AGMA 90FTM5-1990
抛光磨损
POLISHING WEAR
说明：
- 此图仅显示与当前标准最近的5级引用；
- 鼠标放置在图上可以看到标题编号；
- 此图可以通过鼠标滚轮放大或者缩小；
- 表示标准的节点，可以拖动；
- 绿色表示标准：AGMA 90FTM5-1990 ， 绿色、红色表示本平台存在此标准，您可以下载或者购买，灰色表示平台不存在此标准；
- 箭头终点方向的标准引用了起点方向的标准。
- 标准号
- AGMA 90FTM5-1990
- 发布日期
- 1990年
- 实施日期
- 废止日期
- 无
- 中国标准分类号
- J00
- 发布单位
- US-AGMA
- 引用标准
- ANSI/AGMA 110.04-1980 Dudley, D.W., "Gear Wear", Wear Control Handbook, Ed. M.B. Peterson and _.0. Winer, ASME, New York, 1980, pp. 755-83D.
- 适用范围
- Polishing wear has been known to occur on piston rings, cylinder bores, valve lifters, hydraulic components, rolling-element bearings and gear teeth. The bright, polish surfaces may look good, but polishing wear is detrimental because it is a high wear phenomenon which reduces the geometric accuracy of the components. A case history is presented of a gearbox which suffered extensive polishing wear of the gear teeth and rolling-element bearings. The results of research into the basic mechanism of polishing wear, and laboratory analyses of materials and lubricants are presented. Polishing wear is shown to be due to fine-scale abrasion. It is promoted by a combination of a fine abrasive and a gear oil with chemically-active additives.