ETSI EN 301 489-1-2008 电磁兼容性和无线频谱事务(ERM).无线电设备和业务的电磁兼容性(EMC)标准.第1部分:共同技术要求(版本1.8.1)
Electromagnetic compatibility and Radio spectrum Matters (ERM); ElectroMagnetic Compatibility (EMC) standard for radio equipment and services; Part 1: Common technical requirements V1.8.1
The present document contains the common requirements for radio communications equipment and associated ancillary
equipment, in respect of ElectroMagnetic Compatibility (EMC). Product dependent arrangements necessary to perform the EMC tests on dedicated types of radio communications
equipment, and the assessment of test results, are detailed in the appropriate product related parts of
EN 301 489 series [11].
The present document, together with the product related part, specifies the applicable EMC tests, the methods of
measurement, the limits and the performance criteria for radio equipment and associated ancillary equipment. In case of differences (for instance concerning special conditions, definitions, abbreviation) between part 1 of the present document and the relevant product related part of EN 301 489 series [11], the product related part takes precedence.
Technical specifications related to the antenna port of radio equipment and radiated emissions from the enclosure port of radio equipment and combinations of radio and associated ancillary equipment are not included in the present document. Such technical specifications are normally found in the relevant product standards for the effective use of the radio spectrum.
The environment classification used in the present document refers to the environment classification used in:
? EN 61000-6-3 [18] and EN 61000-6-1 [19] for the residential, commercial and light industrial environment; or
? TR 101 651 [20] for the telecommunication centre environment; or
? ISO 7637-2 [8] for the vehicular environment.
The EMC requirements have been selected to ensure an adequate level of compatibility for apparatus intended to be
used in the environments mentioned above. The levels, however, do not cover extreme cases which may occur in any
location but with low probability of occurrence. The applicable environment(s) shall be declared by the manufacturer and shall be in accordance with the equipment documentation.
For radio equipment and associated ancillary equipment intended to be installed in motor vehicles (i.e. ESAs) and not related to immunity related functions of the vehicle, additional technical requirements necessary to demonstrate
conformance to the motor vehicle EMC Directive 2004/104/EC [23], are set out in annex B (normative) of the present
document.
The present document may not cover those cases where a potential source of interference which is producing
individually repeated transient phenomena or a continuous phenomenon is permanently present, e.g. a radar or
broadcast site in the near vicinity. In such a case it may be necessary to use special protection applied to either the source of interference or the interfered part or both.
Where none of the existing specific product related radio parts covers the required conditions for a particular radio equipment/service e.g. in case of the initial introduction of a new radio service or a special application, the present document can be used together with specific information for the radio equipment provided by the manufacturer, for the purposes of testing to the EMC requirements set out in the present document.
NOTE: Radio equipment for use in maritime environment is covered by other ETSI EMC standards.