SAE J1453/3-2009
O形环密封面连接器规范.第3部分:钢管接头,壁板,转环,钎套,连接器,帽盖和SAE J 1926-2英制螺杆端连接器的尺寸规格,试验和要求

Specification for O-Ring Face Seal Connectors: Part 3 Requirements, Dimensions, and Tests for Steel Unions, Bulkheads, Swivels, Braze Sleeves, Connectors, Caps, and Connectors with SAE J 1926-2 Inch Stud Ends

作废

非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 SAE J1453/3-2009 前三页，或者稍后再访问。

您也可以尝试购买此标准，
点击右侧 “立即购买” 按钮开始采购（由第三方提供）。

标准号

SAE J1453/3-2009

发布

2009年

发布单位

美国机动车工程师协会

替代标准

SAE J1453/3-2012

当前最新

SAE J1453/3-2012

 

 

适用范围

1.1 PurposeThe three parts of SAE J1453 cover material, dimensional, and performance requirements of steel O-ring face seal(ORFS) connectors for tubing and the O-ring face seal interface and nut portion of hose stem assemblies for nominal tubediameters of 6 mm through 38 mm and for nominal hose diameters 6.3 mm through 38 mm. SAE J1453-3 covers therequirements for “inch based” O-ring face seal connectors to inch stud ends along with the associated adapters, bulkheadand union connectors. Inch hex wrenching flats are predominantly used throughout this standard.1.2 Field of ApplicationThese connectors are intended for general application (see Figures 3, 4, and 5) and hydraulic systems on industrialequipment and commercial products, where elastomeric seals are acceptable to overcome leakage and variations inassembly procedures. These connectors are capable of providing leak proof full flow connections in hydraulic systemsoperating from 95 kPa vacuum to working pressures shown in Table 4. Since many factors influence the pressure atwhich a hydraulic system will or will not perform satisfactorily, these values should not be construed as guaranteedminimums. For any application, it is recommended that sufficient testing be conducted and reviewed by both the user andmanufacturer to ensure that required performance levels are met.For use of these connectors in conditions outside the pressure and temperature limits specified, the manufacturers mustbe consulted.Both metric and inch tubing can be accommodated by changing only the sleeve to match the tube diameters. In the past,these connectors have been used predominantly with inch tubing. For new designs metric tubing should be considered.

推荐

SAE J1453/3-2009系列标准

谁引用了SAE J1453/3-2009 更多引用