SAE AMS 3678-1999

Polytetrafluoroethylene (PTFE) Moldings and Extrusions Unfilled, Pigmented, and Filled Components

SAE AMS 3678-1999 发布历史

This specification covers a polytetrafluoroethylene (PTFE) resin filledwith inorganic pigment in the form of extruded or molded rods or tubes which are sintered after molding or, in the case of extrusions, sintered during the extrusion process. These products have been used typically for parts such as backup rings and seal elements in both static and dynamic applications requiring dimensional stability up to 450 degrees F (232 degrees C) with good mechanical properties, but usage is not limited to such applications. Each application should be considered individually.

SAE AMS 3678-1999由美国机动车工程师协会 US-SAE 发布于 1999-03。

SAE AMS 3678-1999在国际标准分类中归属于: 49.025.40 橡胶和塑料。

SAE AMS 3678-1999的历代版本如下：

• 1999年03月 SAE AMS 3678-1999

标准号

SAE AMS 3678-1999

发布日期

1999年03月

实施日期

废止日期

无

国际标准分类号

49.025.40

发布单位

US-SAE

适用范围

This specification covers a polytetrafluoroethylene (PTFE) resin filledwith inorganic pigment in the form of extruded or molded rods or tubes which are sintered after molding or, in the case of extrusions, sintered during the extrusion process. These products have been used typically for parts such as backup rings and seal elements in both static and dynamic applications requiring dimensional stability up to 450 degrees F (232 degrees C) with good mechanical properties, but usage is not limited to such applications. Each application should be considered individually.

SAE AMS 3678-1999 中可能用到的仪器设备

谁引用了SAE AMS 3678-1999 更多引用