SAE J 2337/3-2002
流体动力和高压的连接,采用带有ISO 261螺纹及O形圈密封的端口,双头螺栓端及塞子 第3部分:端口塞堵要求,尺寸,设计和测试方法
Connections for Fluid Power and High Pressure UsePorts, Stud Ends, and Plugs with ISO 261 Threads and O-Ring SealingPart 3: Port Plug Requirements, Dimensions, Design, and Test Methods
- 标准号
- SAE J 2337/3-2002
- 发布日期
- 2002年01月01日
- 实施日期
- 废止日期
- 无
- 中国标准分类号
- T33
- 国际标准分类号
- 23.040.01
- 发布单位
- US-SAE
- 代替标准
- SAE J 2337/3-2012
- 适用范围
- The purpose of SAE J 2337 specifies dimensions, design, and performance requirements for eight plugs using a conical seal to insure leak proof performance with a design factor of 4 to 1. These connectors are intended for general and hydraulic systems on industrial equipment and commercial products, where elastomeric seals are acceptable to overcome leakage and variations in assembly procedures. These connectors are capable of providing leak proof full flow connections in hydraulic systems operating from 95 kPa vacuum to the working pressures shown in Table 1. Since many factors influence the pressure at which hydraulic systems will or will not perform satisfactorily, these values should not be construed as guaranteed minimums. For any application, it is recommended that sufficient testing be conducted and reviewed by both the user and manufacturer to ensure that the required performance levels are met.