DIN EN 15048-1:2007
非预加载荷结构的螺栓连接组件.第1部分:一般要求

Non-preloaded structural bolting assemblies - Part 1: General requirements; German version EN 15048-1:2007

被代替

标准号

DIN EN 15048-1:2007

发布

2007年

发布单位

德国标准化学会

替代标准

DIN EN 15048-1:2016

当前最新

DIN EN 15048-1:2016

 

 

引用标准

EN 10045-1 EN 10204 EN 15048-2 EN 1993-1-8:2005 EN 20898-2 EN ISO 3506-1 EN ISO 3506-2 EN ISO 6507-1 EN ISO 898-1 EN ISO 9001 prEN 1090-2-2005

被代替标准

DIN EN 15048-1:2004

适用范围

This part of this European Standard specifies the general requirements for the components of bolt/nut/washer assemblies for non-preloaded structural bolting and for the assemblies themselves. It applies to bolts (including screws, studs and stud bolts) and nuts made of carbon steel, alloy steel and stainless steel with the following property classes: - bolts made of carbon steel and alloy steel: 4.6, 4.8, 5.6, 5.8, 6.8, 8.8, 10.9; - nuts made of carbon steel and alloy steel: 4, 5, 6, 8, 10, 12; - bolts made of austenitic stainless steel: 50, 70, 80; - nuts made of austenitic stainless steel: 50, 70, 80; - if appropriate, washers according to hardness class HV 100 or HV 200. NOTE The property classes 4.8, 5.8 and 6.8 may be subjected to limitations of use, it is recommended to refer to prEN 1090-2. The standard applies to thread sizes from M12 to M36 and to the associated washers but does not preclude the use of other sizes. Bolted connections with components according to this European Standard are able to be shear and/or tensile loaded. Bolts, nuts and washers according to this European Standard are not normally intended for welding.

DIN EN 15048-1:2007相似标准

推荐