本)
发布单位
国际电工委员会
替代标准
IEC 61204:1993/AMD1:2001
当前最新
IEC 61204:1993/AMD1:2001
 
 

IEC 61204:2001相似标准


推荐

40个电气问答汇总,电气工程师应该掌握

(1)当输入直流信号Ui=0时,输出信号U0=0 (2)输出交流信号的幅值,应比例于直流信号的大小,(3)当直流信号Ui的极性改变时,输出交流信号的相位也随之改变。27、35kV中性点不接地电网中,线路相间短路保护配置的原则是什么?相间短路保护配置的原则是:(1)当采用两相式电流保护时,电流互感器应安装在各出现同名两相上(例如A,C相)。(2)保护装置保护装置应采用远后备方式。...

电子科大张晓升教授团队Nano Energy:基于周期性侧向悬臂梁的单向电流摩擦电纳米发电机

虽然TENG有接触分离式、相对滑动式、单电极式、独立式等四种不同的模式,但它们都表现出由电极间感应电荷的流入和流出所产生的交流特性。这种正负交变脉冲的电流波形对于构建自供电的传感器和驱动器是非常有用的,但却无法直接为需要直流电的电子器件供电。为了将这种交流脉冲电转换为直流电,研究人员已经开发出了多种电源管理技术,其中整流电路是实现单向电流转换的根本。...

仪表工程师面试,都问些什么?

答:蝶阀特别适用于低压差、大口径、大流量的气体和浆状液体。049V形球阀有何特点?答:V形球阀又称V形切口球阀,阀芯为1/4球壳,开有V形缺口。其优点是:流通能力大、控制特性好(为等百分比)、可调范围大、具有剪切作用,能严密关闭,适用于浆料、纤维状流体场合。050简述选用气开式和气关式调节阀的原则。答:事故状态下,要考虑工艺装置应尽量处于安全状态,避免事故发生。...

盘点七大现代铁路技术应用的自动化产品

变频器靠内部IGBT的开断来调整输出电源的电压和频率,根据电机的实际需要来提供其所需要的电源电压,进而达到节能、调速的目的,另外,变频器还有很多的保护功能,如过流、过压、过载保护等等。随着工业自动化程度的不断提高,变频器也得到了非常广泛的应用。产品定义电压等级低于690V的可调输出频率交流电机驱动装置,就归类为低压变频器。...





Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号