BS EN 13476-2:2007
无压地下排水和污水塑料管系统.未增塑聚氯乙烯(PVC-U)、聚丙烯(PP)和聚乙烯(PE)结构壁管系统.A型、有平滑内外表面的管和配件及系统用规范

Plastics piping systems for non-pressure underground drainage and sewerage - Structured-wall piping systems of unplasticized poly(vinyl chloride) (PVC-U), polypropylene (PP) and polyethylene (PE) - Specifications for pipes and fittings with smooth interna

被代替

标准号

BS EN 13476-2:2007

发布

2007年

发布单位

英国标准学会

替代标准

BS EN 13476-2:2018

当前最新

BS EN 13476-2:2018+A1:2020

 

 

引用标准

CEN/TS 14541-2007 EN EN 1053 EN 1055:1996 EN 12061 EN 12256 EN 12666-1 EN 1277 EN 13476-1:2007 EN 13476-3 EN 1401-1 EN 1411 EN 1437 EN 1446 EN 14741 EN 14758-1 EN 1852-1 EN 1905 EN 1979 EN 476 EN 580 EN 681-1 EN 681-2 EN 681-4 EN 727 EN 728 EN 744 EN 922

被代替标准

06/30082990 DC-2006

适用范围

This part of EN 13476, together with EN 13476-1, specifies the definitions and requirements for pipes, fittings and the system based on unplasticized poly(vinyl chloride) (PVC-U), polypropylene (PP) and polyethylene (PE) structured-wall piping systems that are intended to be used for non-pressure underground drainage and sewerage systems. This part is applicable to pipes and fittings with smooth internal and external surfaces, designated as Type A. It specifies test methods and test parameters as well as requirements. This part is applicable to: a) structured-wall pipes and fittings, which are intended to be used buried underground outside the building structure; reflected in the marking of products by “U”; b) structured-wall pipes and fittings, which are intended to be used buried underground both outside (application area code “U”) and within the building structure (application area code “D”); reflected in the marking of products by “UD”. This part is applicable to structured-wall pipes and fittings with or without an integral socket with elastomeric ring seal joints as well as welded and fused joints. This part covers a range of pipe and fitting sizes, materials, pipe constructions, stiffness classes, application classes, and tolerance classes and gives recommendations concerning colours. NOTE 1 It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and any relevant national regulations and installation practices or codes. NOTE 2 For dimensions larger than DN 1200 OD/ID this document may be applied regarding appearance, colour, physical and mechanical characteristics as well as performance requirements.

BS EN 13476-2:2007相似标准

推荐