BS DD IEC/PAS 62437-2006
道上车辆、船舶和设备上用接收机保护的无线电干扰特性.限值和测量方法.有源天线规范

Radio disturbance characteristics for the protection of receivers used on board vehicles, boats, and on devices - Limits and methods of measurement - Specifications for active antennas

BS DD IEC/PAS 62437-2006 发布历史

Active antennas used on board vehicles are electronic components in the sense of CISPR 25. Therefore, the requirements regarding emissions apply to it in its function as EUT. In addition to this, vehicle active antennas are used as part of the measurement chain for the evaluation of emissions produced by any other component in the vehicle. With a passive antenna no special considerations were necessary because it can neither generate emissions nor harmonics due to its linearity. This Publicly Available Specification (PAS) gives additional information for the use of active antennas for radiated emission measurement according to CISPR 25. Test set-ups at component level are defined for the determination of noise floor. The current vehicle antenna technology provides two categories of active antennas. The first category (I) consists of an active part (electronic part) and a passive part (antenna structure). These parts can be considered as two separate "black boxes". During the emission tests (antenna as EUT), the passive antenna part is normally replaced by an "artificial antenna network". Antennas with their active and passive parts inseparably combined within one housing are defined as category (II) antennas.

BS DD IEC/PAS 62437-2006由英国标准学会 GB-BSI 发布于 2006-01-18，并于 2006-01-18 实施。

BS DD IEC/PAS 62437-2006 在中国标准分类中归属于: M51 天线及其馈线，在国际标准分类中归属于: 33.120.40 天线。

BS DD IEC/PAS 62437-2006的历代版本如下：

• 2006年01月18日 BS DD IEC/PAS 62437-2006 道上车辆、船舶和设备上用接收机保护的无线电干扰特性.限值和测量方法.有源天线规范

非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 BS DD IEC/PAS 62437-2006 前三页，或者稍后再访问。

注意： 点击下载后，生成下载文件时间比较长，请耐心等待......

标准号

BS DD IEC/PAS 62437-2006

发布日期

2006年01月18日

实施日期

2006年01月18日

废止日期

无

中国标准分类号

M51

国际标准分类号

33.120.40

发布单位

GB-BSI

适用范围

Active antennas used on board vehicles are electronic components in the sense of CISPR 25. Therefore, the requirements regarding emissions apply to it in its function as EUT. In addition to this, vehicle active antennas are used as part of the measurement chain for the evaluation of emissions produced by any other component in the vehicle. With a passive antenna no special considerations were necessary because it can neither generate emissions nor harmonics due to its linearity. This Publicly Available Specification (PAS) gives additional information for the use of active antennas for radiated emission measurement according to CISPR 25. Test set-ups at component level are defined for the determination of noise floor. The current vehicle antenna technology provides two categories of active antennas. The first category (I) consists of an active part (electronic part) and a passive part (antenna structure). These parts can be considered as two separate "black boxes". During the emission tests (antenna as EUT), the passive antenna part is normally replaced by an "artificial antenna network". Antennas with their active and passive parts inseparably combined within one housing are defined as category (II) antennas.

BS DD IEC/PAS 62437-2006 中可能用到的仪器设备