This practice covers the determination of indentation hardness of metallic materials using comparison hardness testers. This practice applies only to those comparison hardness testers, normally portable, that use standardized test blocks in accordance with Test Method E10 as a basis for comparison. Calibration of comparative test bars (rods), used for comparison to determine hardness numbers, is also covered by this practice. The indenting force used during comparison hardness testing is normally an impact load applied by striking a hammer at the appropriate areas as outlined in the manufacturer's instructions. Final indentation diameter in both the comparative test bar and material tested shall be within the range of the comparator used for the instrument.This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all the safety problems associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ANSI/ASTM A833-1996由美国国家标准学会 US-ANSI 发布于 1996-10。
ANSI/ASTM A833-1996 在中国标准分类中归属于: H10 金属化学分析方法综合,在国际标准分类中归属于: 77.040.10 金属材料机械试验。
非常抱歉,我们暂时无法提供预览,您可以试试: 免费下载 ANSI/ASTM A833-1996 前三页,或者稍后再访问。
点击下载后,生成下载文件时间比较长,请耐心等待......
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号