This International Standard applies to lampholders with Edison thread E14, E27 and E40, designed for connection to the supply of lamps and semi-luminaires* only. It also applies to switched-lampholders for use in a.c. circuits only, where the working voltage does not exceed 250 V r.m.s. This standard also applies to lampholders with Edison thread E5 designed for connection to the supply mains of series connected lamps, with a working voltage not exceeding 25 V, to be used indoors, and to lampholders with Edison thread El0 designed for connection to the supply mains of series connected lamps, with a working voltage not exceeding 60 V, to be used indoors or outdoors. It also applies to lampholders El0 for building-in, for the connection of single lamps to the supply. These lampholders are not intended for retail sale. As far as it reasonably applies, this standard also covers lampholders other than lampholders with Edison thread designed for connection of series-connected lamps to the supply. NOTE This type of lampholder is for example used in Christmas tree lighting chains. As far as it reasonably applies, this standard also covers adapters. This standard also covers lampholders which are, wholly or partly, integral with a luminaire or intended to be built into appliances. It covers the requirements for the lampholder only. For all other requirements, such as protection against electric shock in the area of the terminals or of the lamp cap, the requirements of the relevant appliance standard shall be observed and tested after building into the appropriate equipment, when that equipment is tested according to its own standard. Such lampholders as well as lampholders provided with a snap-on outer shell, for use by luminaire manufacturers only, are not for retail sale. This standard applies to lampholders to be used indoors or outdoors in residential as well as in industrial lighting installations. It also applies to candle lampholders. In locations where special conditions prevail, as for street lighting, on board ships, in vehicles and in hazardous locations, e.g. where explosions are liable to occur, special constructions may be required. NOTE 1 This standard does not apply to three-light lampholders E26d. NOTE 2 This standard is based on the following data relative to lamps for general lighting service: - caps E14 are used for lamps with a current not exceeding 2 A; - caps E27 are used for lamps with a current not exceeding 4 A; - caps E40 are used for lamps with a current not exceeding 16 A. NOTE 3 If the nominal voltage of the supply does not exceed 130 V, the maximum current for caps E4O is 32 A (see 4.5 and 5.3). NOTE 4 Where lampholders are used in luminaires, their maximum operating temperatures are specified in IEC 60598.
IEC 60238 Edition 8.1-2008由国际电工委员会 IX-IEC 发布于 2008-08。
IEC 60238 Edition 8.1-2008 在中国标准分类中归属于: K74 灯具附件，在国际标准分类中归属于: 29.140.10 灯头和灯座。
* 在 IEC 60238 Edition 8.1-2008 发布之后有更新，请注意新发布标准的变化。
非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 IEC 60238 Edition 8.1-2008 前三页，或者稍后再访问。
点击下载后，生成下载文件时间比较长，请耐心等待......
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证：京ICP证110310号