This International Standard applies to all commercially available optical amplifiers (OA) and optically amplified subsystems. It applies to OA using optically pumped fibres (OFA based on either rare-earth doped fibres or on the Raman effect), semiconductors (SOA), and waveguides (POWA). NOTE The applicability of the test methods described in the present standard to distributed Raman amplifiers is for further study. The object of this standard is to establish uniform requirements for accurate and reliable measurements, by means of the optical power meter test method, of the following OA parameters, as defined in Clause 3 of IEC 61291-1: a) nominal output signal power; b) gain; c) reverse gain; d) maximum gain; e) polarization-dependent gain; f) large-signal output stability; g) saturation output power; h) maximum input signal power; i) maximum output signal power; j) input power range; k) output power range; I) maximum total output power. In addition this test method provides a means for measuring the following parameters: - maximum gain wavelength; gain wavelength band. NOTE All numerical values followed by (t) are suggested values for which the measurement is assured. Other values may be acceptable but should be verified. The object of this standard is specifically directed to single-channel amplifiers. For multichannel amplifiers, one should refer to the IEC 61290-10 series2.
IEC 61290-1-3-2005由国际电工委员会 IX-IEC 发布于 2005-11。
IEC 61290-1-3-2005 在中国标准分类中归属于: L50 光电子器件综合,在国际标准分类中归属于: 33.180.30 光纤放大器。
非常抱歉,我们暂时无法提供预览,您可以试试: 免费下载 IEC 61290-1-3-2005 前三页,或者稍后再访问。
点击下载后,生成下载文件时间比较长,请耐心等待......
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号