1. Dimensions are in inches.
2. Metric equivalents are given for general information only.
3. Terminal numbers do not appear on the relay header. There shall be affixed to the relay a suitable legible circuit
diagram that identifies each terminal location specified. Circuit diagram shown above is the terminal view.
4. In the event of a conflict between the text of this standard and the references cited herein, the text of this standard
shall take precedence.
5. Referenced Government documents of the issue listed in that issue of the Department of Defense Index of
Specifications and Standard (DoDISS) specified in the solicitation form a part of this standard to the extent specified
herein.
6. For details see table I.
7. Unless otherwise specified, tolerance is ± .010 (0.25 mm).
8. Dash numbers D1 and D2 supersede and are completely interchangeable with dash numbers -1 and -2 respectively.